short
A
E
F
I
B
D
G
C
H
1
Important
• Before connecting the appliance, check that the voltage indicated on the type
plate corresponds to the local mains voltage.
• Do not use this product near water in e.g. baths, washbasins, sinks.
If the product falls into water, unplug it immediately and dispose of it. It must not be used
again.
• Always ensure that the attachments are completely dry (on the inside as well as the outside!)
before affixing them to the styler.
• Always switch the appliance off before putting it down, even if it is only for a moment.
• For additional protection, the installation of a residual current device (RCD) with a rated
residual operating current not exceeding 30 mA is advisable in the electric circuit supplying
the bathroom. Ask your electrician for advice.
• Even when the appliance is switched off, the electricity has not been cut off. Always pull out
the mains plug when the appliance is not being used.
• Never obstruct the air inlet grille.
• This product is equipped with an automatic overheating protection device. If the appliance
overheats, it will switch off. Unplug the appliance. After cooling down for a few minutes, the
appliance can be used again. Before switching back on again, check the air inlet grille for
possible blockage by fluff, hair, etc. If in doubt, consult your dealer or an Authorised Philips
Service Centre.
• Check the condition of the mains cord regularly. Do not wind the mains cord around the
appliance.
• The mains cord of this appliance cannot be replaced. If the cord is damaged, the appliance
should be discarded.
• For examination or repairs always return the appliance to an Authorised Philips Service
Centre. Unqualified repair work can be dangerous for the user.
Your new Philips Profile Style has been specially designed to give beautiful styling results. It is quick and
easy to use. We hope you will enjoy using your Profile Style - the hairstyler with which you can create
almost any desired hairdo.
In order to get the best results, please read the instructions carefully before use. Also refer to the
illustrations on fold-out pages.
English
• Before styling, brush or comb your hair to
ensure that it is untangled.
• Prevent the hair from becoming too dry.
Overdrying may result in frizzy hair ends which
are hard to style.
• The results you can obtain with the Profile Style
depend upon various factors, for example the
thickness, length and structure of your hair.
Experimenting with the attachments will allow
you to discover the styling possibilities for your
particular hair type and will help you determine
how to achieve the best results.
• Always switch the appliance off before removing
and/or affixing the attachments.
Attachments
• Shape Brush
The Shape Brush is suitable especially for straight
or wavy short hair.Its special design with vented
hollow center ensures that the warm air is directed
directly into your hairdo. The bobble-tipped pins
provide good grip on the hair.
The heated air from the front of the brush ensures
optimum styling and “volume”. For a longer lasting
result you can apply some mousse before styling
your hair.
Volume
- Insert the Shape Brush into the hair. Brush
against the direction of the hair growth, touching
the scalp with the brush. Then rotate the
attachment away from the head (fig. 4). The hair
will be lifted and fall lightly back onto the head.
In this manner you add maximum volume and
body to the hair.
• If the hair is still damp you can hold the Shape
Brush still for a moment, before you rotate it
away from the head to remove it.
• You can also add volume to long hair by holding
your head down and brushing the hair with the
Styler in this position.
General description (fig. 1)
A Hairstyler
B Shape Brush
C Retractable Bristle Brush with metal bar
D Switch
0 = Off
| = Warm air flow for easy styling
E Air inlet grille
F Swivel cord
G Release button for detaching attachments
H Bristle retraction knob (to retract or push out
the bristles)
I Hanging loop
To affix an
attachment:
- Align the attachment with
the styler, making sure
the arrows on the
attachment are in line
with the arrows on the
styler. Press to fit (fig. 2).
To remove an
attachment:
- While pressing the
release button, pull the
attachment in the
direction of the arrow
(fig. 3).
How to use
• Remember, a good haircut is the basis for a good
hairstyle.
• The Profile Style is most effective when the hair is
slightly damp. After washing, dry your hair in the
normal way until it is damp. Then begin using your
styler. When the hair is dry, slightly dampen it with
water.
2
CLICK
3
1
2
Shaping and Styling
Making waves in short to medium hair
- Switch on the appliance. Insert the Shape Brush
into the hair (fig. 5) and wind the brush in the
hair in the desired direction (fig. 6). The resulting
shape of the wave depends on the direction you
turn the brush.
- As soon as the hair is warm to the touch,
remove the hot air brush from the hair by
rotating it away from the head.
- Leave the curls or waves to cool down, before
finishing by combing, brushing or fingercombing
the hair into its final style (fig. 7).
- Of course the Shape Brush is also very suitable
to curl your hair in or outwards.
• Retractable Bristle Brush
Making curls in short to medium hair
- Divide the hair into locks (fig. 8) , using a comb.
Do not take too much hair in one lock.
- Switch on the appliance. Wind the hair around
the brush in the desired direction (fig. 9).
Ensure that the hair is wound up so that it is at
right angles to the scalp (fig. 10). This will give
your hair optimum lift and volume (fig. 11). As
soon as the hair is warm to the touch, retract the
bristles and remove the brush from the hair
sideways.
Making waves in long hair
- Switch on the appliance. Take the ends of the
hair and wind them around the brush in the
desired direction (fig. 12). The resulting shape of
the wave depends on the thickness of the lock.
- As soon as the hair is warm to the touch, retract
the bristles and remove the hot air brush from
the hair.
- Leave the curls or waves to cool down, before
finishing by combing, brushing or fingercombing
the hair into its final style (fig. 13).
To remove the brush from the hair
• Retractable Bristle Brush
- It is not necessary to rotate the brush in the
opposite direction. Simply push and turn the
bristle retraction knob in the direction of the
arrows (fig. 14) and the bristles will retract.
- Slide the metal bar sideways out of the curl.
This will prevent the curl from getting spoilt or
tangled and makes it last longer.
Cleaning
The brushes can be cleaned with a small brush or
a dry cloth.
Storage
The appliance can be hung
from the hanging loop
(fig. 15).
15
4
7
10
12
5
8
14
666
9
1
11
13
2
;
4222 002 21322
Loading...