Clock Radio
Register your product and get support at
www.philips.com/welcome
User manual
AJL305
1
1
2
6
7
8
ALARM
CLOCK RADIO AJL305
REC MIC
Design by Philips, Holland
CLOCK TUNER PHOTO
5
4
3
VOL
9
FM
DC IN 9V
ANT.
0
!
RESET
@
Important notes for users in the U.K.
Mains plug
This apparatus is fi tted with an approved 13 Amp plug.To change a fuse in
this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI approved
type.
3. Refi t the fuse cover.
If the fi tted plug is not suitable for your socket outlets, it should be cut off
and an appropriate plug fi tted in its place. If the mains plug contains a fuse,
this should have a value of 3 Amp. If a plug without a fuse is used, the fuse at
the distribution board should not be greater than 3 Amp.
Note: The severed plug must be disposed of to avoid a possible shock
hazard should it be inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the following code: blue =
neutral (N), brown = live (L). As these colours may not correspond with the
colour markings identifying the terminals in your plug, proceed as follows:
• Connect the blue wire to the terminal marked N or coloured black.
• Connect the brown wire to the terminal marked L or coloured red.
• Do not connect either wire to the earth terminal in the plug, marked E
(or e) or coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is clamped
over the sheath of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require consent. See Copyright Act
1956 and The Performer’s Protection Acts 1958 to 1972.
English Controls / Power supply
Controls (See 1)
Alarm
1
activates, or deactivates alarm
–
REPEAT ALARM/BRIGHTNESS
2
CONTROL
repeats alarm in 9-minute interval
–
adjusts brightness of LCD display
–
CLOCK
3
–
switches to clock mode
TUNER
4
switches to tuner mode
–
PHOTO
5
–
switches to photo mode
Mini USB port
6
–
connects to a USB port on PC
REC
7
–
switches to voice memo recording
MIC
8
–
records voice memos
VOL
9
–
adjusts volume level
DC IN
0
–
socket for DC 9 V adapter
Pigtail
!
–
FM antenna to improve reception
RESET
@
–
press if the set does not react to
operation of any button
Power supply
1 Connect the supplied power adapter to the
set's DC IN 9V socket and to the power
socket.
2 Disconnect the power adapter if you want
to switch off the set completely.
Helpful hints:
To avoid damage to the set, use only the
–
adapter supplied!
The type plate is located on the rear of the set.
–
General Information
Congratulations on your purchase and
welcome to Philips!
To fully benefi t from the support that
Philips offers, register your product at
www.philips.com/welcome
Supplied accessory
1 X certifi ed power adapter (Model: DSA-
–
9W-09 FUK 090100 Input: 100-240V
~50/60Hz 0.3A, Output: +9V 1A)
Restoring the set
You can restore factory settings if the set
does not react to any operation or you want
to restore all settings.
Reset
Press and hold RESET with a ballpoint or
–
other thin sticks.
Master reset
Press and hold PHOTO and TUNER at
–
the same time and press and hold RESET
with a ballpoint or other thin sticks.
Besides restoring settings, master reset
deletes all preset radio stations, photos, and
voice memos.
You can use master reset to delete
everything easily.
Environment Information
All unnecessary packaging material has
been omitted. The packaging can be easily
separated into three materials: cardboard,
polystyrene and plastic.
Your set consists of materials which
can be recycled if disassembled by a
specialized company. Please observe the
local regulations regarding the disposal of
packaging, dead batteries and old equipment.
Disposal of your old product
Your product is designed and
manufactured with high quality
materials and components, which
can be recycled and reused.
When this crossed-out wheeled
bin symbol is attached to a
product it means the product is covered
by the European Directive 2002/96/EC.
Please inform yourself about the local
separate collection system for electrical and
electronic products.
Please act according to your local rules and
do not dispose of your old products with
your normal household waste. The correct
disposal of your old product will help
prevent potential negative consequences for
the environment and human health.