All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
Depart. Technical support- CM640 PROCEDURE COMPANY RESTRICTED
PHILIPS Consumer
Communications
Centre du Mans
Service Repair Support
VY-V-640-P330
Page : 4 of 43
Langue : EN
Date : 11/06/03
1.0 PURPOSE
This document establishes the functional test and inspection procedures for the second level service repair of the
PHILIPS 330 transceiver.
2.0 SCOPE
The test plan is applicable to all levels of service repair of the PHILIPS 330 transceiver.
3.0 REFERENCE
None.
4.0 GLOSSARY / ACRONYM LIST
Window or Bezzel Protective plastic over the LCD display
SW Software
PN Hardware Configuration of the Mobile
CN Matrix for Types of SW used on the different hardware
HW Hardware
ASC Authorized Service Center
NSC National Service Center
Test SIM Card Used for functionality of PHILIPS Mobile Phones
Test SIM Card « SP » SIM Card used to simulate the user interface and enable radio tests
5.0 TEST EQUIPMENT AND TOOLS
Equipment / Tools
- Test SIM Card « Production » - Part No. : 4311 255 00781
- Test SIM Card « SP » - Part No. : 4311 255 00782
- Data Connect Cable - Part No. : 4311 258 10392
- Digital Multimeter - Recommended Model : Fluke (Specification with current reading in mA).
- Specific Screw Driver - Part No. : 4311 255 30131
- Paper Cut tool
- Digital Radiocommunication Tester.
- Coupling system with shielded chamber or - RF Pliers - Part No.: 4311 255 30041
PHILIPS ELECTRONICS N.V. 1999 VY-V-640-P330
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
Depart. Technical support- CM640 PROCEDURE COMPANY RESTRICTED
PHILIPS Consumer
Communications
Centre du Mans
Service Repair Support
VY-V-640-P330
Page : 5 of 43
Langue : EN
Date : 11/06/03
6.0 TEST AND INSPECTION PLAN
The test plan is derived from the Product Test Reference of PHILIPS 330.
6.1 User Interface Test
Use the Test SIM Card to test the transceivers as follows :
• On/Off button
• LCD Backlight
• Keyboard Test
• Side Keys
• Buzzer Test
• Vibrator Test
• Audio Test
• Antenna
• LCD
• IMEI
• Tester Status/Eeprom Status
With a fast Charger connected with the PRODUCT’s bottom connector, check the full scrolling
from one mode to the next when charging IGN (Ignition) – Battery.
6.2 RF Test
The purpose of the radio test is to prove that the tested phone is compliant to the Standard.
The radio test must be performed with a
Digital Radio Test Set. The mobile has to
be set on the antenna coupler inside the
shielded chamber.
Use the Test SIM Card « SP »to test the GSM 900 / DCS 1800 band
Test ( to measure the radiated power level. Not necessary when using an antenna coupler)
PHILIPS ELECTRONICS N.V. 1999 VY-V-640-P330
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
Depart. Technical support- CM640 PROCEDURE COMPANY RESTRICTED
PHILIPS Consumer
Communications
Centre du Mans
Service Repair Support
VY-V-640-P330
Page : 6 of 43
Langue : EN
Date : 11/06/03
7.0 BEFORE STARTING
7.1 Description Of The Transceiver
PHILIPS ELECTRONICS N.V. 1999 VY-V-640-P330
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
Depart. Technical support- CM640 PROCEDURE COMPANY RESTRICTED
PHILIPS Consumer
Communications
Centre du Mans
Service Repair Support
VY-V-640-P330
Page : 7 of 43
Langue : EN
Date : 11/06/03
7.2 Description Of The Display
PHILIPS ELECTRONICS N.V. 1999 VY-V-640-P330
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
Depart. Technical support- CM640 PROCEDURE COMPANY RESTRICTED
PHILIPS Consumer
Communications
Centre du Mans
Service Repair Support
VY-V-640-P330
Page : 8 of 43
Langue : EN
Date : 11/06/03
7.3 Using The Carousel
PHILIPS ELECTRONICS N.V. 1999 VY-V-640-P330
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
Depart. Technical support- CM640 PROCEDURE COMPANY RESTRICTED
PHILIPS Consumer
Communications
Centre du Mans
Service Repair Support
VY-V-640-P330
Page : 9 of 43
Langue : EN
Date : 11/06/03
7.4 Removing the Battery
PHILIPS ELECTRONICS N.V. 1999 VY-V-640-P330
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
Depart. Technical support- CM640 PROCEDURE COMPANY RESTRICTED
PHILIPS Consumer
Communications
Centre du Mans
Service Repair Support
VY-V-640-P330
Page : 10 of 43
Langue : EN
Date : 11/06/03
7.5 Inserting The Sim Card
7.6 Inserting the Battery
PHILIPS ELECTRONICS N.V. 1999 VY-V-640-P330
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
Depart. Technical support- CM640 PROCEDURE COMPANY RESTRICTED
PHILIPS Consumer
Communications
Centre du Mans
Service Repair Support
VY-V-640-P330
Page : 11 of 43
Langue : EN
Date : 11/06/03
7.7 Charging The Battery
Once the battery is clipped on the phone, plug the charger into the right hand socket at the base of the phone as
shown on the drawing.
Then plug the transformer unit into a main AC power
socket with easy access.
The symbol indicates the state of charge :
If the battery is completely flat, the battery icon will only
reappear after 2 or 3 minutes of charging.
During charging the 4 charge indicators change; each
bar represents around 25% of charge and it takes
around 2.15 hours to fully recharge your mobile phone.
Bars moving Battery is charging
Bars steady Battery is fully charged
Battery outline flashing (see troubleshooting chapter)
you can disconnect the charger. Remove the connector by pressing the release button on top of the connector.
PHILIPS ELECTRONICS N.V. 1999 VY-V-640-P330
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
you can disconnect the charger. Remove the connector by pressing the release button on top of the connector.
Depart. Technical support- CM640 PROCEDURE COMPANY RESTRICTED
PHILIPS Consumer
Communications
Centre du Mans
Service Repair Support
VY-V-640-P330
Page : 12 of 43
Langue : EN
Date : 11/06/03
8.0 TEST PROCEDURES
8.1 Initial Functional check for PHILIPS 330
8.1.1 Insert the Test Production Card into the SIM reader at the back of the mobile phone and clip a charged
battery on the phone.
8.1.2 Press the “ON” button for 2 seconds at least and the LCD will show a message, which contains information
of FA (Final Adjustment) status and 12NC.