Always there to help you
Question?
Contact
Philips
Register your product and get support at
www.philips.com/support
AJ2000
User manual
Contents
1 Important 2
Safety 2
2 Your clock radio 3
Introduction 3
What's in the box 3
Overview of the clock radio 4
3 Get started 5
Install battery 5
Connect power 5
Set clock 6
Turn on 6
4 Listen to FM radio 7
Prepare FM antenna 7
Tune to FM radio stations 7
Store FM radio stations automatically 7
Store FM radio stations manually 7
Select a preset FM radio station 7
Adjust volume 8
5 Set alarm timer 9
Set alarm 9
Activate/deactivate alarm timer 9
Snooze the alarm 9
6 Other features 10
Set sleep timer 10
Adjust display brightness 10
7 Product information 11
Specications 11
8 Troubleshooting 12
9 Notice 13
Care of the environment 13
1EN
1 Important
Safety
Warning
• Never remove the casing of this clock radio.
• Never lubricate any part of this clock radio.
• Never place this clock radio on other electrical
equipment.
• Keep this clock radio away from direct sunlight, naked
amesorheat.
• Make sure that you always have easy access to the
power cord, plug or adaptor to disconnect the clock
radio from the power.
• Read and follow these instructions.
• Make sure that there is enough free space
around the clock radio for ventilation.
• Onlyuseattachments/accessoriesspecied
by the manufacturer.
• Use only power supplies listed in the user
manual.
• Unplug this clock radio during lightning
storms or when unused for long periods
of time.
• Battery usage CAUTION – To prevent
battery leakage which may result in bodily
injury, property damage, or damage to the
clock radio:
• Install the battery correctly, + and - as
marked on the clock radio.
• Remove the battery when the clock
radio is not used for a long time.
• The battery shall not be exposed to
excessiveheatsuchassunshine,reor
the like.
• The clock radio shall not be exposed to
dripping or splashing.
• Do not place any sources of danger on the
clockradio(e.g.liquidlledobjects,lighted
candles).
• Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
Risk of swallowing batteries!
• The device may contain a coin/button
type battery, which can potentially be
swallowed. Keep the battery out of reach
of children at all times! If swallowed, the
battery can cause serious injury or death.
Severe internal burns can occur within two
hours of ingestion.
• If you suspect that a battery has been
swallowed or placed inside any part of the
body, seek immediate medical attention.
• When you change the batteries, always
keep all new and used batteries out of
reach of children. Make sure that the
battery compar tment is completely secure
after you replace the battery.
• If the battery compar tment cannot be
completely secured, discontinue use of the
product. Keep out of reach of children and
contact the manufacturer.
Note
• The type plate is located on the bottom of the
apparatus.
2 EN
2 Your clock radio
Congratulations on your purchase, and
welcometoPhilips!Tofullybenetfromthe
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With this clock radio, you can:
• listen to FM radio;
• view time; and
• set two alarms.
What's in the box
Check and identify the contents of your
package:
• Clock radio
• Printed materials
Always there to help you
Register your product and get support at
www.philips.com/support
Question?
Contact
Philips
Short User manual
3EN
Overview of the clock radio
a
c
d
e
g
f
b
a SCAN/SLEEP
• Scan and store radio stations
automatically.
• Set sleep timer.
b /RADIO
• Turn the radio on or off.
c SET TIME/PRESET
• Set time.
• Store FM radio stations manually.
• Select a preset radio station.
d HOUR/MIN/- TUNING +
• Adjust hour and minute.
• Tune to FM radio stations.
e SNOOZE/BRIGHTNESS
• Snooze the alarm.
• Adjust display brightness.
f Display panel
• Show current status.
g / /- VOLUME +
• Set alarm.
• Activate or deactivate alarm timer.
• Adjust volume.
4 EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Install battery
Caution
• Risk of explosion! Keep the battery away from heat,
sunshineorre.Neverdiscardbatteryinre.
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• The battery contains chemical substances, so it should
be disposed of properly.
Note
• You can only use AC power as power supply. The
lithium CR2032 battery can only back up clock and
alarm settings.
• When power is disconnected, the display backlight is off.
To replace the battery:
1 Push the clip to the left and pull out the
battery tray.
2 Inser t 1 x CR2032 batter y as illustrated.
CR2032
CR2032
Connect power
For rst-time use:
Remove the protective tab to activate the
battery.
Caution
• Risk of product damage! Make sure that the power
voltage corresponds to the voltage printed on the back
or underside of the clock radio.
• Risk of electric shock! When you unplug the AC plug,
always pull the plug from the socket. Never pull the
cord.
Connect the power adaptor to the wall outlet.
5EN
Set clock
1 In standby mode, press and hold SET TIME
for two seconds to activate clock setting
mode.
» The hour and minute digits blink.
2 Press HOUR and MIN repeatedly to set
hour and minute respectively.
3 Press SET TIMEtoconrm.
» The set time is displayed.
Turn on
Press to turn on the radio.
» The product switches to FM tuner
mode.
Switch to ECO standby mode
Press again to switch to ECO standby mode.
» The clock (if set) is displayed.
6 EN
4 Listen to FM
radio
Store FM radio stations automatically
Note
• You can store a maximum of 20 FM radio stations.
Prepare FM antenna
For better reception, fully extend and adjust the
position of the pig-tail antenna.
