Philips 700 User Manual [en, es]
Always here to help you
Register your product and get support at
www.philips.com/welcome
HX6700 series
1
ENGLISH 4
ESPAÑOL 13
PORTUGUÊS DO BRASIL 22
HX6700 series
4
ENGLISH
Introduction
Congratulations on your purchase and welcome to Philips! To fully
benet from the support that Philips offers, register your product at
www.philips.com/welcome.
Important
Read this user manual carefully before you use the appliance and save it
for future reference.
Danger
- Keep the charger away from water. Do not place or store it over or
near water contained in a bathtub, washbasin, sink etc. Do not immerse
the charger in water or any other liquid. After cleaning, make sure the
charger is completely dry before you connect it to the mains.
Warning
- Check if the voltage indicated on the appliance corresponds to the
local mains voltage before you connect the appliance.
- The mains cord cannot be replaced. If the mains cord is damaged,
discard the charger. Always have the charger replaced with one of the
original type in order to avoid a hazard.
- If the appliance is damaged in any way (brush head, toothbrush handle
and/or charger), stop using it.
- This appliance contains no serviceable par ts. If the appliance is
damaged, contact the Consumer Care Center in your country (see
chapter ‘Guarantee and service’).
- Do not use the charger outdoors or near heated surfaces.
- This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
- Children should be supervised to ensure that they do not play with
the appliance.
Caution
- If you have had oral or gum surgery in the previous 2 months,
consult your dentist before you use the toothbrush.
- Consult your dentist if excessive bleeding occurs after using this
toothbrush or if bleeding continues to occur after 1 week of use.
- If you have medical concerns, consult your doctor before you use
the Sonicare.
- The Sonicare toothbrush complies with the safety standards for
electromagnetic devices. If you have a pacemaker or other implanted
device, contact your physician or the device manufacturer of the
implanted device prior to use.
- This appliance has only been designed for cleaning teeth, gums and
tongue. Do not use it for any other purpose. Stop using the appliance
and contact your doctor if you experience any discomfort or pain.
- The Sonicare toothbrush is a personal care device and is not intended
for use on multiple patients in a dental practice or institution.
- Stop using a brush head with crushed or bent bristles. Replace the
brush head every 3 months or sooner if signs of wear appear.
ENGLISH 5
- Do not use other brush heads than the ones recommended by the
manufacturer.
- If your toothpaste contains peroxide, baking soda or other bicarbonate
(common in whitening toothpastes), thoroughly clean the brush head
and the handle with soap and water after each use. Otherwise the
plastic may crack.
- Do not clean brush heads, the handle, the charger and the charger
cover in the dishwasher.
Electromagnetic elds (EMF)
This Philips appliance complies with all standards regarding electromagnetic
elds (EMF). If handled properly and according to the instructions in this
user manual, the appliance is safe to use based on scientic evidence
available today.
The Sonicare (Fig. 1)
A Hygienic travel cap
B Brush head
C Interchangeable colour code ring
D Handle with soft grip
E On/off button
F Brushing modes
G Charge light indicator
- Deluxe charge indicator (specic types only)
- Standard charge indicator (specic types only)
H Standard charger (specic types only)
- H1 Charger cover with brush head holder
- H2 Travel charger
I Deluxe charger (specic types only)
- I1 Charger cover with brush head holder
- I2 Travel charger
- I3 Charger base with cord wrap facility
Getting started
Changing the colour code ring
Sonicare brush heads come with interchangeable colour code rings to
identify your brush head.
To change the colour code ring:
1 Pull the colour code ring from the bottom of the brush head.
ENGLISH6
2 To attach a new ring, slip one edge of the new ring over the bottom
of the brush head. Then press down on the other side to snap the
ring into place.
Attaching the brush head
1 Align the brush head so the bristles face the front of the handle.
2 Firmly press the brush head down onto the metal shaft until it stops.
Note: There is a small gap between the colour code ring and the handle.
Charging the Sonicare
1 Put the plug of the charger in the wall socket.
2 Place the handle on the charger.
, The battery charge indicator next to the battery symbol ashes to
indicate that the toothbrush is charging.
Battery charge indicator
The battery charge indicator shows the approximate remaining battery
charge.
Deluxe charge indicator (specic types only):
- Solid green: 50-100%
- Flashing green: 10-49%
- Flashing yellow: less than 10%
Standard charge indicator (specic types only):
- Solid green: 50-100%
- Flashing green: less than 50%
Note: When the battery is low, you hear 3 beeps after the completion of the
brushing cycle and the battery charge indicator ashes for 30 seconds.
Note: To keep the battery fully charged, you may keep your Sonicare on the
charger when not in use. It takes 24 hours to charge the battery fully.
ENGLISH 7
Using the Sonicare
Brushing instructions
1 Wet the bristles and apply a small amount of toothpaste.
2 Place the toothbrush bristles against the teeth at a slight angle
towards the gumline.
3 Press the on/off button to switch on the Sonicare.
4 Apply light pressure to maximise Sonicare’s effectiveness and let the
Sonicare toothbrush do the brushing for you.
5 Gently move the brush head slowly across the teeth in a small back
and forth motion so the longer bristles reach between your teeth.
Continue this motion throughout the brushing cycle.
Note: To make sure you brush evenly throughout the mouth, divide your mouth
into 4 sections using the Quadpacer feature (see chapter ‘Features’).
6 Begin brushing in section 1 (outside upper teeth) and brush for
30 seconds before you move to section 2 (inside upper teeth).
