Philips continuously strives to improve its products.
Therefore, Philips reserves the rights to revise this user
guide or withdraw it at any time without prior notice.
Philips provides this user guide “as is” and does not
accept, except as required by applicable law, liability for
any error, omission or discrepancy between this user
guide and the product described. The device is meant to
be connected to GSM/GPRS networks.
Screen
Right
softkey
Hang up and
on/off key
Alphanumeric
keypad
How to ...
Switch the phone
On/Off
Store numbers in
Phonebook
Make a callEnter the phone number
Answer a callPress
End a callPress
Reject a callPress
Adjust earpiece
volume
Access ContactsPress
Access main menuPress
Access to SMS
editor
Access to date and
time settings
Long press ).
Enter the phone number and
press
L
to save.
using the keypad and press
(
to dial.
(
when your phone
rings.
)
.
)
when your phone
rings.
+
or - during a call.
Press
-
or R in idle mode.
L
in idle mode.
>
in idle mode.
Press
<
in idle mode.
Press
Access to volumePress
Access to Call listPress
Switch to silent
mode
Return to previous
menu
Quickly return to
idle mode
+
in idle mode.
(
in idle mode. The
call list displays the calls
missed, the incoming calls
and outgoing calls.
Long press
mode to toggle between the
silent mode and normal
mode.
Press
Press
R
)
.
.
*
key in idle
The Left/ Right key
Press the left and right soft keys L and R located at
the top of the keypad to perform the function
displayed at the bottom of the screen.
1
Table of contents
1. Getting Started ................................. 4
Insert the SIM card .......................................... 4
Switch on the phone ....................................... 5
Charge the battery .......................................... 6
Please read the safety instructions in the “Precautions”
section before using your phone.
To use your phone, you must insert a valid SIM card
supplied by your GSM operator or retailer. The SIM
card contains your subscription information, your
mobile phone number and a memory in which you
can store phone numbers and messages.
Insert the SIM card
Follow the steps below to insert your new SIM card.
Remember to switch off your mobile phone before
removing the back cover and battery.
Remove the back cover
To insert the SIM card, you must first remove the
back cover. Press on the back cover with your thumb
and slide the cover downwards. Then use your free
hand to lift up the door of the battery compartment as
shown below.
4Getting Started
Remove the battery
To remove the battery, lift up the battery from the
bottom as show below.
Insert the SIM card
Make sure the clipped corner of the SIM card is facing
the correct direction and the metallic contacts facing
downwards. Slide the SIM card into the SIM card slot
until it stops.
Replace the back cover
Replace the back cover by sliding it up into its slot,
until it stops.
Replace the battery
Slide the battery back to its slot, with the gold contacts
facing downwards until it stops. Then lock it by
pushing it downwards.
Remove the protective film covering the screen before
using the phone.
Switch on the phone
To switch on the phone, long press ) key. Enter the
PIN code if required. It is preconfigured and
communicated to you by your operator or retailer. For
more information on PIN code, see “Security”.
If you enter an incorrect PIN code three times in
succession, your SIM card will be locked. To unlock it,
you must obtain the PUK code from your network
operator.
Getting Started5
Charge the battery
Your phone is powered by a rechargeable battery. A
new battery is partially charged and an alarm will warn
you when the battery level is low. If the battery is
empty, it needs to be charged for 2 or 3 minutes
before the battery symbol indicators flash. Plug the
charger into the charger connector at the top left side
of the phone as shown below. Then plug the other
end of the charger into an AC power socket.
The battery symbol indicates the state of charge. The
charge indicators will scroll when the battery is
charging. The battery is fully charged when the charge
indicators stop scrolling. You can then disconnect the
charger.
Keeping the charger plugged to the mobile phone
when the battery is fully charged will not damage the
battery. The only way to disconnect the charger is to
unplug it, so use an easily accessible AC power socket.
If you are not using your phone for a period of time,
we recommend that you remove the battery.
You can use your phone while it is charging. When the
battery is completely discharged, the charge indicators
will appear only after a few minutes of charging.
6Getting Started
2. Calling
Make a call
From idle screen
1. In idle mode, enter the phone number using the
keypad. To correct an error, press
2. Press
3. Press
To make an international call, long press 0 to insert
the international prefix “+”.
(
to dial the number.
)
to hang up.
Using the phonebook
1. Press - or R in idle mode.
2. Select a contact from the list and press
the selected number. To select a different
number, press
information).
3. Press
)
+
or - (see “Contacts” for more
to hang up.
Make an Emergency call
Without a SIM card in phone, you can press
(SOS) to dial emergency call.
With a SIM card in phone, you can enter emergency
number in idle mode, then press
(
R
.
(
to dial
L
.
In Europe the standard emergency number is 112, in
the UK it is 999.
Answer and end a call
When there is an incoming call, the number of the
caller may be displayed if the caller has chosen to
display his or her identity. If the number is stored in
the phonebook, the corresponding name will be
displayed instead of the number.
