AZ1055
CONTROLS
REMOTE
SENSOR
PLAY
RECORD
SEARCH
OPEN¥STOP
PAUSE
ST
OP
PLAY¥
PAUSE
¥
¥
¥
S
E
A
R
C
H
S
E
A
R
C
H
¥
¥
¥
BASS REFLEX
CD MODE
V
O
L
U
M
E
AZ1055
PRO
G
R
A
M
B
A
S
S
R
E
F
L
E
X
B
A
S
S
R
E
F
L
E
X
CD RADIO CASSETTE RECORDED
D
IG
IT
A
L A
U
D
IO
C
O
M
P
A
CT
8
9
7
3
SEARCH
SEARCH
REPEAT
SHUFFLE
5
4
6
12
English
BASIC FUNCTIONS
1 POWER:
CD, TAPE, BAND
....selects the sound source
2 DBB.......................enhances the bass
3 VOLUME ...............adjusts the volume level
4 p...........................3.5mm headphone socket
(back of the set)
Note: Connecting the headphones will switch
off the speakers.
5 CASSETTE RECORDER
PAUSE ; ...............interrupts recording or
playback
OPEN·STOP /9..stops the tape and opens
the cassette compartment
SEARCH 6 ...........rewinds the tape
SEARCH 5 ...........fast forwards the tape
PLAY 1 .................starts playback
RECORD 0 ...........starts recording
6 ..............................Sensor for the infrared
remote control
RADIO
7 TUNING ................tunes to radio stations
1 BAND: FM, MW...selects the wave band
4
8 CD PLAYER
OPEN
•
9...........................stops CD play and erases
2; ........................starts and interrupts CD
§ .........................skips and searches
∞ .........................skips and searches
CD MODE..............selects the different CD
9 ..............................Display
REMOTE CONTROL
SHUFFLE ...............plays CD tracks in random
REPEAT.................repeats a track, the entire
2; ........................starts and interrupts CD
¡™......................selects the beginning of
9 ..........................stops CD play and erases
56SEARCH.....
CLOSE .....opens the CD
compartment
the program
play
forward
backward
playing modes and
programs tracks
order
CD or the program
play
the current, a previous or a
subsequent track of a CD
the program
searches backward/forward
in a CD track
A
Batteries
For the set (optional)
Open the battery compartment of the set and insert 6 batteries,
type R20, UM-1 or D-cells (preferably alkaline).
For the remote control (optional)
Open the battery compartment of the remote control and insert 2
batteries, type R03, UM-4 or AAA-cells (preferably alkaline).
Remove batteries if they are flat or if the set is not going to be
used for a long time.
Batteries contain chemical substances, so they should be
disposed of properly.
Mains
1 Check whether the mains voltage as shown on the type plate
corresponds to your local mains voltage. If it does not, consult
your dealer or service organisation.
on the bottom of the set.
2 If the set is equipped with a VOLTAGE selector A, set this
selector to the local mains voltage.
The type plate is located
POWER SUPPLY
English
3 Connect the mains cable to the AC MAINS socket and the wall
socket. This switches on the mains supply.
inside the battery compartment.
The battery supply will be switched off when the set is connected
to the mains. To change over to battery supply, pull out the plug
from the unit’s AC MAINS socket.
To disconnect the set from the mains completely, remove the
mains plug from the wall socket.
For users in the U.K.: please follow the instructions on page 2.
