Philips HP6322/01 User Manual

www.philips.com

Ladyshave softselect

HP6322/01

ENGLISH 2 - 3

4 - 5

6

7

1

2

3

4

5

8

11

14 15

17

6

9

12

18

7

10

13

OIL

16

A

B

C

19

E

A

B

C

D

2 ENGLISH

Introduction

◗ This Philips Ladyshave softselect is equipped

with an adjustable shaving foil with three
different zones for shaving the underarms,
bikini line and legs.

◗ The golden zone of the shaving foil is most

suitable for shaving the underarms (fig. 1).

◗ The gold-striped zone of the shaving foil is

most suitable for shaving the bikini line (fig. 2).

◗ The silvery zone of the shaving foil is most

suitable for shaving the legs (fig. 3).

◗ This Ladyshave can only be operated on

batteries.

◗ The Jojoba Glider (fig. 4) improves the gliding

of the appliance to help reduce the risk of
skin irritation for a smooth shave.

Wet or dry use

You can use the Ladyshave softselect either dry
or wet. If you shave while taking a bath or
shower, we advise you to use soap or shaving
foam for the most comfortable shave.After use
you can simply rinse the Ladyshave in the shower
or under the tap. Make sure the battery cap is
properly closed during wet use and when cleaning
the appliance.

Important

◗ Do not use or clean the appliance with water

that is hotter than shower temperature.

◗ Store the appliance at a temperature between

15°C and 35°C.

General description

A Shaving foil
B Soft select slide
C On/off switch
D Battery cap
E Brush

Preparing the appliance for use

The Ladyshave runs on 2 R6 AA 1.5 volt
batteries. We strongly advise you to use Philips
LR6 PowerLife batteries. They supply sufficient
energy for approx. 40 minutes of shaving.

1 Pull the battery cap downwards with some

force to remove it (fig. 5).

2 Put the batteries in the battery holder.

Make sure the + and - poles of the batteries are
pointing in the right direction (fig. 6).
Make sure your hands and the appliance are dry
when inserting the batteries.

3 Push the battery cap back onto the appliance.

To avoid damage due to battery leakage:
Do not expose the Ladyshave to direct sunlight.
Remove the batteries if the appliance is not going
to be used for a month or more.
Do not leave empty batteries in the appliance.

Using the appliance

1 Check whether the softselect slide on the

shaving head is in the appropriate position for
the body part you wish to shave (fig. 7).

2 Switch the Ladyshave on (fig. 8).

3 Place the trimmers and the shaving foil

gently on the skin and move the Ladyshave
slowly over the skin against the direction of hair
growth while pressing it lightly (fig. 9).

Make sure that both trimmers and the shaving foil
are always completely in contact with the skin.

Cleaning the appliance

Clean the Ladyshave every time you have used it.

Do not use any corrosive detergents, scouring
pads or cloths, petrol, acetone etc. to clean the
appliance.

1 Switch the appliance off.

2 Remove the shaving head (fig. 9).

Do not exert any pressure on the shaving foil to
avoid damage.

3 Always put the protective cap on the shaving

head to avoid damage to the foil.

4 Brush the hairs off the cutter block and the

shaving head. Make sure you also brush away
any hairs that have collected under the
trimmers (fig. 10).

Do not clean, rinse or immerse the Ladyshave in
water if the battery cap is not properly closed.
Do not use water that is hotter than shower
temperature to clean the appliance.

Maintenance and replacement

1 Lubricate the shaving foil and the trimmers

with a drop of sewing machine oil twice a year
(fig. 12).

If you use the Ladyshave two or more times a
week, we advise you to replace the shaving foil
and cutter block every two years.

◗ The shaving foil may only be replaced with an

original Philips shaving foil (type HP6120).

2 Remove the shaving head (fig. 10).
3 Press the shaving head in the direction of

the arrows with some force, then remove the
foil (fig.13).

4 Make sure the softselect slide is in the

middle position (bikini line) when you insert the
new foil (fig.14).

5 Press the sides of the shaving head slightly

together and insert the new foil (fig. 15).

6 Note that pivots A, B and C should snap

into the corresponding holes (fig. 16.
◗ The cutter block may only be replaced with

an original Philips cutter block, type HP2909

(figs. 17 and 18).

To change the cutter block, pull it off the
appliance with some force.

◗ If a trimmer is worn out or damaged, please

contact your Philips dealer or a Philips Service

Centre for replacement.

4203 000 51027

2/7

3 ENGLISH

The environment

Batteries contain substances that may pollute the
environment.

◗ Do not throw empty batteries away with the

normal household waste, but hand them in at
an official collection point (fig. 19).

◗ Make sure the batteries are completely empty

when you dispose of them.

◗ When discarding the appliance in due course,

put the motor unit and other metal parts into
a metal recycling box.

◗ All plastic parts are marked with recycling

symbols. Please dispose of them in accordance
with local regulations.

Information & service

If you need information or if you have a problem,
please visit the Philips Web site at
www.philips.com or contact the Philips Customer
Care Centre in your country (you will find its
phone number in the worldwide guarantee
leaflet). If there is no Customer Care Centre in
your country, turn to your local Philips dealer or
contact the Service Department of Philips
Domestic Appliances and Personal Care BV.

4203 000 51027

3/7