Philips HP8350/03, HP8350/00 User Manual

HP8350/00

2

3

D

F

G

B

C

E

A

1

4

HP8350/00

ENGLISH 6
ESPAÑOL 13
PORTUGUÊS DO BRASIL 20

32

38

6

Introduction

Congratulations on your purchase and welcome to Philips! To fully benet

from the support that Philips offers, register your product at www.philips.
com/welcome.
The new Philips SalonStraight XL straightener provides great results in
less time. The professional styling temperature combined with ceramic­coated plates give you perfect long-lasting straight results.

General description (Fig. 1)

A Ceramic-coated plates
B + button to increase the temperature setting
C - button to decrease the temperature setting
D On/off slide switch
E Locking slide
F Hanging loop
G Digital LCD display with temperature setting, ‘READY’ indication and

automatic shut-off indication
Heat-resistant pouch (not shown)

Important

Read this user manual carefully before you use the appliance and save it
for future reference.

Warning

Do not use this appliance near water. Do not use this appliance near
bathtubs, showers, basins or other vessels containing water (Fig. 2).
When you use the appliance in a bathroom, unplug it after use. The
proximity of water presents a risk, even when the appliance is
switched off.
Check if the voltage indicated on the appliance corresponds to the
local mains voltage before you connect the appliance.
Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the mains cord or the appliance itself is damaged.

-

-

-

-

-

ENGLISH

If the mains cord is damaged, you must have it replaced by Philips, a

service centre authorised by Philips or similarly qualied persons in

order to avoid a hazard.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
Keep the appliance away from non-heat-resistant surfaces and never
cover the appliance with anything (e.g. a towel or clothing) when it is
hot.

Keep the appliance away from ammable items.

Never leave the appliance unattended when it is plugged in.

Caution

For additional protection, we advise you to install a residual current
device (RCD) in the electrical circuit that supplies the bathroom. This
RCD must have a rated residual operating current not higher than
30mA. Ask your installer for advice.
The straightening plates and the plastic parts near the plates reach a
high temperature quickly. Prevent the hot surfaces of the appliance
from coming into contact with your skin.
The maximum temperature occurs just after heating up. The actual
temperature during use may be lower.
Always unplug the appliance after use.
For safety reasons, the straightener automatically switches off after
having been on for 1 hour.
Wait until the appliance has cooled down before you store it.
Always switch off the appliance before you put it down, even if it is
only for a moment.
Do not leave the plates in your hair for more than a few seconds at a
time, as this may cause damage to your hair.
Do not wind the mains cord round the appliance.
Only use the appliance on dry hair.

Do not use the appliance on articial hair.

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

ENGLISH 7

Do not use the appliance for any other purpose than described in
this manual.
Keep the straightening plates clean and free of dust, dirt and styling
products such as mousse, spray and gel, for a perfect straightening
result.
The plates have a nano-diamond ceramic coating. This coating slowly
wears away over time. This does not affect the performance of the
appliance.
If you use the appliance on colour-treated hair, the straightening plates
may stain.
Never use any accessories or parts from other manufacturers or that

Philips does not specically recommend. If you use such accessories

or parts, your guarantee becomes invalid.

Electromagnetic elds (EMF)

This Philips appliance complies with all standards regarding

electromagnetic elds (EMF). If handled properly and according to the

instructions in this user manual, the appliance is safe to use based on

scientic evidence available today.

Using the appliance

Straighteners are powerful styling tools and must always be used with
care. As with all straighteners that reach salon-high temperatures, do not
use the appliance frequently to avoid damage to the hair.
If you use the straightener incorrectly or at a wrong temperature setting,
you could overheat your hair or even burn it. Always make sure you
select a temperature setting that is suitable for your hair type.

Note: Make sure your hair is completely dry before you straighten it.

Straightening

1 Put the plug in the wall socket.

2 Lock the straightening plates if you want the straightening plates to

heat up more quickly (Fig. 3).

To lock the straightening plates, press the plates together and push the
locking slide downwards.

