Phantom Star Phantom ULB42V, Star Phantom ULB42, Star Phantom ULB44 Installation And Instruction Manual
INSTALLATION AND INSTRUCTION MANUAL
The
The
Star Phantom
Star Phantom
Undercover Interior Discrete LED Lightbar
Models
ULB42V ULB42 ULB44
Value Phantom Phantom Starburst Phantom
®
IMPORTANT: Please read all of the following instructions before installing your new warning light.
PLITSTR299 REV. J 5/20/14
Please Note: These instructions are provided as a general guideline only. Specific
mounting and/or wiring, may be necessary and are the sole responsibility of the
installer. Star Headlight & Lantern Co., Inc. assumes no responsibility for the
integrity of the installation for this or any of its products.
Mounting
The
Star Phantom
®
line of lights is designed to be
mounted on the inside of your vehicle. They are not intended for
exterior applications and are not warranted against water damage.
It is the sole responsibility of the owner to ensure the warning light is
secure. Check your light every time you enter the vehicle to ensure that
it is mounted securely. The manufacturer assumes no responsibility for
the secure mounting of this light.
The following mounting instructions describe the standard, most common way to
mount this light. This method may or may not apply to your vehicle. Because
vehicles can vary widely in their design, it may be necessary to configure the brackets
differently than described. Some applications may require you to design your own
custom brackets. The installer assumes all responsibility for the integrity of the
installation. It is the sole responsibility of the owner to ensure the light is secure.
P30073-4
(QTY=12)
#8 FLAT WASHERS
P30054-27
#10-32 x 1/2" CARRIAGE BOLT
(QTY=2)
P30076-8
1/4" FLAT WASHE R
(USE AS SPACER )
(QTY=2)
P30150-220P
ATTACHING BRACKET
(QTY=2)
P30150-79P
FORKED "L" BRA CKET (Style 1)
P30150-189P
FORKED "L" BRA CKET (Style 2)
(QTY=2)
(QTY=2)
-1-
P30094-10
#10-32 SERRATED
FLANGE NUT
(QTY=2)
Mounting (CONT'D)
These lights are designed to
be mounted in the front
windshield of a vehicle using
the pre-existing visor clips.
1. Slide the enclosed rubber
channel over the front edge
of the baffle .
2. Insert a carriage bolt through one of the
1/4” washers and slide it through the back
of each of the long L-brackets. Please
note that washer is used as a spacer on
the square neck of the carriage bolt.
3. Remove the four of the #8 Phillips head screws shown to the
right from the light and add the # 8 washers. Use them to
install the long L-brackets.
CAUTION: Take extreme caution not to over
tighten the screws!!!
P30073-4 (QTY=4)
#8 FLAT WASHERS
-2-
4. Attach a forked bracket to each
L-bracket using one of the nuts.
Note: There are two different style
forked brackets included. Use the
one that suits your application
best.
Leave the nut slightly loose to
allow for minor adjustments during
the remainder of the installation.
Loading...