Philips HD7811 68, HD7812 68, HD7814 68, HD7815 68, HD7816 68 Owner Manual

HD7812, HD7810
HD7811
HD7816, HD7814, HD7812, HD7811, HD7810
Coffee Machine
1
2 3 4 5
6
10 11 12 13
14 15 16 17
18 19 20 21
7 8
9
22 23 24 25
26
27
ENGLISH
4222.001.9719.8
2/4
Introduction
With SENSEO\, you can enjoy a perfect cup of coffee with a delicious crema layer whenever you feel like it. Each cup is freshly brewed, so you’re always sure of a pure and round taste. SENSEO\ combines a unique brewing method from Philips with convenient coffee pods from Douwe Egberts, available in different blends
of ne roast and ground coffee. Together they make sure you only get the very best in avour and aroma from the
coffee.
The Douwe Egberts coffee in convenient SENSEO\
coffee pods and Philips’ unique new SENSEO\ brewing system are perfectly matched to ensure that the best taste and aroma are extracted from the coffee.
To optimise the taste of the coffee, keep the following
aspects in mind:
Fresh water
Use fresh water every day. If you have not used the coffee
machine for three days, you have to ush it with fresh
water before you use it again (see section ‘Flushing’ in chapter ‘Cleaning’).
Fresh coffee pods
Use the SENSEO\ coffee pods that have been specially developed by Douwe Egberts for your SENSEO\ coffee machine for a full, round taste. Douwe Egberts SENSEO\ coffee pods stay fresh longer if you close the package with the keep-fresh seal after use or if you store them in a storage container.
A clean machine
Clean and descale the Philips SENSEO\ coffee machine regularly (see chapters ‘Cleaning’ and ‘Descaling’). Remove used coffee pods after brewing. If a used pod has been left in the coffee machine and you have not used the
machine for some time, ush the machine before you use
it again (see section ‘Flushing’ in chapter ‘Cleaning’).
General description (Fig. 1)
A Water reservoir B Lid of water reservoir C 1-cup pod holder ° D 2-cup pod holder °° E Coffee spout F Cover of coffee spout G Drip tray H Cup tray I Water distribution disc J Sealing ring K Outow valve L Indicator light
Important
Read these instructions for use carefully before you use the machine and save them for future reference.
Check if the voltage indicated on the bottom of
,
the machine corresponds to the local mains voltage before you connect the machine. If the mains cord is damaged, it must be replaced
,
by Philips, a service centre authorised by Philips
or similarly qualied persons in order to avoid a
hazard. To prevent unexpected contact with hot water,
,
always make sure the lid of the SENSEO\ machine is properly locked before you start using the machine. Never put normal ground coffee or use torn pods
,
in the SENSEO\ machine, as this causes it to become blocked. Do not use the machine in combination with
,
a transformer, as this could cause hazardous situations.
Put the machine on a at, stable surface. Never let
,
the machine operate unattended. Do not use the machine at altitudes higher
,
than 2200 metres above sea level. The machine does not work at temperatures below
,
10°C. Flush the coffee machine with fresh water before
,
you use it for the rst time (see chapter ‘Preparing the machine for use’). This causes the boiler to ll
with water, which is essential for the machine to work properly.
This appliance is not intended for use by persons
,
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they
,
do not play with the appliance.
Electromagnetic elds (EMF)
This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If handled
properly and in accordance with the instructions in this instruction manual, the appliance is safe to use according
to scientic evidence available today.
Preparing the machine for use
You cannot brew coffee if you have not ushed the
SENSEO\ coffee machine rst!
The ushing cycle causes the boiler to ll with water.
After this, the coffee machine is ready for use. Flush the machine in the following way:
1 Remove the water reservoir (Fig. 2).
2 Fill the water reservoir with cold water up to
the MAX indication and put it back onto the
machine. (Fig. 3)
3 Move the lever upwards to release the lid (Fig. 4).
4 Open the lid (Fig. 5).
5 Put the 1-cup pod holder ° or the 2-cup pod
holder °°in the machine without pod(s). (Fig. 6)
6 Close the lid and lock the lever (Fig. 7).
Note: Make sure you lock the lever properly. Push it down until it snaps home with a click.
Note: Never ush the machine with the lid open. The lid
must be properly locked.
7 Put the plug in an earthed wall socket.
8 Put a bowl (with a capacity of at least 1500ml)
under the coffee spout to collect the water. (Fig. 8)
9 Press the on/off button I and subsequently press
the 1-cup button ° and the 2-cup button °°
briey at the same time. (Fig. 9) The boiler lls itself with water from the water
,
reservoir. This takes some time (approx. 90 to 150
seconds). The machine switches off automatically
when the ushing cycle ends. During the ushing
cycle, the machine produces more noise than during a regular brewing cycle.
