Page 1
Software check and upgrade
Preparation to upgrade software
1)Start the USB burning software & create a folder named "UPG_ALL" B. Read out the software versions to confirm upgrading
2)Then copy the Bin file (BDP_5200.bin )into it,
3)Burn the data onto the blank USB. 1) Power on the set and open the tray door.
4)If the model is BDP5200,must use (BDP_5200.bin )to upgrade 2) Press <Home> button on the reomote control.
A. Procedure for software upgrade 3) Select <Setup>, then press <OK>.
A) Upgrade software via Disc 4) Select <Advanced Setup>, press right cursor to choose
1) Power on the set and insert the prepared Upgrade <Version Info.>, then press <OK>, the software version
CDR. and other information will display on the TV screen as below:
2) The set will starts reading disc & response with the Model:BDP5XXX/XX
following display TV screen: Versions:
Now searching for upgrade software!
Please wait…! http://www.philips.com/support
3)Wait for a few seconds after the screen will display :
Upgrade software for this player have been found.Do you want to upgrade?
Cancel Start
4) Press Right cursor button to choose "Start", then press <OK>;
5) The software will updagrde and screen will display as below:
Upgrade is ongoing, Please wait…
Please do not unplug or switch off the device.
6) The screen will display as below when upgrading complete:
Upgrade has completed successfully!
Power off after 5s.
Restart now
5) Restart the set.
MAC:XX-XX-XX-XX-XX-XX
Caution: The set must not be power off during
upgrading, otherwise the Main board will be
damaged entirely.
B) Upgrade softwar via network:
1) Setup the network connection (See "Getting started">"Set up
network").
2) In the Home menu, select <Setting>-<Advanced Setup> <Software Download>-<Network>.
* You are prompted to start upgrading processes if upgrade
media is detected.
3) Follow the instructions on the TV screen to confirm update
operation.
* Once software updated is complete, this player automatically
truns off to standby.
4) Disconnect the power cord for a few seconds and connect again
to turn on the player.
C) Update software via USB Flash Drive:
1) Go to www.philips.com/support to check if the latest software
version is available for this player.
2) Download the software onto a USB flash drive.
3) Insert the USB flash drive to the USB jack of the rear panel.
4) In the Home menu, select <Setup>-<Advanced Setup>-<Software Updade
>-<USB>.
5) Follow the instructions on the TV screen to confrim update operation.
* Once software update is complete, this player automatically turns to
standby.
6) Disconnect the power cord for a few seconds and connect again to
turn on the player.
Loading...