Continue brushing in section 3 (outside lower teeth) and brush for
30 seconds before you move to section 4 (inside lower teeth).
7 After you have completed the brushing cycle, you can spend
additional time brushing the chewing surfaces of your teeth and
areas where staining occurs. You can also brush your tongue,
with the toothbrush switched on or off, as you prefer.
The Sonicare is safe to use on:
- Braces (brush heads wear out sooner when used on braces)
- Dental restorations (llings, crowns, veneers)
Note: You can switch off the toothbrush at any time by pressing and holding
the on/off button for 2 seconds.
Clean and White mode brushing instructions
The Clean and White mode consists of 2 minutes of Clean mode to clean
the whole mouth and an additional 30 seconds of White mode to focus on
the visible front teeth.
1 Brush the rst 2 minutes as instructed in steps 1-6 above.
2 After the 2 minutes of Clean mode, the White mode begins with
a change in brushing sound and motion. That is your signal to start
brushing the visible upper front teeth for 15 seconds
3 At the next beep and pause, move to the visible lower front teeth
for the nal 15 seconds of brushing.
ENGLISH8
Brushing modes
The Sonicare automatically starts in the default Clean mode. To select a
different brushing mode:
1 Press the on/off button to toggle between modes.
, The green LED indicates the selected mode.
Note: You can only switch between modes when the toothbrush is switched on.
Clean mode
Standard mode for superior teeth cleaning.
Sensitive mode (specic types only)
Gentle yet thorough cleaning for sensitive gums and teeth.
Clean and White mode
2 minutes of Clean mode with an additional 30 seconds of White mode to
focus on the visible front teeth.
Note: When the Sonicare is used in clinical studies, the default 2-minute Clean
mode must be selected. However, in whitening/stain reduction studies, the
Clean and White mode must be selected. The handle should be fully charged
and the Easy-start feature deactivated.
Features
Easy-start
- This Sonicare comes with the Easy-start feature activated.
- The Easy-start feature gently increases power over the rst
14 brushings to help you get used to brushing with the Sonicare.
Note: Each of the rst 14 brushings must last at least 1 minute to move
through the Easy-start ramp-up cycle properly.
Note: When the Clean and White mode is selected, the Easy-start feature is
inactive.
Deactivating or activating the Easy-start feature
1 Attach the brush head to the handle.
2 Place the handle in the plugged-in charger.
- To deactivate Easy-star t:
Press and hold the on/off button for 2 seconds. You hear 1 beep to indicate
that the Easy-start feature has been deactivated.
- To activate Easy-star t:
Press and hold the on/off button for 2 seconds. You hear 2 beeps to
indicate that the Easy-start feature has been activated.
Note: Use of the Easy-start feature beyond the initial ramp-up period is not
recommended and reduces the effectiveness of the Sonicare toothbrush in
removing plaque.
ENGLISH 9
Smartimer
The Smartimer indicates that your brushing cycle is complete by
automatically switching off the toothbrush at the end of the brushing cycle.
Dental professionals recommend brushing no less than 2 minutes twice a day.
If you want to pause or stop brushing during the 2-minute brushing cycle,
press and hold the on/off button for 2 seconds. Press the on/off button
again and the Smartimer picks up where you left off.
The Smartimer automatically resets to the beginning of a 2-minute cycle if:
- you stop brushing for 30 seconds or longer.
- you put the handle in the charger.
Quadpacer (select models)
- The Quadpacer is an interval timer that has a short beep and pause
to remind you to brush the 4 sections of your mouth evenly and
thoroughly.
- When you use the two-minute Clean or Sensitive mode, you hear a
short beep and a pause in brushing action at 30, 60 and 90 seconds.
- When you use the Clean and White mode, you hear and feel a change
in the brush head sound and motion after 2 minutes of Clean mode.
Then move the brush head to the visible upper front teeth and brush
them for 15 seconds. At the nal beep and pause, move to the visible
lower front teeth and brush them for 15 seconds.
Cord wrap facility (specic types only)
If your Sonicare type includes the deluxe charger cover and base, the travel
charger is pre-installed inside the cover. If you want to shorten the mains
cord, you can store excess cord in the cord wrap facility in the charger base.
1 To separate the charger cover from the charger base, press the two
grey snap bars on the charger base and pull the white charger cover
upwards.
2 Wrap excess mains cord around the grey charger base as shown in
the picture. Make sure you wrap the cord on the inside of the two
snap levers.
ENGLISH10
3 When you have stored the excess cord, guide the mains cord
through the small groove in the rear of the grey charger base.
4 To reattach the charger cover, press it down over the charger base
until it snaps into place.
Tip: For extra convenience during travel, you can remove the travel charger and
use it without the charger cover and charger base.
Cleaning
Do not clean brush heads, the handle, the charger or the charger covers
in the dishwasher.
Toothbrush handle
1 Remove the brush head and rinse the metal shaft area with warm
water.
Do not push on the rubber seal on the metal shaft with sharp objects,
as this may cause damage.
2 Wipe the entire surface of the handle with a damp cloth.
Brush head
1 Rinse the brush head and bristles after each use.
2 Remove the brush head from the handle and rinse the brush head
connection at least once a week with warm water.
Charger
1 Unplug the charger before you clean it.
2 Wipe the surface of the charger with a damp cloth.
Storage
- If you are not going to use the appliance for a long time, unplug it, clean
it and store it in a cool and dry place away from direct sunlight. You can
use the cord wrap facility (specic types only) to store the mains cord
in an organised way.
- You can store brush heads on the pegs at the back of the charger.
Loading...