Register your product and get support at
www.philips.com/welcome
Clock Radio
AJ260
Quick start guide
Step A
Connect power
Connect the supplied mains adapter to the
1
sets 7.5V DC jack and the plug into a wall
outlet.
Step B
Set the Clock & Alarm time
Press and hold TIME SET or ALM1 /
1
ALM2 until the time digits ash.
Press and hold TUNING +/- to adjust
2
time.
Press TIME SET or ALM1 / ALM2 to
3
conrm.
Repeat the steps 2-3 to complete all the
4
other time items setting.
Step C
Select the Alarm mode
In standby mode, slide the RADIO/BUZ to
select desired mode.
Helpful hints:
– If you have selected RADIO, make sure
you have properly tuned to a station before
turning off the set.
Switch off the alarm
Press • SLEEP/ALARM RESET.
•
•
Listen to radio
Press RADIO ON/OFF once to switch
1
Press AUTO SCAN/DATE to program
2
Press PRESET repeatedly until the desired
3
Weather forecast and Indoor
thermometer
The unit can auto detect and measure
atmospheric pressure changes to graphically
display the weather forecast in the next 12 to
24 hours, and current indoor temperature.
REPEAT ALARM/
Press
BRIGHTNESS CONTROL.
ALM1 or ALM2.
Press
on the radio.
all available stations.
preset station is displayed.
Note:
– The weather forecast based on the
atmospheric pressure may vary slightly from
the actual weather situation.
Use the outdoor sensor
The outdoor sensor is supplied to work with
the main unit to measure and display the
outdoor temperature.
Place the sensor in a desired open area.
1
The place must be within 50 meters away
from the main unit. (Make sure that the
sensor is loaded with 2 A A batteries.)
•
For the rst time using the outdoor sensor
and the main unit, press RESET located
on the sensor back, and RESET located
in the battery compar tment of the main
unit. Then, the main unit will begin to
receive transmission from the sensor.
•
To update the outdoor temperature
from the sensor any time, press and hold
AUTO SCAN/DATE for 5 seconds.
Note:
– Refer to the supplied User Manual for more
information about the outdoor sensor.
© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
AJ260_79_QSG_V1.0_1029