1. Insert the memory card with the gold contacts facing to
the front of the device.
2. Push the memory card until it clicks into place, and slide
the switch to ON.
2.2 Installing in Vehicles
Attach the bracket to the device. Slide it into the bracket
holder until you hear a click.
6
1. Peel off the protective plastic sheet from the adhesive
bracket and Lens.
2. Place and press down the bracket rmly onto
your windshield.
3. Adjust the device position. Loose the knob to swivel
the device to proper position.Then tighten the knob to
make sure the device is securely locked in place.
7
4. Connect the Micro USB interface of the car charger to
the Micro USB port of the device.
5. Plug the car charger to the cigarette lighter socket of
your vehicle.
2.3 Automatic Power On/Off
1. Once the power of the vehicle is on, the device automatically turns on.
2. If you disconnect the car charger, the device automatically turns off.
2.4 Manual Power On/Off
1. To turn on the device, slide the switch to ON.
2. To turn off the device, slide the switch to OFF.
8
2.5 Manual Record Start/Stop
1. When device in automatic
recording status, press ▲ to
stop recording.
2. When device in stop recording status, press ▲ to start
recording video again.
2.6 Manual Voice Recording Off/On
1. When device set voice recording on in system setting, press
▼ to switch voice recording to
Off.
2. When device set voice recording Off in system setting, press
▼ to switch voice recording to
On.
9
2.7 Remove the Memory Card
Slide the switch to Off, and push to eject the memory card
out of the slot.
2.8 About Micro SD Card
1. Please use Micro SD card with the size/memory at least
8GB, Class6(up to 32GB)
2. Be sure to format Micro SD card using the device before
the initial usage.
3. The following information is the card capacity and Recording time:
Micro SD
Card Capacity
16GB260 minutes170 minutes160 minutes
32GB520 minutes340 minutes320 minutes
(720P/30FPS)(720P/60FPS)(1080P/30FPS)
Video Resolution
Notes:
1. If car power supply doesn’t stop automatically, it is recommended to disconnect the car charger manually to avoid
car battery power lost.
2. Please use our dedicated car charger to avoid non-compliance with the device.
3. Once connected to a PC through USB, the device only
allows data transfer.