The mains cable is
5
A
M
/
F
M
5
3
6
3
F
M
1
0
3
1
0
5
1
0
7
B
A
S
S
R
E
F
L
E
X
B
A
S
S
R
E
F
L
E
X
B
A
S
S
R
E
F
L
E
X
S
P
E
A
K
E
R
S
Y
S
T
E
M
-
V
O
L
U
M
E
+
REMOTE CONTROL
PLAY
R
E
C
O
R
D
SEARCH
P
A
U
S
E
S
T
O
P
O
P
E
N
•C
LO
S
E
C
D
R
A
D
IO
C
L
A
S
S
E
T
T
E
R
E
C
O
R
D
IN
G
A
Z
1
0
5
5
S
H
U
F
F
L
E
P
R
O
G
R
A
M
A
M
/
F
M
5
3
6
3
F
M
1
0
3
1
0
5
1
0
7
B
A
S
S
R
E
F
L
E
X
B
A
S
S
R
E
F
L
E
X
B
A
S
S
R
E
F
L
E
X
S
P
E
A
K
E
R
S
Y
S
T
E
M
-
V
O
L
U
M
E
+
REMOTE CONTROL
PLAY
R
E
C
O
R
D
SEARCH
P
A
U
S
E
S
T
O
P
O
P
E
N
•C
L
O
S
E
C
D R
A
D
IO
C
LA
S
S
ET
T
E
R
E
C
O
R
D
IN
G
A
Z
1
0
5
5
S
H
U
F
F
L
E
P
R
O
G
R
A
M
AZ1055
CD RADIO CASSETTE RECORDER
FM AM
170
130
100
80
63
53
kHz
x 10
MHz
100
96
92
88
104
108
O
P
E
N
•
C
L
O
S
E
C
D
S
Y
N
C
H
R
O
S
T
A
R
T
R
E
C
O
R
D
I
N
G
R
BASIC FUNCTIONS RADIO
English
Switching the set on and off
Set the POWER slider to the desired sound source:
CD, TAPE, or BAND (for radio).
OFF
POWER
TAPE
FM
CD
AM
The set is switched off when the POWER slider is set to OOFFFF/TAPE
and the keys of the tape deck are released.
Note: If you use batteries, switch the set off after use. This will
avoid unnecessary power consumption.
Adjusting volume and sound
Adjust the volume using the VOLUME control.
Increase and decrease the bass level by pressing DBB.
The bass level can also be emphasised if you place the set against
wall or shelf. Do not cover any vents; leave sufficient room around
the unit for ventilation.
Radio – tuning to radio stations
1 Set the POWER slider to FM or MW to select the desired
wave band.
2 Tune to the desired radio station by using the TUNING wheel.
Improving RADIO reception
For FM stations, pull out the telescopic antenna. To improve the
signal, incline and turn the antenna. Reduce its length if the signal
is too strong (very close to a transmitter).
DYNAMIC
BASS
BOOST
DYNAMIC
BASS
BOOST
VOLUME
AZ1055
CD RADIO CASSETTE
AZ1055
CD RADIO CASSETTE
For MW stations, direct the built-in antenna by turning the whole
set. The telescopic antenna is not needed.
6
CD RADIO CLASSETTE RECORDING
AZ1055
SHUFFLE
PROGRAM
PLAY
RECORD
SEARCH
PAUSE
OPEN¥STOP
STOP
PLAY ¥
PAUSE
¥
¥
¥
S
E
A
R
C
H
CD MODE
S
E
A
R
C
H
•
•
•
Playing a CD
1 Set the POWER slider to CD.
•
2 Press OPEN
3 Insert an audio CD (printed side up) and close the CD
compartment.
™ The CD player starts and scans the contents list of the CD.
Then, the CD player stops. Display indication: the total
number of tracks.
4 Press the 2; button to start CD play.
™ Display indication: the current track number.
5 Press the 9 button to stop CD play.
™ Display indication: the total number of tracks.
You can interrupt CD play by pressing 2;. Continue CD play by
pressing the button again.
™ Display indication: the current track number (flashing).
Note: CD play will also stop if:
– you open the CD compartment,
– the end of the CD is reached, or
– you move the
CLOSE to open the CD compartment.
POWER
slider.
CD PLAYER
P
O
E
N
•
C
L
O
S
E
Y
English
If you make a mistake when operating the CD player, or if the
CD player cannot read the CD, the display shows E or no. (See
”TROUBLESHOOTING”.)
