Always there to help you
Question?
Contact
Philips
Register your product and get support at
www.philips.com/support
BT4000
User manual
Contents
1 Important 2
2 Your Bluetooth speaker 3
Introduction 3
What's in the box 3
Overview of the speaker 4
3 Get started 5
Connect power 5
Turn on 5
Turn off 5
4 Use Bluetooth devices 6
Connect a device 6
Play from Bluetooth device 7
Control your phone call 7
Disconnect the Bluetooth-enabled device 7
Connect another Bluetooth-enabled
device 7
Reconnect the Bluetooth device 7
5 Other features 8
Listen to an external device 8
Charge your mobile devices 8
Adjust volume 8
6 Product information 9
Specications 9
7 Troubleshooting 10
General 10
About Bluetooth device 10
8 Notice 11
Compliance 11
Care of the environment 11
Trademark notice 11
1EN
1 Important
Warning
• Never remove the casing of this speaker.
• Never lubricate any part of this speaker.
• Never place this speaker on other electrical equipment.
• Keep this speaker away from direct sunlight, naked
amesorheat.
• Make sure that you always have easy access to the
power cord, plug, or adaptor to disconnect the speaker
from the power.
• Make sure that there is enough free space
around the speaker for ventilation.
• Use only power supplies listed in the user
manual.
• The speaker shall not be exposed to
dripping or splashing.
• Do not place any sources of danger on
thespeaker(e.g.liquidlledobjects,lighted
candles).
• Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
Note
• The type plate is located on the bottom of the product.
2 EN
2 Your Bluetooth
speaker
Congratulations on your purchase, and
welcometoPhilips!Tofullybenetfromthe
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With this speaker, you can
• enjoy audio from your Bluetooth-enabled
devices, or other external audio devices;
and
• charge your mobile devices.
What's in the box
Check and identify the contents of your
package:
• Speaker
• Power adapter
• Short user manual
• Safetyandnoticeleaet
3EN
Overview of the speaker
g
c
b
a
a
• Turn the speaker on or off.
b +/-
• Adjust volume.
c /PAIRING
• Answer or reject an incoming call.
• End the current phone call.
• Disconnect Bluetooth connection.
• Enter Bluetooth pairing mode.
d NFC
• Connect a device with NFC feature
through Bluetooth.
e AUDIO IN
• Connect an external audio device.
f CHARGING 5V 1A
• Charge your mobile devices.
g DC IN
• Connect power.
d
e
f
4 EN
3 Get started
Turn off
Always follow the instructions in this chapter in
sequence.
Connect power
Caution
• Risk of product damage! Make sure that the power
voltage corresponds to the voltage printed on the back
or underside of the speaker.
Connect the power adapter to:
• the DC IN socket on the speaker.
• the wall outlet.
DC IN
The speaker is turned off in the following
situations:
• Press again; or
• The Bluetooth connection is
disconnected and no audio-in cable is
connected for 15 minutes.
» The LED indicator turns off.
Turn on
Press to turn on the speaker.
» The speaker switches to Bluetooth
mode automatically.
» TheLEDindicatorashesblue.
5EN
4 Use Bluetooth
devices
With this speaker, you can listen to audio from
Bluetooth-enabled devices and control the
incoming call through Bluetooth.
Connect a device
Note
• Make sure that your Bluetooth device is compatible
with this speaker.
• Before pairing a device with this speaker, read its user
manual for Bluetooth compatibility.
• The speaker can memorize a maximum of 4 paired
devices.
• Make sure that Bluetooth function is enabled on your
device, and your device is set as visible to all other
Bluetooth devices.
• Any obstacle between this speaker and a Bluetooth
device can reduce the operational range.
• Keep away from any other electronic device that may
cause interference.
Option 1: Connect a device through NFC
Near Field Communication (NFC) is a
technology that enables short-range wireless
communication between various NFC
compatible devices, such as mobile phones and
IC tags.
If your Bluetooth device supports NFC, you can
connect it with this speaker easily.
1 On your device, enable NFC and
Bluetooth functions (refer to the user
manual of the device).
2 Press on this speaker.
» TheLEDindicatorashesblue.
3 Touch the NFC tag on the top of the
speaker with the NFC area of your
Bluetooth device.
4 Follow the on-screen instructions to
complete the pairing and connection.
» After successful connection, the
speaker beeps twice, and the LED
indicator turns solid blue.
Option 2: Connect a device manually
Note
• The operational range between this speaker and a
Bluetooth device is approximately 10 meters (30 feet).
1 Press .
» TheLEDindicatorashesblue.
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth devices
that can be paired (see the user manual of
the device).
3 When [Philips BT4000] is displayed on
your device, select it to start pairing and
connection. If necessary, input “0000” as
the pairing password.
» After successful pairing and connection,
the speaker beeps twice, and the LED
indicator turns solid blue.
• Ifyoufailtond[Philips BT4000] on
your device for pairing, press and hold
PAIRING until you hear beep sound,
and then try again.
LED indicator Description
Flashing blue Connecting;
Waiting for pairing
Solid blue Connected
6 EN
Play from Bluetooth devices
Note
• If there is an incoming call on the connected mobile
phone, music play pauses.
After successful Bluetooth connection, play
audio on the Bluetooth device.
» Audio streams from your Bluetooth
device to the speaker.