• To an sw e r t he c al l: press
•
To reject the call:
• To ha n g u p: press ).
The phone will not ring when it is in silent mode.
If you have activated Any key in Settings > General >
Answer mode, you can answer a call by pressing any
key, except
)
.
press ).
(
.
Options during a call
During a call, press R to activate Handsfree mode or
L
Options to access the following options:
- Mute the call
-Put the call on Hold
- End Call
- Access Main Menu
- View Contacts
Calling7
Adjust earpiece volume
During a call, press + or - navigation key to increase
or decrease the volume.
Handle multiple calls
You can handle two or more calls at the same time, as
well as make conference calls using your phone. The
availability of this feature is dependent on your
network operator and/or subscription.
Make a second call
You can make a second call when there is an active call
or with a call on hold. While on the phone, dial the
number (or select a contact from the phonebook) and
press
(
. The first call is put on hold and the second
number is dialled. You can press
following Options:
• Mute the call
• Switch to toggle between 2 calls
• Establish a Conference call
• End All to end all current calls
• Access Main Menu
• View Contacts
L
to access the
To be able to receive the second call, you need to
deactivate Call divert (see page 22) and activate Callwaiting (see page 22) functions.
Answer a second call
When you receive a second call while already in
communication, the phone will emit a beep tone and
the screen displays information about the incoming
call. You can then:
Press
(
)
Press
L
OptionsTo access options list. You can
Press
To answer the call (the first one
is put on hold).
To reject the call.
select to:
• Mute the call
• Switch to toggle between 2 calls
• Conference Call to introduce
the caller into a conference call
• End All to end all current calls
• Access Main Menu.
• View Contacts
8Calling
*
3. Text or number Entry
Input Method
Your phone supports 3 types of input methods:
Multitap ABC/Abc/abc
Numeric
Symbols
During text editing, short press
multitap and numeric mode. The status bar at the top
of the screen will display the current input method.
, and represent Multi-tap upper, Smart
Multi-tap and Multi-tap lower case English input and
represents numeric input.
To switch between languages, during text editing,
press
L
Options and select Input language.
Function keys
R
Delete the characters on the left of the
cursor or exit from editing mode.
+/-/</>
Move the cursor or select a symbol from the
list.
)
Return to idle mode.
L
Enter Options menu.
#
to switch between
Enter symbols.
#
Switch between multitap and numeric
mode.
Multitap ABC/Abc/abc Input
1. Press once on the numeric key (2 to 9) to
enter the first letter on the key, press twice to
enter the second letter on the key, so on and so
forth. If the letter you wish to enter and the one
you have just entered are on the same key, just
wait for a few seconds for the cursor to re-appear.
You can press key 0 to insert a space in abc/Abc/
ABC Multitap input mode.
The letters located on each key are as follows:
R
to delete the characters on the left of
the cursor.
Key Characters in the order displayed
1
, . ? ! @ 1
2
a b c 2 å æ ä à ç á
3
d e f 3 è é
6
Text or number Entry9
4
g h i 4 ì í
5
j k l 5 £
6
m n o 6 ö ø ò ñ ó
7
p q r s 7 β $
8
t u v 8 ù ü ú
9
w x y z 9
0
0
Numeric input
1. Short press # to toggle between input method
and to enter the numeric mode.
2. To delete a number, press
R
.
Symbol Input
Press * to enter punctuation or symbols. Use the
navigation keys to select the desired punctuation or
symbol and press
L
OK to enter it.
10Text or number Entry
4. Messaging
SMS
This menu allows you to send text messages using
Short Messaging Service (SMS), as well as manage the
messages you have sent and received.
New SMS
To compose and send an SMS, select New SMS.
When you finish writing your message, press
Options access the next options:
Send Send the message
Save as draftSave the message in drafts folder.
Input language Switch between languages during
When the message is completed, press
Send to send your message. Input a new number or
select a contact from your phonebook. You can send
it up to 5 recipients. Press Options > Send to confirm
and send your message. Select Add Recipients. Press
L
to confirm.
text editing.
L
L
Options >
When you send a message via the SMS network, your
phone may display Sent Successfully. This means the
message has been sent to the SMS center which you
have set in your SIM card. However, this does not
imply that the message has been sent to its destination.
Inbox
This menu allows you to read the SMS messages
which you have received. The messages are displayed
in a list. You can select a message and press
to access the following menu options:
ViewView the selected message.
ReplyReply to the sender.
ForwardForward the selected message.
CallCall the sender.
Store Number Save the number of the sender.
MoveMove the message to your phone or
SIM.
DeleteDelete a selected message.
Delete allDelete all messages in the Inbox.
L
Options
Outbox
When you select Autosave SMS in message settings,
the sent message will be stored in Outbox.
Messaging11
Loading...
+ 27 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.