-

-

-

-

-

ENGLISH8

3 Set the on/off slide switch to ‘I’ to switch on the appliance (Fig. 4).

The default temperature setting of 120 appears on the display. As
soon as the appliance has heated up to this setting, the word
‘READY’ appears on the display (Fig. 5).

Never leave the appliance unattended when it is plugged in. Always put
the appliance on a heat-resistant surface when it is heating up and
when it is hot.

For safety reasons, the straightener automatically switches off after
having been on for 1 hour.

4 Select a temperature setting (120 to 220) that is suitable for your

hair type.

Always select a low setting when you use the straightener for the rst

time.
For coarse, curly or hard-to-straighten hair, select a medium to high
setting (170 and up).

For ne, medium-textured or softly waved hair, select a medium to

low setting (160 and below).

Note: Take extra care with pale, blonde, bleached or colour-treated hair, since
it is susceptible to damage at high temperatures.

5 Use the + and - buttons to set the appropriate temperature

setting. (Fig. 6)
The display shows the selected temperature setting.
When the appliance has heated up to the selected setting, the word
‘READY’ appears on the display.
The bars on the display show the remaining usage time of the
appliance. The total usage time is 60 minutes. Every ten minutes,
one of the six bars disappears. After 60 minutes, the appliance
switches off automatically.

6 Comb or brush your hair so that it is disentangled and

smooth. (Fig. 7)

7 Use a comb to divide the hair into sections. Do not put too much

hair in one section.

,

-

-

-

,
,

,

ENGLISH 9

Note: It is better to section off the crown area and to straighten the hair

underneath rst. Then straighten the top area.

8 If the straightening plates are locked, push the locking slide upwards

to unlock them (Fig. 8).

9 Take a section that is not wider than 5cm. Place it between the

straightening plates and press the handles of the appliance rmly

together.

10 Slide the straightener down the length of the hair in 5 seconds,

from root to hair end, without stopping to prevent
overheating (Fig. 9).

Tip: If you want to create icks, straighten the lock and turn the

straightener a half-circle inwards (or outwards) when you get to the end of
the lock. Hold the straightener in this position for 2 to 3 seconds and then
release the lock (Fig. 10).

11 Repeat this process after 20 seconds until you have achieved the

desired look.

12 Let your hair cool down. Do not comb or brush it before it has

cooled down, as this would ruin the hairstyle you have just created.

Cleaning

Never immerse the appliance in water or any other liquid, nor rinse it
under the tap.

1 Switch off the appliance and unplug it.

2 Let the appliance cool down completely on a heat-resistant surface.

3 Clean the appliance with a damp cloth.

Note: Make sure the appliance is completely dry before you use or store it.

Storage

Never wind the mains cord round the appliance.

1 Switch off the appliance and unplug it.

ENGLISH10

2 Let the appliance cool down on a heat-resistant surface.

3 Press the straightening plates together and push the locking slide

downwards to lock the plates (Fig. 3).

4 Store the appliance in a safe and dry place. You can also store the

appliance by hanging it from its hanging loop.

Environment

Do not throw away the appliance with the normal household waste

at the end of its life, but hand it in at an ofcial collection point for

recycling. By doing this, you help to preserve the
environment (Fig. 11).

Guarantee & service

If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer

Care Centre in your country (you nd its phone number in the
worldwide guarantee leaet). If there is no Consumer Care Centre in

your country, go to your local Philips dealer.

Troubleshooting

This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Philips Consumer Care Centre in your
country.

Problem Possible cause Solution

The
appliance
does not
work.

There is a power
failure or the socket
to which the
appliance is
connected is not live.

Check if the power supply
works. If it does, plug in another
appliance to check whether the
socket is live.

-

ENGLISH 11

Problem Possible cause Solution

You have not
switched on the
appliance.

Set the on/off slide switch to ‘I’
to switch on the appliance.

The
appliance overheated
and switched itself
off.

