Philips BT3200 User Manual
Trimming with the unique ‘stubble look’ setting
1 To create a ‘stubble look’, trim with the beard
trimming comb set to setting 1 (Fig. 6).
Trimming without comb
Use the trimmer without beard trimming comb to trim
full beards and single hairs.
Be careful when you trim without comb because the
cutting element removes every hair it touches.
1
Pull the beard trimming comb off the appliance (Fig. 7).
2 Switch on the appliance.
3 Make well-controlled movements. Touch the hair
lightly with the trimmer (Fig. 8).
Cleaning
Never use scouring pads, abrasive cleaning agents or
aggressive liquids such as alcohol, petrol or acetone to
clean the appliance.
1 Make sure the appliance is switched off and
disconnected from the mains.
2 Wipe the housing of the appliance with a dry cloth.
Never immerse the appliance in water or rinse it under
the tap.
3 Remove the trimming comb and clean it with
the brush.
4
Remove the cutting unit by pushing against the teeth
of the cutting unit. Clean it with the brush (Fig. 9).
5 To reattach the cutting unit, insert the lug of the
cutting unit into the guiding slot. Push the cutting
unit back onto the appliance (‘click’) (Fig. 10).
Replacement
Only replace a worn or damaged cutting unit with an
original Philips cutting unit, available from authorised
Philips service centres.
1 Remove the old cutting unit by pushing against the
teeth of the cutting unit (Fig. 9).
2 Insert the lug of the new cutting unit into the
guiding slot (Fig. 10).
3
Push the cutting unit back onto the appliance (‘click’)
(Fig. 11).
Environment
- Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in
at an ofcial collection point for recycling. By doing
this, you help to preserve the environment (Fig. 12).
Guarantee and support
If you need service or suppor t, please visit
www.philips.com/support or read the
separate worldwide guarantee leaet.
11
1
Register your product and get support at
www.philips.com/welcome
BT3200
2
5
8
3
6
9
12
4
7
10
4222.002.8472.1
4222_002_8472_1_LF_A7_4x2_222x210_12pag_v1.indd 1 5/8/14 11:19 AM
ENGLISH
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benet from the support that Philips offers,
register your product at www.philips.com/welcome.
General description (Fig. 1)
1 Trimming comb
2 Cutting unit
3 Precision Zoom Lock™ adjustment ring
4 On/off slide
5 Socket for appliance plug
6 Brush
7 Appliance plug
8 Adapter with charging light
Important
Read this user manual carefully before you use the
appliance and save it for future reference.
Danger
- Keep the appliance and the adapter dry (Fig. 2).
Warning
- The adapter contains a transformer. Do not cut
off the adapter to replace it with another plug,
as this causes a hazardous situation.
- This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
- Children should be supervised to ensure that they
do not play with the appliance.
Caution
- This appliance is not washable. Never immerse the
appliance in water, nor rinse it under the tap. (Fig. 2)
-
Always check the appliance before you use it.
Do not use the appliance, adapter or any other
part if it is damaged, as this may cause injury.
Always replace a damaged adapter or part with
one of the original type.
- Never use compressed air, scouring pads, abrasive
cleaning agents or aggressive liquids such as petrol
or acetone to clean the appliance.
Electromagnetic elds (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic elds.
General
- The adapter is equipped with an automatic voltage
selector and is suitable for mains voltages ranging
from 100 to 240 volts.
- The adapter transforms 100-240 volts to a safe low
voltage of less than 24 volts.
- Maximum noise level: Lc = 75dB(A)
Using the appliance
Note: The appliance is not rechargeable and can only be
used from the mains.
Always comb the beard and/or moustache with a ne
comb before you start trimming.
When you trim for the rst time, be careful. Do not
move the trimmer too fast. Make smooth and gentle
movements.
Trimming with comb
1 Turn the Precision Zoom Lock™ adjustment ring
to the desired setting. The selected setting is the
setting in the centre of the adjustment ring. (Fig. 3)
See the table below for an overview of the settings and
the resulting hair lengths.
Setting Resulting
1 1 mm 6 6mm
2 2 mm 7 7mm
3 3 mm 8 8mm
4 4 mm 9 9mm
5 5 mm 10 10mm
Note: When you trim for the rst time, start at the highest
setting (10) to familiarise yourself with the appliance.
2 Put the appliance plug in the appliance and put the
adapter in the wall socket.
3 Press the on/off slide upwards to switch on the
appliance.
4 To trim most effectively, move the trimmer against
the hair growth direction. Make sure the surface of
the comb always stays in contact with the skin (Fig. 4).
5
If a lot of hair has accumulated in the beard trimming
comb, remove the comb and blow and/or shake the
hair out of it. The selected setting does not change
when you do this (Fig. 5).
hair length
Setting Resulting
hair length
11
1
2
5
8
3
6
9
4
7
10
12
4222_002_8472_1_LF_A7_4x2_222x210_12pag_v1.indd 2 5/8/14 11:19 AM
Loading...