Philips HB558AB Service Manual

Combi Solarium

HB558/A HB558/B

Philips Domestic Appliances and Personal Care

Service Manual

TECHNICAL INFORMATION

Input consumption : approx. 2540 W / 230 V / 50 Hz

Lamp couch : 10x TL Cleo Performance 100W-S

Lamp canopy : 6x TL Cleo Performance 100W-S

: 4x TL Cleo Performance 80W-S

: 1x HP400/H (HB558/A)

: 1x HP400/SH (HB558/B)

Starter : 20x S12

: 1x ZG 4,5D

Ballast : 17x 100 W / 230 V

: 6x 80W / 230V

Timer : 1x 30 mins – motor-driven

Radiation area : 174 x 58 cm

Protecting goggles : HB071 – 4822 690 80123

Output UVX36 meter : > 5.6 mW/cm² - couch

: > 5.0 mW/cm² at 20 cm – canopy

: (both values with HP400 on)

SK1

SK3 TCO

S11

L11a

NTC1

C NTC

La11

230 V / 50 Hz

L11cL11b

SK2

Canopy

6 x

100 W

4 x

80 W

1 x

HPA

260 W

10 x

100 W

4 x

3 x

Couch

Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands © Copyright reserved Subject to modification

03/02

HINTS FOR REPAIRS

- Interchange starters, lamps or ballasts to establish whether they are defective.

- If they are not defective, check the internal wiring, especially that connected to the lamp holders.

- The snap-on connections of the wiring can be detached by means of a paperclip.

- Premature blackening of a tube end points to a defective starter or a wiring fault.

- A burned NTC resistor or overheated wiring points to a wiring fault at the connecting block.

- The acrylic sheets can be cleaned with a moist cloth and some washing-up liquid. Avoid the use of alcohol, alcohol-based cleaners, petrol, acetone or abrasives. These substances can cause irreparable damage to the sheets.

CANOPY

HB558/A HB558/B

Replacement of lamps/starters (items 2, 42 and 7)

Loosen the screws (item 25) and remove the end covers (item 12).

Pull the acrylic sheet (item 43) out of the appliance. Now the lamps/starters can be replaced.

Disassembly of gas spring (item 26)

Fold the canopy up and have a second person lock it in this position.

Undo two nuts on either side and take the gas spring out of the hinged parts.

Disassembly of fan (item 20)

Unlock the clamps of the fan cover (item 21). Loosen the connecting wires and pull out the fan unit

(item 20).

Disassembly of timer (item 32)

Remove the end cover on the side where the timer is located.

Pull the top cover on this side out of the groove of the side panel (item 33).

Pull the side panel off the metal frame to create enough room to remove the timer.

Disassembly of hinge (items 27, 28 and 29)

Unlock the clamps of the hinge cover with a screwdriver. Loosen the screw (B). Ask a second person to depress the locks of the bearing

bush (item 29) with two small screwdrivers. Position yourself on the other side of the appliance and

press the couch with your foot while pulling the canopy slightly (approx. 5 mm) towards you to deactivate the lock.

Repeat this procedure at the other hinge. Now you and the other person should position yourselves

at opposite ends of the appliance. Lift the canopy from the stand by pulling at it.

Place the canopy on a soft surface. Remove the lock spring (item 28) Tap the bearing bush off the shaft with a plastic hammer.

Disassembly of facial unit (item 37)

Remove the fan, the end covers and the top cover. Contrary to what is indicated in the exploded view, a

complete reﬂ ector unit with ﬁ lter glass mounted in a metal frame is supplied as item 37.

COUCH

Replacement of lamps and starters (items 2 and 7)

Loosen the screws and remove the end covers (item 12). Pull the acrylic sheet (item 1) out of the appliance. Now the lamps/starters can be replaced.

Disassembly of fan (item 20)

Remove the side panels of the decorative cover (item 13). Put the canopy in its highest position. Turn the appliance on its back with help of a second person. Unlock the clamps of the fan cover (item 21). Loosen the connecting wires and pull out the fan unit

(item 20).

2-7

HB558/A HB558/B

Pos Service code Description

1 9965 000 12136 acrylic sheet couch 2 9280 043 21920 TL Cleo Performance 100 W-S 3 4222 062 94570 connector 4 4222 062 94580 NTC resistor 22 Ω 5 4822 321 11395 mains ﬂ ex

6 4822 146 10344 ballast 100 W 7 4822 219 80258 starter S12 8 9965 000 01933 lamp/starter holder 9 9965 000 01934 lamp holder 10 4822 265 10935 4-p socket

11 9965 000 12134 rear panel couch 12 9965 000 11523 end cover 13 9965 000 12138 set of decorative covers 14 9965 000 12137 leg couch 15 9965 000 02712 push rivet 6 x 9.5

16 4822 690 80123 HB071 protecting goggles 17 4222 062 94600 capacitor 50 µF/250 V 18 9965 000 12133 front panel couch 19 9965 000 12135 bottom cover couch 20 9965 000 11520 fan complete

21 9965 000 11521 fan cover 22 4822 320 11885 connecting cable 23 9965 000 11524 top cover canopy 24 9965 000 12132 rear panel canopy 25 4822 502 14539 s.t. screw 4.8 x 19

Pos Service code Description

26 4822 529 10383 gas spring 27 9965 000 11528 hinge cap 28 9965 000 11525 securing spring 29 9965 000 11526 bearing bush 30 4822 410 11079 timer knob

31 9965 000 01946 switch on/off 32 9965 000 11519 timer 30 mins 33 9965 000 12129 front panel canopy 34 4822 252 20325 aut. cutout 100 °C 35 4822 325 20102 lamp holder

36 4822 134 10088 HPA lamp HP400/H (/A) 9965 000 16185 HPA lamp HP400/SH (/B) 37 9965 000 12130 reﬂ ector/ﬁ lter unit 38 4222 062 94320 fan HPA 39 4822 214 12272 starter HPA 40 4822 271 30619 micro switch

41 4822 146 10792 ballast 80 W 42 9280 032 21920 TL Cleo Performance 80 W-S 43 9965 000 11522 acrylic sheet canopy

9965 000 12131 mounting set

3-7

+ 4 hidden pages