Philips HD8773-47 User Manual
CONTROL PANEL QUICK REFERENCE
For a full understanding of functions, see the user manual.
24. Espresso brew button
25. Medium Coffee brew button
26. Long Coffee brew button
27. Cappuccino brew button
28. "Aroma" - Pre-ground
coffee button
29. Menu button
30. ON/OFF button
24 27
25 28
26 29
30
TROUBLE SHOOTING
Q: Why isn’t my coffee coming out hot enough?
A: The beverage temperature setting may be too low. Adjust the beverage
temperature setting to Normal or High.
A: Cups may be cold. Preheat cups with hot water prior to dispensing coffee.
Q: Why is my coffee coming out so weak?
A: The machine automatically adjusts itself after brewing a few cups of coffee to
optimize the extraction of the coffee to the compactness of the ground coffee.
We recommend brewing 3-5 espressos before drinking to allow for this
adjustment process. Refer to the "Saeco Adapting System" in the user manual
for more information.
A: The coffee may be too coarse. Change the coffee blend or adjust the grind. Finer
coffee grounds result in stronger tasting coffee. Refer to the “Adjusting the ceramic
coffee grinder” in the user manual for more information.
Q: Why is my machine leaking water/coffee?
A: Sometimes water is drained automatically by the machine into the drip tray to
manage the rinsing of the circuits and ensure optimum machine performance.
A: The dispensing spout may be clogged. Clean the holes in the dispensing spout.
Q: Why isn’t the machine filling up my cup?
A: The machine’s coffee lengths can be programmed. Enter the beverage
programming menu and adjust the coffee length setting to your liking for every
beverage. See "Adjusting the coffee length" sections in the user manual.
PLEASE NOTE: OUR MACHINES ARE TESTED WITH
COFFEE AT THE FACTORY TO ENSURE HIGH
QUALITY STANDARDS. WHILE MACHINES ARE
CLEANED THOROUGHLY AFTER TESTING, IN
SOME CASES, COFFEE GROUNDS MAY REMAIN IN
THE MACHINE.
FOR FULL INSTRUCTIONS, PLEASE REFER TO THE
USER MANUAL
SET UP
1
2
Open lid and use handle to remove water tank. To use without
water filter, rinse tank with water. Fill with fresh water up to
MAX mark. Place water tank into machine. To install water filter
see user manual.
NOTE: Only use cool fresh water, any other liquid may cause
damage.
Open coffee bean hopper lid. Slowly pour beans into hopper.
Replace lid.
NOTE: Only use coffee beans. Ground, instant and flavored
coffees may damage the machine.
BEFORE FIRST USE
1
Switch power button on back of machine
to the “I” or ON position.
QUICK START GUIDE
MINUTO CARAFE
HD8773/47
For more troubleshooting please refer to the User Manual.
NEED ASSISTANCE:
If you have any questions or concerns, we are always available to assist you. Please
call us direct at 1-800-933-7876
or visit us at www.philips.com/saeco
421946005561
2/2014
Turn machine on by pressing
2
on control panel.
“ ” button
3
Once heated, a 1-minute rinse/self-cleaning cycle with fresh water will begin automatically.
4
Place a container under dispensing spout to catch water.
5
Before using the machine for the first time a manual rinse cycle must be initialized. Place
container under dispensing spout. Select the pre-ground coffee brewing function by
pressing the
“ ” button. Wait for dispensing to stop. When it has stopped, repeat this operation 2
more times.
NOTE: Do not add pre-ground coffee into the machine during this process.
6
Place a container under the water dispensing spout and press the “
Press the
spout. Do this until the "no water" icon appears on the display.
“ ” button. Check that the selection lever is set to “ESPRESSO”. Press the
“ ” button twice to start dispensing hot water through the water dispensing
Once machine turns on, it will automatically prime the circuit. When
the process is completed the machine will stop automatically.
Yel l ow
” MENU button.
OPTIMIZE YOUR COFFEE
To optimize coffee extraction to compactness of the ground coffee, brew 3-5 cups of espresso
and discard BEFORE drinking.
Fill the water tank again up to the MAX level indicator.
1
Place a cup under dispensing spout and press the
2
dispense espresso.
3
Repeat Step 2 three-five times.
4
Your machine is now ready to brew coffee!
“ ” button to grind and
BREWING AN ESPRESSO USING WHOLE BEANS
1
Place an espresso cup under dispensing spout and adjust it accordingly.
3
Press the “
“
” button to start brewing.
” button to select your desired aroma or strength. Press the
BREWING A LONG COFFEE USING WHOLE BEANS
1
2
3
Press the “
“
” button to start brewing.
Remove lower part of the dispensing spout and place a travel
mug underneath it.
Push lever to the up position to select the
COFFEE function.
” button to select your desired aroma or strength. Press the
USING THE MILK CARAFE
1
Remove the carafe lid and pour milk between the MIN and
MAX level indicators.
2
3
ESPRESSO
Press the “
the “
” button to start brewing.
Push lever downwards to select ESPRESSO function.
” button to select your desired aroma or strength. Press
BREWING A MEDIUM COFFEE USING WHOLE BEANS
1
Place a coffee mug under the dispensing spout and adjust it accordingly.
2
COFFEE
Push the lever to the up position to select the COFFEE function.
2
3
Slide the milk carafe dispenser right to the
4
To make an cappuccino place a cup under the dispensing spout then press the
“ ”
button. For frothed milk place a cup under the dispensing spout then
press the
start frothing milk.
5
After each use, clean milk carafe as described in the user manual.
“
Insert the milk carafe by slightly tilting then pushing the carafe
towards the bottom while rotating until it is locked at the drip
tray.
NOTE: Do not use force while inserting the carafe.
" "
icon.
”
MENU button. Press the
“ ”
button then the
“ ”
button to
Loading...