Philips HQ6076, HQ6071 User notes [pt]

Register your product and get support at
www.philips.com/welcome
HQ6076,HQ6075,HQ6073, HQ6071,HQ6070
1
2
3 4
5
8 9
6 7
12 13
15 16
18 19
4222.002.5411.1
20 21
03/07/2012
ENGLISH
Introduction
Congratulations on your purchase and welcome
to Philips! To fully benet from the support that
Philips offers, register your product at www.philips.com/welcome.
General description (Fig. 1)
1 Trimmer 2 Trimmer release button 3 Socket for small plug 4 Adapter 5 Small plug 6 Battery symbol 7 On/off button 8 Shaving unit release button 9 Shaving unit 10 Protection cap 11 Pouch (not shown)
Important
Read this user manual carefully before you use the appliance and save it for future reference.
Danger
- Warning: Keep the adapter dry.
- This symbol means: Forbidden to rinse the adapter under a running tap (Fig. 2).
Warning
- The adapter contains a transformer. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation.
- This symbol means: Forbidden to use in the shower (Fig. 3).
- Warning: Do not use this appliance close to
a bathtub, shower or other containers lled
with water.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
Caution
- Do not use the shaver or the adapter if it is damaged.
- Only use the adapter supplied.
- If the adapter is damaged, always have it replaced with one of the original type in order to avoid a hazard.
- Charge, use and store the shaver at a temperature between 5°C and 35°C.
- Warning: Remove the detachable cord from the handheld part before cleaning this part in water.
- Be careful with hot water. Always check if the water is not too hot, to avoid burning your hands.
- Water may leak from the socket at the bottom of the appliance when you rinse it. This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver.
- Do not immerse the shaver in water or another liquid
- Do not use the shaver in combination with pre-shave lotions, creams, foams, gels or other cosmetic products.
General
- This shaver can be safely cleaned under the tap.
- This symbol means: Suitable to be cleaned under a running tap (Fig. 4).
- The adapter transforms 100-240 volts to a safe low voltage of less than 24 volts.
Compliance with standards
- This Philips appliance complies with all
standards regarding electromagnetic elds
(EMF). If handled properly and according to the instructions in this user manual, the appliance
is safe to use based on scientic evidence
available today.
- This shaver complies with the applicable IEC safety standards.
Charging
Make sure the appliance is switched off before you start to charge it. You can recharge the shaver between shaves, even if the battery is not empty. This does not damage the battery and prevents the battery from running low during shaving. Charging normally takes approx. 8 hours.
Do not leave the appliance connected to the mains for more than 24 hours.
Charge indications
Charging
, When you start charging the shaver, the
battery symbol lights up (Fig. 5).
Battery running low
, HQ6076/HQ6075/HQ6073: When the
battery runs low, the red battery symbol lights up. When you switch off the shaver, the
red battery symbol starts ashing. (Fig. 5)
, HQ6071/HQ6070: There is no indication that
the battery is low. The appliance switches off automatically when the battery is completely empty.
Charging the appliance
Charge the appliance when the red battery symbol
lights up or ashes (HQ6076/HQ6075/HQ6073)
or when the motor stops or starts running more slowly (HQ6071/HQ6070).
1 Put the appliance plug in the shaver (Fig. 6).
2 Put the adapter in the wall socket.
3 When the battery is fully charged, remove
the adapter from the wall socket and pull the appliance plug out of the shaver.
Cordless shaving time
A fully charged shaver has a cordless shaving time of up to 40 minutes.
Using the appliance Shaving
1 Press the on/off button once to switch on the
shaver.
The light ring lights up.
2 Move the shaving heads quickly over your
skin, making both straight and circular movements (Fig. 7).
Shaving on a dry face gives the best results. Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system.
3 Press the on/off button once to switch on
the shaver.
4 To prevent damage to the shaving unit, put
the protection cap on the shaver after every use (‘click’) (Fig. 8).
Trimming
For grooming sideburns and moustache.
1 Open the trimmer by pushing the slide
upwards (Fig. 9).
The trimmer can be activated while the motor is running.
Cleaning and maintenance
Regular cleaning guarantees better shaving performance. The easiest and most hygienic way to clean the appliance is to rinse the shaving unit and the hair chamber with hot water every time you have used the appliance.
For thorough cleaning of the shaving heads, we advise you to use Philips Shaving Head Cleaning Spray HQ110.
Every day: shaving unit and hair chamber
Warning: Remove the detachable cord from the handheld part before cleaning this part in water.
Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt.
1 Switch off the shaver, remove the adapter
from the wall socket and pull the appliance plug out of the shaver.
2 Press the release button (1) and open the
shaving unit (2) (Fig. 10).
3 Clean the shaving unit and the hair chamber
by rinsing them under a hot tap for some time (Fig. 11).
Make sure the inside of the shaving unit and the hair chamber have been cleaned properly.
4 Rinse the outside of the appliance (Fig. 12).
5 Close the shaving unit and shake off excess
water.
Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads.
6 Open the shaving unit again and leave it open
to let the appliance dry completely (Fig. 13).
You can also clean the hair chamber without water by using the brush supplied.
Every six months: shaving heads
1 Open the shaving unit.
You can also pull the shaving unit off the shaver for easier cleaning.
2 To remove the shaving heads, do the
following.
- HQ6076/HQ6075: Remove the retaining frame and take out the shaving heads. (Fig. 14)
- HQ6073/HQ6071/HQ6070: Open the shaving unit, turn the wheel anticlockwise (1) and remove the retaining frame (2). Then take out the shaving heads (Fig. 15).
3 Clean the cutters and guards with the brush
supplied (your shaving heads may differ from
the one shown in the gure) (Fig. 16).
Loading...
+ 3 hidden pages