Note: Before you use the machine for the rst time, clean
the coffee spout and the pod holders with hot water and some washing-up liquid or in the dishwasher. Clean the
water reservoir thoroughly in hot water, if necessary with
some washing-up liquid.
Now your Philips SENSEO\ coffee machine is ready for use.
Brewing coffee
1 Fill the water reservoir with cold water up to
the MAX indication and put it back onto the
machine. (Fig. 3)
Never pour milk, coffee, hot water or carbonated water into the water reservoir.
° MIN: minimum amount of water required to
­brew 1 cup of SENSEO\ coffee.
°° MIN: minimum amount of water required to
­brew 2 cups of SENSEO\ coffee. A full reservoir allows you to make SENSEO\ coffee
­a number of times (up to 5 cups (HD7810, HD7812) or up to 10 cups
(HD7811). This makes it unnecessary to ll the
water reservoir each time you want to make a cup of coffee.
2 Press the on/off button I. (Fig. 10)
The indicator light blinks while the water is heating up. Heating up takes approx. 90 seconds.
The coffee machine is ready for use when the
,
indicator light burns continuously.
3 Move the lever upwards to release the lid (Fig. 11).
4 Open the lid.
5 Place the appropriate pod holder in the machine.
Note: Make sure the pod holder is clean and the sieve in the
centre is not clogged, e.g. with loose coffee grounds.
,
If you want to make one cup of SENSEO use 1 coffee pod in combination with the 1-cup pod holder ° and the 1-cup button °. (Fig. 12) If you want to make two cups of SENSEO\ coffee,
,
use 2 coffee pods in combination with the deeper 2-cup pod holder °° and the 2-cup button
°°. (Fig. 13)
6 Place the SENSEO
centre of the pod holder, with the convex side pointing downwards.
Note:Use SENSEO\ coffee pods from Douwe Egberts specially designed for your SENSEO\ coffee machine for a full and round taste.
Place 1 SENSEO\ coffee pod in the 1-cup pod
,
holder °. (Fig. 14) Place 2 SENSEO\ coffee pods in the 2-cup pod
,
holder °°. (Fig. 15)
Note: Make sure the coffee in the pod(s) is evenly distributed and press the pod(s) lightly into the pod holder.
Note: Never put normal ground coffee or use torn pods in the SENSEO\ machine, as this causes it to become blocked.
\
coffee pod(s) properly in the
\
coffee,
7 Close the lid and lock the lever (Fig. 7).
Always make sure the lid is properly locked. Push the lever down until it snaps home with a click.
Never start brewing with the lid open. The lid must be properly closed.
8 Place one cup or two cups under the spout
openings (Fig. 16).
The cups you use should have a capacity of at least
150ml. Do not use cups that are too large, as they cause the coffee to get cold more quickly.
9 Press the button that indicates the number of cups
of SENSEO\ coffee you want to brew. (Fig. 17)
° for one cup
­°° for two cups
-
The SENSEO\ coffee machine starts brewing.
,
The machine automatically supplies the optimal
­amount of water. You can interrupt the brewing process at any time
­by pressing the on/off button I. If you switch the machine back on after you have interrupted the brewing process, the machine does not complete the interrupted brewing cycle.
Do not remove the water reservoir during a brewing cycle, as this causes the machine to draw in air. When
this happens, the next cup will only be partly lled.
Note: If you only get a small quantity of coffee or no coffee
at all out of the machine, you have not ushed the machine properly before rst use. As a result, the boiler is not or not completely lled. Flush the machine properly (see chapter
‘Preparing the machine for use’) before you brew another cup of coffee.
10 After use, lift the pod holder out of the machine
and remove the coffee pod(s).
Be careful when you do this, for there may still be some water/coffee on the coffee pod(s).
Tips
Rinse the pod holders and the coffee spout
,
regularly to make sure that the coffee always tastes optimally. The SENSEO\ coffee tastes best if you stir it
,
before you drink it. If you intend to make another cup of SENSEO\
,
coffee later, just leave the coffee machine switched on. The machine automatically switches itself off
after 1 hour. (Fig. 18)
Cleaning
Never immerse the SENSEO\ coffee machine in water.
Never clean the machine by ushing it with the lid open.
1 Always unplug the machine before you clean it.
2 Clean the outside of the machine with a moist
cloth.
3 Remove the coffee spout (Fig. 19).
You can disassemble the coffee spout for more
,
thorough cleaning. (Fig. 20)
Loading...
+ 2 hidden pages