Portable Speaker
BT112
General information
Warnings
• Only use attachments or accessories specied by manufacturer.
• The battery shall not be exposed to excessive heat such as sunshine, re etc.
• Only for indoor use.
Care and safety information
Avoid high temperatures, moisture, water and dust
• Apparatus should not be exposed to dripping or splashing of liquid.
• Do not place any source of danger on the speaker (e.g. liquid lled objects lighted candles).
• Do not install near heat sources.
Do not block any ventilation opening
•
Place the apparatus in a location with adequate ventilation to prevent internal heat build up. Allow at
least 10cm (4 inches) of free space all around the apparatus for adequate ventilation.
Care of the cabinet
• Use a soft cloth slightly moistened to clean the cabinet.
Do not use a solution containing alcohol, spirits, ammonia or abrasives.
•
Accessories
Item 3.5mm to stereo cable User manual USB cable
Quantity 1 1 1
2
Buttons & LED lights
3
Buttons & LED lights
A. Switch operation
Audio
B. LED
5. blue LED: bluetooth mode; green LED: Audio in mode.
6. Orange LED: charging.
C. Back panel
7. Audio in: 3.5mm Audio in socket.
8. Micro USB: power in socket for charging from 5V DC, 1A source only.
* In case of laptop BT connection, this will work with windows media player.
4
Over view of the speaker
Get started
5
Bluetooth pairing
unit
PHILIPS BT112
, when enter pairing mode it will give out a “Beep” sound while
double
Audio in
Audio in socket of speaker
Insert stereo cable to enter audio in mode. Without stereo cable, speaker cannot go into audio in mode.
Charging
Connetc one side of the micro USB charging cable with the speaker, the other side connected with computer
or a standard charger with 5V 1A for charging.
The speaker inside install over-charging protective circuit, which can be connected to computer or charger for long time,
charging time is 3-4 hours. Working time will depend on the volume user sets up.
Handfree phone call function
Low power
6
Troubleshooting
Warning -
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty.
below before taking the system for repair. If you are unable to remedy the problem by following hints
mentioned in below table, Consult your dealer or PHILIPS APSC for help.
Problem Solution
1. No power.
2. No sound or distorted sound.
3. Low hum or buzz sound.
4. No response from the speaker.
5. The audio quality is poor after
connection with Bluetooth enabled
device.
6. Cannot connect with the device.
Charge the unit by using USB charging cable.
Adjust the volume / select the correct source to choose the equipment
that you want to hear through the system.
Place the product as far away as possible from electrical devices that may be
causing interference.
Restart the speaker.
Move the device closer to this product or remove obstacle between them.
This product is already connected with another Bluetooth enabled device.
Disconnect that device and then try again.
* In case these measures do not work contact the nearest PHILIPS service center or call at customer care numbers.
7
Warranty
This Philips Portable Speaker is warranted against any defect due to defective materials or
workmanship for 12 months from the date of purchase, should a defect develop during the period of warranty,
Gibson Innovations India Private Limited undertake to repair the apparatus FREE OF CHARGE through the dealer
from whom it has been purchased or at any of the Philips Authorised Service Centres.
The warranty is not valid in case :
1. Proof of purchase is not accompanied with this warranty card.
2. The warranty card is not completed immediately after purchase.
3. The apparatus is not used according to this manual.
4. Defects are caused by improper or reckless use.
5. Any repairs are done by persons other than Philips Authorised service centre.
6. Any modications or alteration of any nature are made in the apparatus.
7. The serial number is tampered with.
8. Defects due to causes beyond control like lightning, abnormal voltage, acts of God or while in
transit to the purchaser’s residence.
All consumables and parts susceptible to normal wear and tear are not covered under warranty.
Week/S.No.: Bill No.
Date of purchase
Dealer’s name:
Dealers stamp:
___________________________________________________________
___________________________________________________________
___________________________________________________________
__________________________________________________________
___________________________________________________________
Customer’s name and address:
Model No.:
Dealer’s signature:
Gibson Innovations India Private Limited 4th Floor, Block-1, Vatika Business Park, Sector 49, Sohna Road,
Gurgaon-122018, Haryana, India
_____________________________________________________________
________________________________________________________
_____________________________________________
8
Product specications*
Amplier
10W RMSRated output power
Signal to Noise Ratio
Audio input
Frequency Response
>50dB
600MV
70Hz~20KHz
Speaker
Speaker Impedance 4 ohm Connectivity Audio in, Bluetooth
Speaker Driver 1.75 inch/4.5cm
Sensitivity
80 dBm
Bluetooth
Bluetooth version
Bluetooth prole
Bluetooth freg
Bluetooth range
The Philips trademark and Philips shield emblem are
registered trademarks of koninklijke Philips N.V. used
under license.
This product has been manufactured by and sold
under the responsibility of Gibson Innovation India
Private Ltd. and Gibson Innovations India private Ltd.
is the warrantor in relation to this product.
V4.0
V2.1+EDR
2.4GHz~2.48GHz
Upto 10M(freespace)
General Introduction
Power supply
Built in Battery
Dimension main unit(LxWxH)
Weight
Question?
Contact
Philips
5V 1A
Li-polymer battery
56x75x178.5mm
369g
www.india.philips.com
Or customercare.india@philips.com
Loading...