Philips HD2580/26, HD2580/01 User Manual [fa]

Essence HD2580

234

ENGLISH 6

HD2580

á«Hô©dG

Important

- Read these instructions for use carefully before using the appliance and save them for future reference.

- Check if the voltage indicated on the bottom of the appliance corresponds to the voltage in your home before you connect the appliance.

- Connect the appliance to an earthed wall socket.

- Avoid touching the metal parts of the toaster, as they get ver y hot during toasting. Only touch the controls and lift the appliance by its plastic body.

- Do not immerse the appliance or mains cord in water or other liquids.

- Only allow children to operate the toaster under close supervision.

- Never let the toaster operate unattended.

- Unplug the appliance before cleaning. Remove the plug by gripping the plug body and pulling it from the socket. Never yank or twist the cord.

- Do not use the toaster under or near curtains or other flammable materials. Do not operate it under wall cabinets. Bread may burn.

- If a slice of bread gets stuck inside the toaster, unplug the appliance and allow it to cool down before trying to remove the bread. Do not use a knife or a sharp tool, as these may cause damage to the heating elements.

- This appliance is only intended for household use. It is not intended for commercial or industrial use.

- Do not use this appliance when the cord or plug is damaged. If the mains cord of this appliance is damaged, it must always be replaced by Philips or a service centre authorised by Philips, as special tools and/or parts are required.

The appliance is only meant for toasting bread. Do not put any other ingredients in the appliance, as this may lead to a hazardous situation.

Oversized foods, metal foil packages or utensils must not be inserted into the toaster, as this may cause a fire or an electrical shock.

Immediately unplug the toaster if fire is observed.

Before using the toaster for the first time

- Remove any stickers and wipe the body and top of the toaster with a damp cloth.

- Let the toaster first complete one toasting cycle without inserting any bread to burn off any dust that may have accumulated on the heating elements during storing.

ENGLISH6

Toasting bread

1 Put the appliance in a safe place, away from fire hazards such as

curtains, and insert the plug into the wall socket.

After you have inserted the plug, the LEDs will blink quickly from left to right and back until the LED of the third browning level starts to burn continuously to indicate that the toaster has reached its initial setting. If the toaster has not been used for 10 minutes, it will go into sleep mode, which means that all LEDs will go out. You can re-activate the toaster by pressing any button.The LED of the last browning level selected will go on again.

◗ You can adjust the length of the cord by winding part of it round

the brackets in the base of the appliance.

2 Put one or two slices of bread in the toaster.

The type of bread and the state of the bread have no effect on the end result. Frozen, defrosted, fresh or old bread - the toaster's advanced sensor system always guarantees the same result. Note:When you want to toast only one slice of bread, always put it in the front slot of the toaster because of the location of the sensor.

3 Select the desired browning setting.

Select a low setting for lightly toasted bread and a high setting for a dark browning result. Press the £ button once or several times to select a lower setting for lighter toast. Press the ¢ button to choose a higher setting for darker toast. On the control panel the LED of the chosen setting will burn yellow to show the browning level selected.

4 Push the toasting lever down to turn the appliance on.

The toasting lever will only stay down if the appliance has been connected to the mains.

Keep an eye on the toaster while using it.

ENGLISH 7

5 Monitoring the toasting process.

The LED of the browning setting selected stays on and the preheating light blinks red slowly. When the preheating phase has finished, this LED will go out.The first yellow browning LED will start to blink slowly and will continue to do so until the browning level has been reached.The toast pops up when it is ready.

The appliance gets hot during toasting. Do not touch the metal parts.

◗ To remove smaller items, push the toasting lever a little further up

(extra lift).

◗ If bread gets stuck inside the toaster, remove the plug from the

wall socket, let the appliance cool down completely and carefully remove the bread from the toaster. Do not use a knife or another sharp metal tool to do this and do not touch the metal internal parts of the toaster.

6 Adjust the toasting setting during toasting

When the toaster is operating you can press the ¢ button to get darker toast or the £ button to get lighter toast.The LED of the setting selected will burn yellow.

