T E C H N O L O G Y
R
Custom Installation Series
Owners Manual / Installation Instructions
Box contents
1 Speaker
1 Grille
1 Paint mask
1 Cutout hole template
1 Euroblock connector
Power FL-8 Power FL-10 Power FL-12
CI-15
Pre-construction bracket (sold separately)
Grille safety clip
Paint mask
SpeedWing™ mounting arms
Euroblock connector
Grille
MSE Audio Group 8650 College Boulevard Overland Park, Kansas 66210 (888) PHASE-TK
www.mseaudio.com www.phasetech.com
T E C H N O L O G Y
R
Installation Instructions: Installing the
CI-15 in an Existing Wall
1. Unpack speaker. Leave
paint mask in place until
after speaker is installed or
painting is complete.
5. Insert speaker in hole.
Tighten the two clamping
screws. DO NOT
OVERTIGHTEN.
2. Use provided cutout
template to mark hole. Use
RotoZip or other tool to cut
hole in wall. Hole size: 4 in.
(102 mm) tall x 4 in. (102
mm) wide.
6. Remove paint mask
unless painting is required.
In that case, follow steps
7-10 when painting is
complete.
3. Connect Euroblock to
speaker wires, and connect
to speakers.
7. Adjust tap switch to
proper setting. Switch is
preset to the 8-ohm mode.
4. If required, attach
seismic restraint system to
the hole in the metal
clamping arm, then to
reinforced structure (safety
cable not included).
1.
2.
8. Attach grille safety clip
by placing the large end of
the clip over snap-fit post
(1), then sliding clip until
small end snaps into place
around post (2).
9. Align tabs on snap-fit
grille with slots in baffle,
gently press grille into place.
10. Done!
T E C H N O L O G Y
R
Installation Instructions: Installing the CI-15
Using the Pre-Construction Bracket
1. Nail or screw bracket to
studs.
5. Connect Euroblock to
speaker wires, and connect
to speakers.
2. Finish installing wall. 3. Use RotoZip or other tool
to cut hole.
6. If required, attach
seismic restraint system to
the hole in the metal
clamping arm, then to
7. Insert speaker in hole.
Tighten the two clamping
screws. DO NOT
OVERTIGHTEN.
reinforced structure (safety
cable not included).
4. r. Leave
Unpack speake
paint mask in place until
after speaker is installed or
painting is complete.
8. Remove paint mask
unless painting is required.
In that case, follow steps
9-12 when painting is
complete.
9. Adjust tap switch to
proper setting. Switch is
preset to the 8-ohm mode.
1.
2.
10. Attach grille safety clip
by placing the large end of
the clip over snap-fit post
(1), then sliding clip until
small end snaps into place
around post (2).
11. Align tabs on snap-fit
grille with slots in baffle,
gently press grille into
place.
12. Done!
Loading...