Philips 719966148 User Manual

B
BASE
10275 W. Higgins Road
Rosemont, IL 60018, USA
www.philips.com
4404.018.00071
Last update: 04/07/13
01 02 03 04
05 06 07 08
09 10 11 12
13 14 15 16
3/8"
±8
t ......°F
Distributor
MAX. … W
-
GU24
© Copyright
17 18 19 20
21 22 23 24
25 26 27 28
MAX 20ft
00ft
+
29 30
000°
MIN 00 SEC MAX 00 MIN
31 32
00ft 00ft
SAFETY INSTRUCTIONS - PART B E NGL I S H
The manufacturer advises the correct use of Luminaires (lightin xtures)! Therefore always follow these instructions to ensure correct and safe installation and functioning of the luminaire and keep it for future reference.
Turn off electrical power at main fuse or circuit breaker box before commencing installation, maintenance or repair.
If in doubt, consult a quali luminiare to the local electrical code. Certain regulations indicate that luminaires should be installed by a quali
ed electrician.
Observe the correct color of the wiring before installation: white or white tracer (Neutral), black or black tracer (Line), green or bare copper wire (Ground) and green tracer for bonding purpose.
Do not connect this luminaire to a non-grounded elec a non-grounded electrical system could allow metal parts of the luminaire to carry electrical current if any wires or wire connections become broken or loose. Under this condition, anyone coming in contact with the luminaire is subject to electric shock which could cause injury or death.
Always use wire nuts/connectors rated for the correct gauge and number of wires used. CAUTION: Be certain that no bare wire strands are exposed outside of the wire
Be careful not to damage or cut the wire insulation (covering) during installation to contact any sharp edges.
Do not remove thermal insulation pad(s). Doing so will result in increased temperatures and possible
re.
risk of
Maintain interior lighting with a dry cloth duster, do not use abrasives or solvents. Avoid liquid on all electrical parts.
Always consider all the technical speci cations of the luminaire. Verify the stated icons on the identi cation label on the luminaire and the icons that are shown in part A of your safety instructions.
instructions. 01- This luminaire should only be installed indoors. 02- The luminaire is suitable for outdoor usage. 03- Only suitable for dry locations. 04- Suitable for damp locations. 05- Suitable for wet locations. 06- Luminaire is suitable for base up mounting. 07- Luminaire is suitable for base down mounting. 08- Luminaire is suitable for horizontal mounting. 09­10­11­12- Always observe the minimum distance between the lamp and the surface being lit as indicated on the icon. 13- Free air space of at least 4 inches must be kept between top of shade and bottom of canopy. 14- Immediately replace a cracked or broken safety glass and use only manufacturer approved parts. 15- Strip the wire as indicated in the diagram. 16- Use heat-resistant cable for wiring the luminaire into the mains. 17­18- The 19- The . 20- The luminaire is only suitable for a lamp with built-in safety or a low pressure lamp. An extra safety
glass is not necessary. 21- Capsule and linear halogen lamps may not be touched by bare hands. 22- The luminaire is equipped with a fuse. If the luminaire is out of order after the bulb has been replaced,
the internal fuse has to be replaced. If contact with the internal wiring can be made during this opera-
tion, this should be done by a competent electrician. 23-
type (especially important for low voltage luminaires). 24- The Luminaire cannot be used with a dimming circuit. 25- The Luminaire utilizes GU24 Base electrical components and cannot be used with dimmers, timers or
other control devices. 26- Luminaire with time and light setting options. Minimum and maximum will be shown in the icon in part A. 27- The luminaire can be placed at a maximum of 20ft height. 28- To reach an optimal working, you have to p
maximum and minimum reach of the detector is also mentioned in the icon in part A. 29- The standard active range 30- Ensure that you don’t drill through electrical wires or any other obstruction in the wall or ceiling dur-
ing installation! 31- This luminaire contains in some places very hot parts. 32- This product is no
The Luminaire – as well as all other products from the collection – is designed and tested in accordance with the strictest national safety standards. In case of construction faults or material damages, the manufac­turer gives a guarantee up to 2 year (unless otherwise stated on the packaging do not fall under the guarantee terms. Most ballasts, transformers, electronic drivers battery packs are covered by separate ballast manufacturer’s warranties, contact Philips for exceptions. Any damage caused to the luminaire in extreme conditions (coastal areas, industrial surroundings, farm environ­ments) will not be covered by the guarantee. The period of guarantee starts from the purchase date and is only valid on presentation of receipt. The guarantee is void if the luminaire was not installed following
a result of misuse or wrong application of the luminaire. Alterations
ed electrician or contact your retail outlet. Ensure that you always install the
trical system. WARNING: Installing this
nuts/connections (if applicable).
lace the luminaire on the height mentioned in the icon. The
of vision of the detector covers the given degrees mentioned in the icon.
t suitable for children under 14 years.
. Do not permit wires
). Light bulbs and batteries
and emergency
xture in
the
2
Loading...
+ 4 hidden pages