PAN11-1/-2/-3
Introduction
Smart Energy Plug-in Switch
Z-Wave Series
Features
Adopt Z-Wave protocol to secure the success of wireless two
way communication
Higher RF output power (+2.5dBm output power as compared to
-2.5dBm 300 series Z-wave module) to enhance the
communication range
With zero crossing technology to extend the number of switching
Easy install
Very low Electricity consumption ,
Resistive load 3000W, 1500W for incandescent load or 320W for
fluorescent load
Overload protection
Auto report the state when manually push the ON/OFF button
Auto report the wattage when variation over 5%
Voltage, Current, Power factor, Instant power Wattage and
Accumulated power consumption KWh report
Z-Wave V6.02
Z-Wave Certificated
PAN11-1 ZC08-13020005
PAN11-2 ZC08-13020006
PAN11-3 ZC08-13020007
LVD:EN 61058
R&TTE : EN 301489, EN 300200,
This smart energy plug-in switch is a transceiver which is a Z-WaveTM enabled device and is fully compatible with any Z-WaveTM
enabled network. Z-WaveTM enabled devices displaying the Z-WaveTM logo can also be used with it regardless of the manufacturer,
and ours can also be used in other manufacturer’s Z-WaveTM enabled networks. Remote On/Off control of the connected load is
possible with other manufacturer’s Wireless Controller. Each switch is designed to act as a repeater. Repeaters will re-transmit the
RF signal to ensure that the signal is received by its intended destination by routing the signal around obstacles and radio dead
spots.
This smart energy plug-in switch is able to detect voltage, current, power factor, Instant power wattage (5~3150W) and overload
wattage (3010~3300W) of connected light or appliances. When detecting overload state, the Module will be disabled and its On/Off
button will be lockout of which LED will flash quickly for 30 seconds. However, unplug and re-connect the Module will reset its
overload condition to normal status.
This plug-in switch can active sent out instant power wattage when variation over 5% or active sent out state change when
manually push the ON/OFF button , this allows the controller to avoid polling the reading wattage value and state of the switch and
can increase the efficiency of controller.
Specification
Power
RF
Mechanical
Environment
Load
No load standby power
Input voltage
Frequency
Regulation
Distance
weight
Dimension (W x H x D)
Operation Temperature
Humidity
Resistive load
incandescent load
fluorescent load
load return error rate 5W~40W
load return error rate40W~3150W
overload
0.48W (230V)
90 ~240VAC
868.42 (EU) MHz
FCC part15.249 / EN300 220-1/
min. 30m indoor min. 100m outdoor
118 g
57.7x94.5x76.6 mm (Germany type PAN11-1)
0 ~ 40° C
85%RH max
3000W
1500W
320W
±3W
±5%
3300W
1
Dimension and Placement (unit:mm)
Germany type PAN11-1
57.7x94.5x76.6 mm
PAN11-1/-2/-3
France type PAN11-2
57.7x94.5x76.6 mm
UK type PAN11-3
57.7x94.5x61 mm
Application:
Home Automation
Energy Saving
Philio Technology Corporation
www.philio-tech.com
2
Loading...