Note: when you adjust to a lower setting for lighter toast, the toast may pop up immediately because the desired browning level has already been reached.

7 Interrupt the toasting process

You can stop the toasting process at any time by pressing the STOP button on top of the toaster.The bread will pop up immediately.

Toasting frozen bread

1 Follow the instructions in the 'Toasting bread' section.

The toaster has an automatic defrosting function, which guarantees that the result is the same whether you use frozen or fresh bread.

Note: frozen bread will take longer to toast than fresh bread.

ENGLISH8

Reheating toasted bread

1 Follow the instructions in the 'Toasting bread' section.

The toaster has an automatic reheating function, which will reheat your toast without making it browner.

Toasting only one side

Perfect for bagels and baguettes.

1 Halve the bagels or baguettes lengthwise and shorten them to

a length of max. 13 cm.

2 Put the bagel halves in the toaster with the sides to be toasted

facing the outside of the toaster.

3 Press the one-side toasting button and set the browning level

according to the instructions given in the 'Toasting bread' section.

Note: the toasting process cannot be adjusted or monitored when the one-side toasting function is used.

The LED for one-side toasting blinks slowly two times and then burns continuously until the toasted bagel or baguette halves pop up.

You have to press the one-side toasting button before every new oneside toasting cycle.

4 Push the toasting lever down to switch the appliance on.

Heating up rolls or croissants

1 Place the warming rack on the toaster.

Turn the warming knob counterclockwise with one hand and place the warming rack with your other hand.

Never put the rolls to be warmed directly on top of the toaster without placing the warming rack to avoid damaging the toaster.

ENGLISH 9

2 Put the rolls or croissants in the centre of the warming rack.

Do not warm more than 2 items at a time.

3 Push the ¬ button and push the toasting lever down

The warming function LED blinks slowly two times and then burns continuously until the toasting lever pops up to indicate that the rolls or croissants are ready.

Note: If you want to heat the rolls or croissants on both sides, turn them after the toaster has switched off and turn the toaster on again by pressing the ¬ button and pushing the toasting lever down.

The warming function must be activated before every new warming cycle.

Sleep mode

◗ If the toaster has not been used for 10 minutes, it will go into

sleep mode, which means that all LEDs will go out.

You can re-activate the toaster by pressing any button.The LED of the last browning level selected will go on again.

Cleaning

1 Remove the plug from the wall socket.

2 Let the appliance cool down.

3 Clean the toaster with a moist cloth.

Never immerse the appliance in water.

4 Remove crumbs from the appliance by sliding the removable

crumb tray out of the toaster.

Do not hold the appliance upside down and do not shake it to remove the crumbs.

◗ After use, you can place the dust cover on top of the toaster.

ENGLISH10

◗ Do not place the dust cover on top of the toaster when the

appliance is switched on or when it is still hot as this could cause damage.

Overheat protection

1 Toaster will switch off when it overheats (at 100cC).

All LEDs on the control panel will go out for 2 seconds, the toasting lever will go up and the toast will pop up.

The first and fifth LEDs will both blink until a temperature of 60cC has been reached inside the toaster.

Then the toaster will reset to the ready mode and return to the last browning setting.You can continue toasting. Follow the instructions in the 'Toasting bread' section.

Timeout protection

1 When the toaster has been toasting for more than 5 minutes

without popping up the bread, the timeout protection will be activated.

All LEDs on the control panel will go on for 2 seconds, the toasting lever will go up and the toast will pop up.

Once the cause of the timeout has been removed and the toaster has cooled down, the toaster will reset to the ready mode and will return to the last browning setting.You can continue toasting. Follow the instructions in the 'Toasting bread' section.

Mains cord replacement

If the mains cord of this appliance is damaged, it must always be replaced by a service centre authorised by Philips, as special tools and/or parts are required.

Information and service

If you need information or if you have a problem, please visit the Philips Web site at www.philips.com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV.

ENGLISH 11

+ 23 hidden pages