PHILCO SPDE28W installation Guide

Instruction Manual and Installation Instructions

Easy Detachable Range Hood Series

en cn

ENVIRONMENT OF OPERATION:

This appliance is designed for home or indoor environment commercial

PRECAUTIONS:

Please read this instruction manual carefully before installation.

During the installation, power supply must be disconnected.

During

1. The installation should be carried out by a qualified technician.

2. Air ventilation inside kitchen must be maintained in good condition when cooker hood is used.

3. Do not put flame on the range hood. Please turn on hood before turning on the hob.

4. Repair service including replacement of main cord should only be

carried out by a qualified electrician.

5. Cleaning process should follow the instructions as stated in this manual, could not change or move parts against instruction to avoid danger or damage.

6. In case of lamp broken, please disconnect the power before change. Release the whole bottom damper to change the old lamp. Maximum power is 40W lamp.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

8. In case of changes in technical specification, there would be no prior notice.

use.

the installation, power supply must be disconnected.

and not for

PDE28S PDE28W

INSTALLATION:

This appliance must be earthed. Installation must be carried out only when power supply is disconnected.

1. Unpack the carton.

2. Detached the fan grille by removing the screws, then take polyform

out from inside and reinstalled grille.

. The air must not be discharged into a flue that is used for exhausting

fumes from appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room ), regulations concerning the discharge of air have to be fulfilled.

4. The installation height is measured vertically from the bottom of hood to the top of stove, the minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the range hood. When the range hood is located above a gas appiliance, this distance shall be at least 650mm and the best recommended height is 650-800mm, avoid left-right or up-down inclination.

5. This hood could be wall-mounted or built-under kitchen cabinet.

6. 6-inch diameter exhaust duct is recommended to use in order to

maximize suction efficiency. In case of 5-inch exhaust duct, an adapter is enclosed. To increase the efficiency of hood, the length of exhaust duct should be minimized, and avoid acute turns.

7. Check the voltage on the rating label which should match the national

or local code.

Wall Mounting Instruction

Built-under Instruction

Cabinet

Insert the screw

Mount the hood

Electrical Switch

Rlease the bottom

damper and screw it

tightly

Oil Cup

Grille

MAIN FUNCTION:

1. 3-fan speed control to suit different types of cooking.

2. The inner exhaust chamber is coated with easy cleaning layer resulting in a more efficient cleaning.

3. The newly designed oil collecting device in 15 effectively drain the oil and water entirely. Efficient centrifugal impeller to separate oil and smoke.

Lamp

Bottom damper

Insert the screw

Unscrew the screws

then pull up to the end

and lock tightly

Align the Hanging

Bracket holes mounting

the hood on the wall

Wall

OPERATION:

Hanging Bracket

1. Button

Press once for lamp on and second for off.

2. 1 2 and can turn on the range hood, press twice turn

3 off. 1 is the low speed; 2 is the medium speed; 3 is the high speed, adjust the fan speed from 1 to 3 according to your requirements.

3.Turn off the hood when not using .

Low

Medium

High

Lamp

MAINTENANCE AND CLEANING:

PERFORMANCE AND DIMENSIONS:

Caution: Always disconnect the machine from the power supply

before cleaning.

1. Please clean your hood regularly, do not use abrasive cleaner. Always clean the oil cups and retainers by detaching or turning in anticlockwise and re-install, to prevent oil spillage and prolong the life of the hood.

2. After each operation, please wipe the machine with a dry cloth or a wet cloth.

3. Must use only foamless hood cleaner for cleaning process to avoid damage to the hood. Dilute the hood cleaner with water for cleaning. (we recommend water to cleaner=20:1 to save the environment, as the inner compartment is coated with easy clean layer that makes cleaning very easy.)

4. Remove all utensils and food from stove before cleaning the hood.

5. This machine is equipped with auto out off device when the damper is dismantled.

6. Do not distort the exhaust fan, do not use abrasive cleaner.

WIRING DIAGRAM:WIRING DIAGRAM:

lamp

transformer

white

black

Right

Motor

red

blue

orange

PCB

123 lamp

plug

safety switch

brown

yellow/green

blue

black

Left

Motor

red

black

PCB

orange

MODEL

PDE28S

PDE28W

RATED

VOLTAGE

220V-240V~

RATED

FREQUENCE

50Hz 80W 2 40W

MOTOR

WATTS

LAMP

WATTS

MAX.

W705 D520 H136

SPECIFICA TIONS MA Y CHANGE WITHOUT PRIOR NOTICE.SPECIFICA TIONS MA Y CHANGE WITHOUT PRIOR NOTICE.

MOUNTING DIMENSIONS DIAGRAM

24mm

61.6mm

655.8mm

705mm(Width)

30mm

136mm

(Height)

141.3mm

235mm

520mm(Depth)

693mm

12mm

152mm

DIMENSION

(mm)

white

blue

yellow

blue

yellow

white

+ 4 hidden pages