Mobilo |
Vacuum cleaner |
HR 8505
!Service Information
Philips Domestic Appliances and Personal Care
ServiceManual
PRODUCT INFORMATION |
|
|
|
- |
Maximum air displacement |
: |
32 I/sec |
- Maximum vacuum water column |
: |
240 cm |
|
- Power consumption (IEC) |
: |
1200 W |
|
- |
Dust storage capacity |
: |
3 l |
- |
Cord length (depends on version) |
: |
6 metre |
- |
Filter system |
: |
Paper dustbag |
|
|
: |
Motor inlet filter |
|
|
: |
Exhaust air filter |
- |
Dimensions cleaner |
: |
44.5 x 29.5 x 25 cm |
- |
Weight cleaner |
: |
5.5 kg |
OPTIONAL |
|
|
|
- |
Exhaust air filter |
HR 6932 = 8836 932 01210 |
|
- Hard floor nozzle |
HR 6943 = 8836 943 03010 |
||
- Active carbon filter |
HR 6949 = 8836 949 01010 |
||
- |
Active carbon filter replacem. set |
HR 6968 = item 12 + 13 |
|
- S-class filter |
HR 6992 = 8836 992 01010 |
||
- |
S-class filter replacement set |
HR 6994 = item 19 + 20 |
|
- Sydney cotton dustbag |
HR 6997 = 4322 004 93250 |
||
- Sydney closable pap. dustbag |
HR 6999 = 8836 999 01010 |
||
- Turbo brush |
HR 6988 = 8836 988 01010 |
||
- Sydney 3M-dustbag |
HR 6999 = 8836 999 90010 |
SERVICE INFORMATION
-To open the appliance, first remove the 2 screws of the control panel (item 11) then with a big screw driver disconnect the 2 snap locks of panel and lower housing (see drawing).
-Component configuration on exploded view may differ in case of specific versions. However, the actual components are distinguished bij means of code numbers.
-If a repair has been made, make sure that all functions of the appliance are working correctly.
-The spare parts have been standardized as much as possible.
-Item 6, cotton dustbag, is used in those countries where paper dustbags are not available.
-Item 21 is provided with a long cord-winder spring; both long and short cords can be used in combination with this spring.
-Cordwinder spring has to be tensioned till maximum minus appox. 1,5 revolution.
-Depending on the original length of the cord, the spare cord must be shortened.
-Item 71 up to and including item 85. The assembly of accessories depends on the national version.
To connect the nozzle, the telescopic
tube and the handle: insert the
narrowed section into the wider section
while turning it a little.
To disconnect: pull while rotating.
To adjust the telescopic tube (item 74) to the required length, use the knob in the direction of the arrow while sliding
the top section of the telescopic tube into or out of the lower section.
fig. 1
-To (dis)assemble the appliance use TORX screw driver no T15
=4822 395 10329, which is one of a set consisting of T20, T15, TI0, T9, T8, T7 and T6 = 4822 395 50145.
-Adjusting the PCB on the motor to 220V, 60Hz.
1. Make sure that the potentiometer (item 36) is set at min. position.
2. Adjust the potentiometer on the PCB item 45, on the motor to 220V/60Hz to allow the motor to run smoothly.
Please note : the standard setting of the spare PCB is 230V/50Hz.
There are open-circuit voltages on all wires.
Published by Philips Domestic Appliances and Personal Care |
Printed in the Netherlands |
© Copyright reserved |
Subject to modification |
4322 277 00396 00/11
1 |
4322 003 19290 |
Acc. cover pearl blue |
|
2 |
4322 000 67680 |
Spring |
|
3 |
4322 009 07920 |
Dust cover pearl blue |
|
4 |
4322 001 94690 |
Packing ring |
|
5 |
4322 003 19280 |
Front cover pearl blue |
|
|
|
|
|
6 |
8836 999 01010 |
Sydney closable pap. dustbag |
|
|
8836 999 90010 |
Sydney 3M-dustbag (opt.) |
|
|
4322 004 93250 |
Sydney cotton dustbag (opt.) |
|
7 |
4322 009 06760 |
Dustbag carrier |
|
8 |
4322 003 12280 |
Clamp of dustbag carrier |
|
9 |
4322 003 12020 |
Dust compartment sealing |
|
10 |
4322 005 12870 |
Turn knob pearl blue |
|
11 |
4322 003 19310 |
Back panel pearl blue |
|
12 |
4322 009 07040 |
Inlett grille + trio filter |
|
13 |
4322 000 37300 |
Safety trio filter |
|
|
|
|
|
14 |
4322 003 19320 |
Pedal pearl blue |
|
15 |
4322 001 72780 |
Buffering motor |
|
16 |
4322 003 12080 |
Motor disc |
|
17 |
4322 003 12510 |
Cord outlet |
|
18 |
4322 009 06700 |
Lower housing + wheels |
|
19 |
8836 932 01210 |
Exhaust air filter |
|
20 |
4322 009 06910 |
Air outlet grille |
|
21 |
4322 009 05350 |
Reel half spring unit |
|
23 |
4322 001 72360 |
Brake tyre |
|
24 |
4322 009 04800 |
Reel half contact unit |
|
|
|
|
|
25 |
4322 009 05060 |
Contact ring plate |
|
26 |
4322 007 11960 |
Cord set Australia |
L = 6.3 m |
27 |
4322 007 12150 |
Cord set Japan/low voltage |
|
28 |
4322 007 12190 |
Cord set UK |
L = 6.3 m |
29 |
4322 007 11920 |
Cord set 4.8 mm pins |
L = 8.5 m |
|
|
|
|
29 |
4322 007 11930 |
Cord set 4.8 mm pins |
L = 6.3 m |
30 |
4322 006 01280 |
Cord set Swiss |
L = 8.5 m |
30 |
4322 007 12020 |
Cord set Swiss |
L = 6.3 m |
31 |
4322 007 11950 |
Cord set Italy |
L = 6.3 m |
32 |
4322 003 12240 |
Dustbag sealing |
|
|
|
|
|
33 |
4322 005 07270 |
Caster |
|
34 |
4322 003 12560 |
Cover (opt.) |
|
35 |
4322 009 06710 |
Rear wheel |
|
36 |
4322 006 07220 |
Speed control 220-240V |
|
37 |
4322 003 12030 |
Cord winder lever |
|
41 |
4322 006 50580 |
Push button switch |
|
42 |
4322 003 12010 |
Motor cover |
|
43 |
4322 001 72790 |
Rear motor buffer |
|
444322 003 09720 Suspension bracket
454322 006 20720 Motor power PCB 230V/50 Hz
46 |
4322 000 03700 |
PCB clamp |
47 |
4322 009 06430 |
Motor 220-240V/50-60Hz |
48 |
4322 000 09750 |
Spring switch-knob |
71 |
4322 009 05400 |
Clip metal tube |
72 |
4322 002 22610 |
Metal tube |
|
|
|
734322 009 05410 Clip telesc. tube (opt.)
744322 004 21050 Telescopic tube (opt.)
75 |
4322 004 21850 |
Bend + hose ass’y |
76 |
4322 005 03770 |
Bend ass’y |
77 |
4322 003 12070 |
Crevice nozzle |
|
|
|
78 |
4322 004 21160 |
Small nozzle |
79 |
4322 004 22110 |
Big nozzle |
|
|
|
MAIN
SWITCH
CORD WINDER
M
ROTARY
POTMETER
MOTOR
POWER
MODULE
This product meets the requirements regarding interference suppression on radio and TV.
After the product has been repaired, it should function properly and has to meet the safety requirements as officially laid down at this moment.