Philips CAB50 User Manual

www.philips.com/welcome

User manual

CAB50

CAB50_05_UM_V1.0

Congratulations on your purchase, and welcome to Philips! To fully

benet from the support that Philips offers, register your product at

www.philips.com/welcome.

1 Safety

Read and understand all instructions before you use this product. If damage is caused by failure to follow the instructions, the warranty does not apply.

• Risk of injury: Never install the receiver and its accessories on

the airbag cover.

• Risk of overheating: Do not x the DAB radio receiver to the

metal surface of the main unit.

• Risk of electromagnetic interference: Do not install the DAB

radio receiver over any sensors or vents.

• Risk of short circuit, malfunction, or damage to this product:

Do not alter the cable of DAB radio receiver or dismantle the

receiver box.

• Risk of damage to the DAB radio receiver: Never pull its cable

when you remove the receiver.

2 Install the DAB radio receiver

Note

• No DAB radio antenna is bundled. Consult your local retailer to

purchase it.

• Make sure that no lead other than the DAB radio antenna contacts

the antenna connector of the DAB radio receiver.

1 Connect the DAB radio receiver to the main unit. 2 Connect a DAB radio antenna to the DAB radio receiver. 3 Secure the DAB radio receiver to your car.

3 Product information

Note

• Specications are subject to change without prior notice.

Power supply 12 V DC (11 V - 16 V), negative

Frequency range 174.928 - 239.200 MHz

Usable sensitivity (EN50248) < -95 dbm

Dimensions (W X H X D) 98 X 23 X 57 mm

ground

4 Notice

Any changes or modications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the

user’s authority to operate the equipment.

Care of the environment

Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.

When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/EC. Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health.

Environmental information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard

(box), polystyrene foam (buffer) and polyethylene (bags, protective

foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local

regulations regarding the disposal of packaging materials, exhausted

batteries and old equipment.

Specications are subject to change without notice. Trademarks

are the property of Koninklijke Philips Electronics N.V or their respective owners. Philips reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly.