Phanteks Glacier G2070 Strix User Manual
GLAC IER G2070
ASUS STRIX
PH-GB2070AS_BK01/CR01
PACKAGE CONTENTS
GLACIER GB2070AS
QTY: 1
GLACIER Stop Fitting
QTY: 2
Thermal Pads
QTY: 2
M2.5x5 Screws/Washers
QTY: 10/10
INSTALLATION GUIDE V1.0
For latest version check www.Phanteks.com
Thermal Compound
PH-NDC-01
QTY: 1
Phanteks D-RGB Cable
QTY: 1
WARNING - This product is intended for advanced users. Improper installation may result in damage to your equipment. While all eorts have
been made to provide the most comprehensive information possible, Phanteks assumes no liability expressed or implied for any damage(s) occurring to your
components as a result of using Phanteks cooling products, either due to mistake or omission on our part in the below instructions, or due to failure or defect in
the Phanteks cooling products. Do not disassemble the water block. Warranty will be voided.
Turn o the power to your system and discharge your body’s static electric charge before proceeding with the installation procedure. If you do not feel comfortable
with performing the installation procedure, consult a qualied computer technician.
STEP 1. REMOVING STOCK COOLER
Unscrew all highlighted screws to remove
the stock cooler, backplate and heatsink.
Make sure to unplug the LED and Fan
cables when you remove the stock cooler.
Take the EVA-Foam from the box to use
as a base for your installation process.
STEP 2. APPLYING THERMAL PASTE & PADS
Clean o the original thermal compound.
We recommend using isopropanol alcohol.
Apply a drop of the Phanteks Thermal
Compound to the center of the GPU chip
RTX 2070
1
3 3 3 3 3 3 3 3
2
Save these screws for step 3.
3 3 3 3
3
3
1 2
3
3
Remove the protective lm and place the
the thermal pads on correct position on
the PCB.
Make sure to remove the protective lm on
both sides of the thermal pads.
RTX 2060
3 3 3 3 3 3
3 3 3 3
1
2
3
3
1 2
STEP 3. RE-INSTALL THE BACKPLATE
Carefully position the backplate onto the
graphics card. Align the mounting holes on
the PCB with the holes on the backplate.
Secure the backplate with 9 M2x5mm
screws to the PCB.
Use the original screws from step 1.
9x
STEP 4. MOUNT THE WATER BLOCK
Carefully position the water block onto the
graphics card. Align the mounting holes on
the PCB with the holes on the water block.
Secure the water block with 6 M2.5x5mm
screws and washers to the PCB.
Make sure to lay the GPU with the water
block at down without resting on the
PCI bracket.
STEP 5. CONNECT D-RGB LIGHTING
Connect the D-RGB cable to the D-RGB strip
in the water block.
6x
6x
All Phanteks D-RGB products can be
daisy-chained together.
You can connect the D-RGB cable to a
compatible motherboard with the cable
that is included with the motherboard.
STEP 6. INSTALLING FITTINGS
Install G1/4 threaded male ttings and
close the remaining ports with the two
included Stop Fittings.
Always perform a leak test before providing
power to any system components.
Connect to
Phanteks Case / Motherboard Cable
Loading...