Philips HP6322/01 User Manual [ko]
Ladyshave softselect
HP6322/01
www.philips.com
u
4203 000 51026
Introduction
◗ This Philips Ladyshave softselect is equipped
with an adjustable shaving foil with three
different zones for shaving the underarms,
bikini line and legs.
◗ The golden zone of the shaving foil is most
suitable for shaving the underarms (fig. 1).
◗ The gold-striped zone of the shaving foil is
most suitable for shaving the bikini line (fig. 2).
◗ The silvery zone of the shaving foil is most
suitable for shaving the legs (fig. 3).
◗ This Ladyshave can only be operated on
batteries.
◗ The Jojoba Glider (fig. 4) improves the gliding
of the appliance to help reduce the risk of skin
irritation for a smooth shave.
Wet or dry use
You can use the Ladyshave softselect either dry or
wet. If you shave while taking a bath or shower, we
advise you to use soap or shaving foam for the
most comfortable shave.After use you can simply
rinse the Ladyshave in the shower or under the
tap. Make sure the battery cap is properly closed
during wet use and when cleaning the appliance.
Important
◗ Do not use or clean the appliance with water
that is hotter than shower temperature.
◗ Store the appliance at a temperature between
15°C and 35°C.
General description
A Shaving foil
B Soft select slide
C On/off switch
D Battery cap
E Brush
Preparing the appliance for use
The Ladyshave runs on 2 R6 AA 1.5 volt
batteries. We strongly advise you to use Philips
LR6 PowerLife batteries.They supply sufficient
energy for approx. 40 minutes of shaving.
1 Pull the battery cap downwards with some
force to remove it (fig. 5).
2 Put the batteries in the battery holder.
Make sure the + and - poles of the batteries are
pointing in the right direction (fig. 6).
Make sure your hands and the appliance are dry
when inserting the batteries.
3 Push the battery cap back onto the appliance.
To avoid damage due to battery leakage:
Do not expose the Ladyshave to direct sunlight.
Remove the batteries if the appliance is not going
to be used for a month or more.
Do not leave empty batteries in the appliance.
Using the appliance
1 Check whether the softselect slide on the
shaving head is in the appropriate position for
the body part you wish to shave (fig. 7).
2 Switch the Ladyshave on (fig. 8).
3 Place the trimmers and the shaving foil
gently on the skin and move the Ladyshave
slowly over the skin against the direction of hair
growth while pressing it lightly (fig.9).
Make sure that both trimmers and the shaving foil
are always completely in contact with the skin.
Cleaning the appliance
Clean the Ladyshave every time you have used it.
Do not use any corrosive detergents, scouring
pads or cloths, petrol, acetone etc. to clean the
appliance.
1 Switch the appliance off.
2 Remove the shaving head (fig.9).
Do not exert any pressure on the shaving foil to
avoid damage.
3 Always put the protective cap on the shaving
head to avoid damage to the foil.
4 Brush the hairs off the cutter block and the
shaving head. Make sure you also brush away any
hairs that have collected under the trimmers
(fig. 10).
Do not clean, rinse or immerse the Ladyshave in
water if the battery cap is not properly closed.
Do not use water that is hotter than shower
temperature to clean the appliance.
English
Maintenance and replacement
1 Lubricate the shaving foil and the trimmers
with a drop of sewing machine oil twice a year
(fig. 12).
If you use the Ladyshave two or more times a
week, we advise you to replace the shaving foil
and cutter block every two years.
◗ The shaving foil may only be replaced with an
original Philips shaving foil (type HP6120).
2 Remove the shaving head (fig.10).
3 Press the shaving head in the direction of the
arrows with some force, then remove the foil
(fig.13).
4 Make sure the softselect slide is in the
middle position (bikini line) when you insert the
new foil (fig.14).
5 Press the sides of the shaving head slightly
together and insert the new foil (fig. 15).
6 Note that pivots A, B and C should snap into
the corresponding holes (fig. 16.
◗ The cutter block may only be replaced with an
original Philips cutter block, type HP2909
(figs. 17 and 18).
To change the cutter block, pull it off the appliance
with some force.
◗ If a trimmer is worn out or damaged, please
contact your Philips dealer or a Philips Service
Centre for replacement.
The environment
Batteries contain substances that may pollute the
environment.
◗ Do not throw empty batteries away with the
normal household waste, but hand them in at
an official collection point (fig. 19).
◗ Make sure the batteries are completely empty
when you dispose of them.
◗ When discarding the appliance in due course,
put the motor unit and other metal parts into
a metal recycling box.
◗ All plastic parts are marked with recycling
symbols. Please dispose of them in accordance
with local regulations.
Information & service
If you need information or if you have a problem,
please visit the Philips Web site at
www.philips.com or contact the Philips Customer
Care Centre in your country (you will find its
phone number in the worldwide guarantee
leaflet). If there is no Customer Care Centre in
your country, turn to your local Philips dealer or
contact the Service Depar tment of Philips
Domestic Appliances and Personal Care BV.
1
5
8
11
14 15
17
2
3
4
6
9
12
7
10
13
OIL
16
A
B
C
18
19
5
9
1
2
3
5
6
7
8
9
10
11
12
10
13
14
15
16
17 18
1
2
3
4
5
8
6
9
7
10
2004/04/19
A
11
12
B
C
14 15
E
D
17
18
13
OIL
16
A
B
C
19
Loading...