Philips BT2000R/37, BT2000B/37, BT2000A/37 User manual

Always there to help you

Question?

Contact

Philips

Register your product and get support at

www.philips.com/support

BT2000

User manual

Contents

1 Important 2

Important safety instructions 2

2 Your Bluetooth speaker 3

Introduction 3
What's in the box 3
Overview of the speaker 4

3 Get started 5

Attach the string 5
Charge the built-in battery 5
Turn on/off 5

4 Play 6

Play from Bluetooth devices 6
Play from external devices 6
Fold or unfold the speaker 7
Adjust volume 7

5 Product information 8

Specications 8

6 Troubleshooting 9

General 9
About Bluetooth device 9

7 Notice 10

Care of the environment 10
Trademark notice 11

1EN

1 Important

Warning

• Never remove the casing of this speaker.

• Never lubricate any part of this speaker.

• Never place this speaker on other electrical equipment.

• Keep this speaker away from direct sunlight, naked

amesorheat.

Important safety instructions

a Read these instructions.
b Keep these instructions.
c Heed all warnings.
d Follow all instructions.
e Do not use this apparatus near water.
f Clean only with dry cloth.
g Do not block any ventilation openings.

Install in accordance with the
manufacturer's instructions.

h Do not install near any heat sources such

as radiators, heat registers, stoves, or

other apparatus (including ampliers) that

produce heat.

i Only use attachments/accessories

specied by the manufacturer.

j Refer all servicing to qualied service

personnel. Servicing is required when
the apparatus has been damaged in any
way, such as liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.

k Battery shall not be exposed to excessive

heat such as sunshine, re or the like.

l Apparatus shall not be exposed to

dripping or splashing.

m Do not place any sources of danger on

the apparatus (e.g. liquid lled objects,
lighted candles).

Note

• The type plate is located on the bottom of the

apparatus.

2 EN

2 Your Bluetooth

speaker

Congratulations on your purchase, and

welcometoPhilips!Tofullybenetfromthe

support that Philips offers, register your product
at www.philips.com/welcome.

Introduction

With this speaker, you can enjoy audio from
your Bluetooth-enabled devices, or other
external audio devices.

What's in the box

Check and identify the contents of your
package:

• Speaker

• USB cable for charging

• String for carrying

• User manual

3EN

Overview of the speaker

a

e

b

c

a DC IN

• Recharge the built-in battery with a
USB cable.

b AUDIO IN

• Connect an external audio device.

c LED indicator
d OFF/AUDIO IN/

• Select Bluetooth or AUDIO IN source.

• Turn the speaker off.

e PAIRING

• Disconnect Bluetooth connection.

• Enter Bluetooth pairing mode.

d

4 EN

3 Get started

Charging indicator status

The LED indicator indicates the battery status.

Always follow the instructions in this chapter in
sequence.

Attach the string

For easy carrying, attach the supplied string to
this speaker as illustrated.

Charge the built-in battery

The speaker is powered by a built-in
rechargeable battery.

Note

• Before use, fully charge the built-in battery.

• The micro USB socket is for charging only.

• Rechargeable battery has a limited number of charge

cycles. Battery life and number of charge cycles vary by
use and settings.

"OFF"
mode

"AUDIO
IN" mode

"Bluetooth"
mode

Under
charging

Flashing white Off

Flashing white Solid white

Flashing blue
or solid blue
(depending
on Bluetooth
connection
status)

Fully charged

Flashing blue
or solid blue
(depending
on Bluetooth
connection
status)

Turn on/off

• To turn the speaker on, slide the

OFF/AUDIO IN/ switch to or AUDIO
IN.

• : Listen to an external Bluetooth
device through Bluetooth connection.

• AUDIO IN: Listen to an external
device through an audio input cable.

• To turn the speaker off, slide the switch to
OFF.

Connect the supplied USB cable between

• the DC IN socket on the speaker, and

• a USB socket of a computer.

DC IN

5EN

4 Play

Play from Bluetooth devices

With this speaker, you can listen to audio from
Bluetooth-enabled devices.

Play from Bluetooth devices

Note

• Make sure that your Bluetooth device is compatible

with this speaker.

• Before pairing a device with this speaker, read its user

manual for Bluetooth compatibility.

• The speaker can memorize a maximum of 4 paired

devices.

• Make sure that Bluetooth function is enabled on your

device, and your device is set as visible to all other
Bluetooth devices.

• Any obstacle between this speaker and a Bluetooth

device can reduce the operational range.

• Keep away from any other electronic device that may

cause interference.

• The operational range between this speaker and a

Bluetooth device is approximately 10 meters (30 feet).

To disconnect the Bluetooth-enabled device:

• Press and hold PAIRING for two seconds;

• Disable Bluetooth on your device; or

• Move the device beyond the
communication range.

» TheLEDindicatorashesblue.

To reconnect the Bluetooth device:

• Next time you turn on the speaker, the
speaker will reconnect the last connected
device automatically; or

• On your Bluetooth device, select "Philips
BT2000" on your Bluetooth menu to start
connection.

To connect another Bluetooth-enabled device:

1 Press and hold PAIRING for two seconds

to disconnect the currently connected
device;

» The speaker enters Bluetooth pairing

mode.