Unplug the appliance and let it
cool down for a few minutes.
Then set the on/off slide switch
to ‘I’ to switch on the appliance
again.

The mains cord is
damaged

If the mains cord is damaged,
you must have it replaced by
Philips, a service centre
authorised by Philips or similarly

qualied persons in order to

avoid a hazard.

The appliance is not
suitable for the
voltage to which it is
connected.

Make sure that the voltage

indicated on the appliance
corresponds to the local mains
voltage.

ENGLISH12

13

Introducción

Enhorabuena por la compra de este producto y bienvenido a Philips. Para
sacar el mayor partido de la asistencia que Philips le ofrece, registre su
producto en www.philips.com/welcome.
La nueva plancha para el pelo SalonStraight XL de Philips proporciona
excelentes resultados en menos tiempo. La temperatura de moldeado
profesional, combinada con las placas con revestimiento de cerámica
proporcionan un alisado perfecto y duradero.

Descripción general (g. 1)

A Placas con revestimiento cerámico
B Botón + para aumentar la temperatura
C Botón - para disminuir la temperatura
D Botón de encendido/apagado
E Botón de bloqueo
F Anilla para colgar
G Display LCD digital con ajuste de temperatura, indicador ‘READY’

(listo) e indicador de apagado automático
Funda resistente al calor (no se muestra)

Importante

Antes de usar el aparato, lea atentamente este manual de usuario y
consérvelo por si necesitara consultarlo en el futuro.

Advertencia

No utilice este aparato cerca del agua ni cerca de bañeras, duchas,

cubetas u otros recipientes que contengan agua (g. 2).

Si utiliza el aparato en el cuarto de baño, desenchúfelo después de
usarlo. La proximidad de agua representa un riesgo, aunque el
aparato esté apagado.
Antes de enchufar el aparato, compruebe si el voltaje indicado en el
mismo se corresponde con el voltaje de red local.
Compruebe el estado del cable de alimentación con regularidad. No
utilice el aparato si la clavija, el cable de alimentación o el propio
aparato están dañados.

-

-

-

-

-

ESPAÑOL

Si el cable de alimentación está dañado, debe ser sustituido por

Philips o por un centro de servicio autorizado por Philips, con el n

de evitar situaciones de peligro.
Este aparato no debe ser usado por personas (adultos o niños) con
su capacidad física, psíquica o sensorial reducida, ni por quienes no
tengan los conocimientos y la experiencia necesarios, a menos que
sean supervisados o instruidos acerca del uso del aparato por una
persona responsable de su seguridad.
Asegúrese de que los niños no jueguen con este aparato.

Mantenga el aparato lejos de supercies no resistentes al calor y

nunca cubra el aparato (por ejemplo, con una toalla o ropa) mientras
esté caliente.

Mantenga el aparato lejos de objetos inamables.

No deje nunca el aparato desatendido cuando esté enchufado.

Precaución

Como protección adicional, aconsejamos que instale en el circuito
que suministre electricidad al cuarto de baño un dispositivo de
corriente residual (RCD) con una corriente residual de
funcionamiento que no exceda los 30 mA. Consulte a su electricista.
Las placas alisadoras y las piezas de plástico cercanas a las placas se

calientan mucho rápidamente. Evite que las supercies calientes del

aparato entren en contacto directo con su piel.
La máxima temperatura se alcanza justo después del proceso de
calentamiento. La temperatura real durante el uso puede bajar.
Desenchufe siempre el aparato después de usarlo.
Por motivos de seguridad, la plancha se desconecta automáticamente
tras una hora de funcionamiento.
Espere a que se enfríe el aparato antes de guardarlo.
Apague siempre el aparato cuando lo deje en algún sitio, aunque sólo
sea por un momento.
No deje las placas en contacto con el cabello más de unos pocos
segundos cada vez, ya que podrían dañarlo.
No enrolle el cable de alimentación alrededor del aparato.
Utilice el aparato sólo sobre el pelo seco.

No utilice el aparato sobre cabello articial.

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

ESPAÑOL14