Page 1
Overview
The following document intends to familiarize one with the use of features
in our Smart Classrooms via the Philips Remote Control. The remote itself
allows for full control of all devices installed in the room.
General Operations Using the Pronto Remote
Press on the HELP icon
for support information.
Contrast controls for the
touch screen display.
Philips Remote User Guide
Bailey 146
Master MUTE button.
Press on the BLK SCR
icon to have the projector project a black
image.
Backlight initiate button.
Press on the VCR icon to
get to the VCR controls.
Press on the LAPTOP
icon to send the laptop
desktop to the projector.
Master VOLUME contorls.
Press on the PRE-
SENTER icon to display documents from
the document camera
on the projector
Press on the AUX icon
to display auxiliary AV
inputs on the projector.
Press on the MASTER SHUT
DOWN icon and hold it for at
least 6 seconds to turn every
equipment off.
ANY TROUBLE USING THE PRONTO PLEASE REFER TO THE NEXT PAGE
Page 2
Starting up Troubleshooting
Blank Screen !
The Pronto screen will be blank when picked up from
the charger base.
To initiate the Pronto just Touch anywhere on the
touch screen as indicated.
Where is the main page!
Just press on the icon that resembles a house at
the top left hand corner of any equipment menu
page. Should a display other than the main page
appear.
No Display!
If display is dark or do not appear check contrast
dial before calling for. There is a contrast dial on
the right side of the Pronto receiver that is similar
to a volume control dial on a walkman.
*IF THE EQUIPMENT APPEARS NON RESPONSIVE...
AIM PRONTO REMOTE AT THE IR SENSOR ON THE
BACKSPLASH.
Page 3
Displaying an Auxiliary Video Source
Step 1
Connect the AUX video
source to the terminals
labeled AUX VIDEO on the
backsplash.
Step 2
Press the AUX VIDEO icon
on the main page.
Step 3
STEP 2
Press the Show icon to
display the video source
through the projector.
STEP 3
STEP 2
Displaying a Laptop Computer
Step 1
Connect the VGA and Audio cables onto the VGA in
plate on the backsplash.
Step 2
Press the LAPTOP icon on
the main page.
STEP 3
Step 3
Press the SHOW icon to
display the output throgh
the computer.
Step 4
Make sure that the projector resolution is at 1024 x
768.
Page 4
Playing the VCR
Step 1
Press the VCR icon in the
main menu.
STEP 3
STEP 1
The VCR controls page as
shown in the right will be
displayed.
STEP 2
Step 2
Press the PLAY icon.
Step 3
Press the SHOW icon to
send the VCR video signal
to the projector.
Displaying the Document Camera
STEP 1
step 1
Press the Presenter icon on the
main menu.
step 2
press the Show icon to display
the image from the document
camera on the projector.
STEP 2
Loading...