2 Connect another Bluetooth device.

LED indicator Description

Flashing blue Connecting;

Waiting for pairing

Solid blue Connected

1 Slide the OFF /AUDIO IN/ switch to .

» TheLEDindicatorashesblue.

2 On your Bluetooth device, enable

Bluetooth and search for Bluetooth devices
that can be paired (refer to the user
manual of the device).

3 When [Philips BT2000] is displayed on

your device, select it to start pairing and
connection. If necessary, input “0000” as
the pairing password.

» After successful connection, the

speaker beeps twice, and the LED
indicator turns solid blue.

4 Play audio on the Bluetooth device.

» Audio streams from your Bluetooth

device to the speaker.

6 EN

Play from external devices

With this speaker, you can also listen to an
external audio device such as an MP3 player.

1 Connect an audio input cable (not

supplied) with a 3.5 mm connector on
both ends to

• the AUDIO IN socket on this speaker,

and

• the headphone socket on the external

device.

AUDIO-IN

2 Slide the OFF /AUDIO IN/ switch to

AUDIO IN.

» The LED indicator becomes white.

3 Play audio on the external device (refer to

its user manual).

Fold or unfold the speaker

• To achieve better bass effect, unfold the
speaker as illustrated.

• To make the speaker smaller, fold the
speaker.

Adjust volume

During play, use the volume control on your
Bluetooth or external device to adjust volume.

7EN

5 Product

information

Note

• Product information is subject to change without prior

notice.

Specications

Amplier

Rated Output Power 2 W RMS
Frequency Response 80 -16000 Hz,

±3 dB
Signal to Noise Ratio >70 dBA
Audio-in Input 300mV RMS

Speaker

Speaker Impedance 4 ohm
Speaker Driver 4.5 cm full range
Sensitivity >81dB/m/W±3dB/m/W

General information

Power Supply (through
USB socket)

Built-in Battery Li-polymer battery

Dimensions - Main
Unit (W x H x D)

Weight - Main Unit 0.15 kg

5 V 0.5 A

(3.7 V, 500 mAh)

99 x 77 x 93 mm

Bluetooth

Bluetooth Version V3.0
BluetoothProle A2DP, AVRCP
Bluetooth Frequency

Brand
Bluetooth Range 10 m (Free space)

8 EN

2.4 GHz ~ 2.48 GHz

6 Troubleshooting

Warning

• Never remove the casing of this device.

To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.

General

No power

• Recharge your speaker.

No sound or poor sound

• Adjust volume on the connected device.

No response from the speaker

• Restart the speaker.

The paired device connects and disconnects
constantly.

• The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.

• For some devices, Bluetooth connection
may be deactivated automatically as a
power-saving feature. This does not indicate
any malfunction of this product.

About Bluetooth device

The audio quality is poor after connection
with a Bluetooth-enabled device.

• The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.

Fail to nd [Philips BT2000] on your device

for pairing.

• Press and hold PAIRING for three seconds,
and then try again.

Cannot connect with the device.

• The Bluetooth function of the device is not
enabled. Refer to the user manual of the
device for how to enable the function.

• This product is already connected with
another Bluetooth-enabled device.
Disconnect that device and then try again.

9EN

7 Notice

Anychangesormodicationsmadetothis

device that are not expressly approved by
WOOX Innovations may void the user’s
authority to operate the equipment.

Notice for the USA and Canada

This device complies with Part 15 of the FCC
Rules and license-exempt RSS standard of
Industry Canada. Operation is subject to the
following two conditions:

1 this device may not cause harmful

interference, and

2 this device must accept any interference

received, including interference that may
cause undesired operation.

This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance
with the instruction manual, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:

• Relocate the receiving antenna.

• Increase the separation between
equipment and receiver.

• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.

• Consult the dealer or an experienced
radio/TV technician for help.

RF Radiation Exposure Statement: This
equipment complies with FCC’s and IC’s RF
radiation exposure limits set forth for an
uncontrolled environment. The antenna(s)
used for this transmitter must be installed and
operated to provide a separation distance of
at least 20 cm from all persons and must not
be collocated or operating in conjunction with
any other antenna or transmitter. Installers must
ensure that 20cm separation distance will be
maintained between the device (excluding its
handset) and users.

CAN ICES-3(B)/NMB-3(B)

Care of the environment

Disposal of your old product and battery

Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
This product may contain lead and mercury.
Disposal of these materials may be regulated
due to environmental considerations. For
disposal or recycling information, please contact
your local authorities or visit www.recycle.
philips.com.
This product contains non-removable batteries:

• Do not incinerate. Batteries may explode if
overheated.

• For disposal or recycling information,
please contact your local authorities or visit
www.recycle.philips.com.

Caution

• Removal of the built-in battery invalidates the warranty

and may destroy the product.

10 EN

Always bring your product to a professional to
remove the built-in battery.

Environmental information

All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.

Trademark notice

The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by WOOX
Innovations is under license.

11EN

Specications are subject to change without notice.

2015 © WOOX Innovations Limited. All rights reserved.
This product was brought to the market by WOOX Innovations Limited or one of its affiliates,
further referred to in this document as WOOX Innovations, and is the manufacturer of the product.
P&F is the warrantor in relation to the product with which this booklet was packaged.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.

BT2000_37_UM_V1.0