Note
• To prevent interference, position the antenna as far as
possible from any other electrical appliances.
Tune to FM radio stations
1 Press RADIO to turn on FM radio.
2 Press and hold - TUNING + for two
seconds.
» The clock radio tunes to a station with
strong reception automatically.
3 Repeat step 2 to tune to more radio
stations.
To tune to a station manually:
In tuner mode, press - TUNING + repeatedly
to select a frequency.
In FM tuner mode, press and hold SCAN for
two seconds.
» The clock radio stores all the available
FM radio stations automatically.
» Therstavailablestationbroadcasts
automatically.
Store FM radio stations manually
Note
• You can store a maximum of 20 FM radio stations.
1 In FM tuner mode, tune to an FM radio
station.
2 Press and hold PRESET for two seconds.
» The preset number begins to blink.
3 Press HOUR or MIN to select a number.
4 Press PRESETtoconrm.
5 Repeat steps 1 to 4 to store other stations.
Note
• To remove a pre-stored station, store another station
in its place.
Select a preset FM radio station
In FM tuner mode, press PRESET repeatedly to
select a preset radio station.
7EN
Adjust volume
While listening to FM radio, press - VOLUME +
repeatedly to increase or decrease volume.
8 EN
5 Set alarm timer
Set alarm
You can set two alarms to ring at different time.
Note
• Make sure that you have set the clock correctly.
1 In standby mode, press and hold or
for two seconds to activate alarm setting
mode.
» The hour and minute digits and the
alarm icon ( or ) begin to blink.
2 Press HOUR and MIN repeatedly to set
hour and minute.
3 Press or toconrm.
4 Press HOUR or MIN to select alarm source:
buzzer or your last listened FM station.
5 Press or againtoconrm.
Snooze the alarm
When the alarm goes off, press SNOOZE.
» The alarm snoozes and repeats ringing
nine minutes later.
Tip
• The alarm volume is not adjustable, but will go up
gradually to gently wake you up.
Activate/deactivate alarm timer
Press or repeatedly to activate or
deactivate the alarm timer.
» The alarm icon ( or ) appears if
the alarm timer is on and disappears
if it is off.
• To stop the alarm, press the
corresponding or .
» The alarm repeats itself in subsequent
days.
9EN
6 Other features
Adjust display brightness
Set sleep timer
Press SLEEP repeatedly to select the sleep
timer period (in minutes).
» The clock radio switches to standby
mode automatically after the preset
period.
To deactivate the sleep timer:
In sleep timer setting mode, press SLEEP
repeatedly until [OFF] (off) appears.
X3
Press BRIGHTNESS repeatedly to select
different brightness levels:
• High
• Medium
• Low
10 EN
7 Product
information
Note
• Product information is subject to change without prior
notice.
Specications
Amplier
Rated Output Power 0.7 W RMS
Frequency Response 75 Hz - 12.5 KHz,
±3 dB
Tuner
Tuning Range (FM) 87.5 - 108 MHz
Tuning Grid 50 KHz
- Mono, 26dB S/N Ratio <22 dBf
Search Selectivity <35 dBf
Total Harmonic Distortion <2%
Signal to Noise Ratio >50 dB
General information
Power supply (power
adapter)
Operation Power
Consumption
ECO Standby Power
Consumption
Dimensions - Main
Unit (W x H x D)
Weight - Main Unit 0.3 kg
Brand name: PHILIPS;
Model: GQ05050050-AG;
Input: 100-240V~,
50/60 Hz, 0.3 A Max;
Output: DC 5 V,
500 mA;
1.5 W
<1 W
185 x 85 x 81 mm
Speaker
Speaker Impedance 8 ohm
Speaker Driver 1 X 1.5” full range
Sensitivity 81±3 dB/m/W
11EN
8 Troubleshooting
Warning
• Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
No power
• Make sure that the AC power plug of the
clock radio is connected properly.
• Make sure that there is power at the AC
outlet.
No response from the clock radio
• Disconnect and reconnect the AC power
plug, then turn on the clock radio again.
Poor radio reception
• Keep the clock radio away from other
electronic devices to avoid radio
interference.
• Fully extend and adjust the position of the
pig-tail antenna.
Alarm does not work
• Set the clock/alarm correctly.
12 EN
9 Notice
Anychangesormodicationsmadetothis
device that are not expressly approved by
Gibson Innovations may void the user’s
authority to operate the equipment.
This product complies with the radio interference
requirements of the European Community.
Care of the environment
Disposal of your old product and battery
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
Removing the disposable batteries
To remove the disposable batteries, see battery
installation section.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
paper pulp (buffer) and polyethylene (bags,
protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
This symbol on a product means that the
product is covered by European Directive
2012/19/EU.
This symbol means that the product contains
batteries covered by European Directive
2013/56/EU which cannot be disposed of with
normal household waste.
Inform yourself about the local separate
collection system for electrical and electronic
products and batteries. Follow local rules and
never dispose of the product and batteries
with normal household waste. Correct disposal
of old products and batteries helps prevent
negative consequences for the environment and
human health.
13EN
2016 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is sold under the responsibility
of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in
relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke
Philips N.V. and are used under license from Koninklijke Philips N.V.
AJ2000_12_UM_V2.0
Loading...