Philips CRA01-00 User Manual

Loop-Through Card

Installation Guide

Part # CRA01/00

Page 1 of 9 LT Installation Guide 1.1 (140907)

12NC: 3139 125 39281

A. Introduction

CRA01/00 is a Loop-Through (LT) interface card designed to support VGA content connectivity
and RS232 control in daisy chain configurations on select Philips SmartCard-enabled displays.
Please refer to the product leaflet for the detailed feature specifications.

This guide will provide the basic steps for installing the LT card into a Philips SmartCard-enabled
display.

B. Package Contents

Your CRA01/00 package should contain the following:

1 x LT card module
1 x LT card cap (see Fig. 1 below)
1 x VGA cable (30cm/ 11.811”)
1 x RS232 cable (20cm/ 7.874”)
Installation Guide (this document)
Global Warranty Card

Fig. 1 – LT card cap

C. Brief Electrical Specifications

Supply Voltage: 12V +/- 10%
Supply Current: 0.12A (Nominal)
Power Consumption: 1.44 W (Nominal)

Page 2 of 9 LT Installation Guide 1.1 (140907)

12NC: 3139 125 39281

D. Loop-Through Card I/O Interfaces

32-pin connector

2

3

1

6

5

4

Connector Application

1 15-pin D-SUB Female VGA Out (Local)
2 15-pin D-SUB Female (High Rise) VGA In
3 15-pin D-SUB Female (High Rise) VGA Out (External)
4 9-pin D-SUB Male RS232 Out (External)
5 9-pin D-SUB Male RS232 In
6 9-pin D-SUB Female RS232 Out (Local)

E. Installation Instructions

1. Turn off the power to your Philips monitor and disconnect the power cable.

2. Place monitor face-down on a clean, non-abrasive surface.

3. Locate the SmartCard slot opening on the rear of the display. (see Fig. 2 below)

SmartCard Slot Cap

Page 3 of 9 LT Installation Guide 1.1 (140907)

12NC: 3139 125 39281