Connect another Bluetoothenabled device
1 Press and hold PAIRING for two seconds
to disconnect the currently connected
device;
» The speaker enters Bluetooth pairing
mode.
2 Connect another Bluetooth device.
Control your phone call
After Bluetooth connection, you can control an
incoming call with this speaker.
Button Function
Press to answer an incoming call.
Press and hold for two seconds to
reject an incoming call.
During a call, press to end the current
call.
Note
• Music play pauses when there is an incoming call.
Disconnect the Bluetoothenabled device
• Press and hold PAIRING for two seconds;
• Disable Bluetooth on your device; or
• Move the device beyond the
communication range.
» TheLEDindicatorashes.
Reconnect the Bluetooth device
• Next time you turn on the speaker, the
speaker will reconnect the last connected
device automatically; or
• On your Bluetooth device, select "PHILIPS
BT4000" on your Bluetooth menu to start
connection.
7EN
5 Other features
Listen to an external device
With this speaker, you can also listen to an
external audio device such as an MP3 player.
Note
• Make sure that there is no Bluetooth connection, or
music playback through Bluetooth is paused.
1 Connect an audio input cable (not
supplied) with a 3.5 mm connector on
both ends to
• the AUDIO IN socket on this speaker,
and
• the headphone socket on the external
device.
» The speaker switches to audio-in
mode automatically.
2 Play audio on the external device (refer to
its user manual).
Charge your mobile devices
You can charge your mobile devices through
the USB socket.
Note
• The USB socket is for charging only.
1 Connect this speaker to AC power.
2 Connect this speaker to your mobile
device with a USB cable (not supplied).
» Once the device is recognized, the
charging starts.
CHARGING
AUDIO IN
8 EN
Adjust volume
During play, press + or - repeatedly to increase
or decrease the volume level.
Tip
• To increase or decrease volume continuously, press and
hold + or - for 2 seconds.
• When the volume reaches the maximum or minimum,
theLEDindicatorashestwice.
6 Product
information
Note
• Product information is subject to change without prior
notice.
Specications
Amplier
Rated Output Power 2 X 10 W RMS
Frequency Response 80 -16000 Hz, ±3 dB
Signal to Noise Ratio >67 dBA
Audio-in Input 600 mV RMS 20
kohm
Bluetooth
Bluetooth Version V3.0
SupportedProles HFP, A2DP, AVRCP
Bluetooth Frequency
Brand
Bluetooth Range 10 m (Free space)
2.4 GHz ~ 2.48 GHz
General information
AC Power
(Power
Adapter)
Operation
Power
Consumption
Dimensions Main Unit
(W x H x D)
Weight Main Unit 1.7 kg
Brand name: PHILIPS;
Model: AS360-120-AE250;
Input: 100-240 V~, 50/60 Hz,
1.2 A
Output: 12 V 2.5 A;
12.5 W (with 1A charging
loader)
300 x 163 x 96 mm
Speakers
Speaker Impedance 8 ohm
Speaker Driver 7cm full range
Sensitivity >84dB/m/W ±
3dB/m/W
9EN
7 Troubleshooting
About Bluetooth device
Warning
• Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
General
No power
• Make sure that the AC power plug of the
unit is connected properly.
• Make sure that there is power at the AC
outlet.
No sound or poor sound
• Adjust volume on the product.
• Adjust volume on the connected device.
No response from the speaker
• Restart the speaker.
The LED indicator ashes blue for 5 times,
and the speaker has no response when
pressing any key.
• The speaker is in DEMO mode. Press and
hold for 15 seconds to exit this mode.
Cannot charge mobile devices
• Make sure that AC power is connected
properly.
• Make sure that there is power at the AC
outlet.
The audio quality is poor after connection
with a Bluetooth-enabled device.
• The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
Cannot connect with the device.
• The Bluetooth function of the device is not
enabled. Refer to the user manual of the
device for how to enable the function.
• This product is already connected with
another Bluetooth-enabled device.
Disconnect that device and then try again.
The paired device connects and disconnects
constantly.
• The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
• For some devices, Bluetooth connection
may be deactivated automatically as a
power-saving feature. This does not indicate
any malfunction of this product.
10 EN
8 Notice
Anychangesormodicationsmadetothis
device that are not expressly approved by
Gibson Innovations may void the user’s
authority to operate the equipment.
Compliance
Hereby, Gibson Innovations declares that this
product is in compliance with the essential
requirements and other relevant provisions
ofDirective1999/5/EC.Youcanndthe
Declaration of Conformity on www.philips.com/
support.
Care of the environment
Recycling
disposal of your old product helps prevent
potentially negative consequences on the
environment and human health.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
Trademark notice
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by Gibson
is under license. Other trademarks and trade
names are those of their respective owners.
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
When you see the crossed-out wheel bin
symbol attached to a product, it means the
product is covered by the European Directive
2002/96/EC:
Never dispose of your product with other
household waste. Please inform yourself about
the local rules on the separate collection of
electrical and electronic products. The correct
The N Mark is a trademark or registered
trademark of NFC Forum, Inc. in the United
States and in other countries.
11EN
Specifications are subject to change without notice.
2015 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is sold under the responsibility of Gibson
Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
and are used under license from Koninklijke Philips N.V.
BT4000_12_UM_V3.0
Loading...