If you press 2; and there is no CD inserted, the display
shows no.
Environmental information
All redundant packing material has been omitted. We have done our utmost to make the
packaging easily separable into three mono materials: cardboard (box), polystyrene foam (buffer)
and polyethylene (bags, protective foam sheet).
Your set consists of materials which can be recycled if disassembled by a specialized company.
Please observe the local regulations regarding the disposal of packing materials, exhausted
batteries and old equipment.
7
CD PLAYER
SHUFFLE
REPEAT
ALL
English
Search backward ∞ and forward §
Selecting another track
Briefly press the ∞ or § button once/several times to skip to the
beginning of the current, previous or subsequent track(s).
During CD play:
CD play continues automatically with the selected track.
When CD play is stopped:
Press 2; to start CD play.
™ Display indication: the selected track number.
Searching for a passage during CD play
1 Hold down the ∞ or § button to find a particular passage in a
forward or backward direction.
™ CD play continues at a low volume.
2 Release the button when you have reached the desired passage.
Note: In the different CD modes or when playing a program, searching
is only possible within the particular track.
CD MODE: Shuffle and Repeat
1 During CD play press CD MODE repeatedly to cause the display
to show the different playing modes.
™
SHUFFLE: All tracks of the CD (or program) are played in
random order.
™
SHUFFLE REPEAT ALL: All tracks of the CD (or program) are
played repeatedly in random order.
™
REPEAT: The current track is played repeatedly.
™
REPEAT ALL: The entire CD (or program) is played repeatedly.
CD RADIO CLASSETTE RECORDING
AZ1055
PAUSE
OPEN¥STOP
STOP
PLAY ¥
PAUSE
¥
¥
¥
S
STOP
PLAY ¥
PAUSE
¥
¥
¥
S
SEARCH
PLAY
RECORD
PROGRAM
E
A
R
C
H
E
A
R
C
H
SHUFFLE
PAUSE
OPEN¥STOP
SEARCH
PROGRAM
SHUFFLE
CD MODE
¥
¥
¥
S
H
E
C
A
R
C
D RAD
AZ1055
IO
C
LA
SSETTE R
EC
O
R
DIN
G
PLAY
RECORD
CD MODE
¥
¥
¥
S
H
E
C
A
R
2 After 2 seconds of flashing display indication, CD play starts in
the chosen mode.
3 To return to normal CD play, press CD MODE until the display
indication disappears.
8
PROGRAM
CD MODE: Programming track numbers
You can select a number of tracks and store these in the memory
in the desired sequence. You can store any track more than once.
A maximum of 20 tracks can be stored in the memory.
1 When CD play is stopped, select the desired track with ∞ or
§.
2 As soon as the number of the desired track is displayed, press
CD MODE to store the track in the memory.
™
PROGRAM appears on the display. P lights up briefly, then the
number of the stored track is shown.
3 Select and store all desired tracks in this way.
4 You can review your settings by pressing and holding CD MODE
for more than 1 second.
™ The display shows all stored track numbers in sequence.
If you try to store more than 20 tracks, the display shows F.
CD PLAYER
CD
AZ1055
RADIO
CLA
SSETTE RE
CO
R
DING
PAUSE
STOP
OPEN¥STOP
SEARCH
PLAY
PLAY ¥
PAUSE
¥
¥
¥
S
E
A
R
C
H
RECORD
PROGRAM
SHUFFLE
CD MODE
¥
¥
¥
S
H
E
C
A
R
PROGRAM
PROGRAM
English
Playing the program
Press 2; to play the program.
Erasing the program
From the stop position, press 9.
™ no lights up briefly,
is erased.
Note: The program will also be erased if you:
– interrupt the power supply,
– open the CD compartment, or
– move the
POWER
PROGRAM disappears and your program
slider.
PROGRAM
9
Loading...