Pfister E27-BNFC User Manual
Wall Mounted Single Control Kitchen Mixer
Mezcladora Monocomando a la Pared de Cocina
Mélangeur Monocommande à Montage Mural
E27-BNFC
09-12-03 ECN5950A 28526-0100
Copyright © 2003, Price Pster, Inc.
1
A COMPANY
ENGLISH
Thank you for purchasing this Price Pster kitchen faucet. All Price Pster products are carefully engineered,
and factory tested to provide long trouble-free use under normal conditions. This kitchen faucet is easy to install
using basic tools and our easy to follow illustrated
instructions. If you have any questions regarding
your kitchen faucet installation call 1-800-Pfaucet
6
6A
6B
(1-800-732-8238).
BEFORE PROCEEDING
Locate water supply inlets and shut off the water
2
supply valves. These are usually found under the
sink or near the water meter. If you are replacing an
existing faucet, remove the faucet from the sink and
clean the sink surface thoroughly.
TOOLS RECOMMENDED
Pliers
Flashlight
9/16” and 11/16” open end wrenches
Adjustable wrenches (optional)
Plumber’s putty
Flaring tool (for copper tube installations)
6B
6A
Ensure that plastic putty plate (A) is pressed on to
deck plate (B). Place a bead of plumber’s putty in
7
7A
7B
7C
7C
Your installation may require supply tubes and / or
shut-off valves.
5
1A INSTALLING OPTIONAL DECK PLATE
5A
5B
5C
5A
Model E27-FNFC is shown
(For single hole mount, go to step 1B)
the goove along the outer edge of the putty plate
(A). Install the deck plate (B) over the three holes
8
8B
8A
8C
in your sink. From underneath sink, hand tighten
wing nuts (C). Caution: do not over tighten wing
2
9
Thank you for purchasing this Price Pster kitchen
faucet. All Price Pster products are carefully
10
ENGLISH
tubes (B), and press onto faucet body (C). Note:
The tabs on the faucet body (C) must be aligned
to the grooves inside the single post ring (B). To
ensure this is the case, rotate the single post ring
(B). When the tabs are aligned, the ring will cease
to rotate.
2A INSTALLING THE FAUCET USING THE
OPTIONAL DECK PLATE
Ensure that the mounting gasket (A) is pressed
frimly in to the faucet body (B). Feed the pull-out
hose (C) up through the faucet body (B), until the
pull-out hose tting is ush with the bottom of the
mounting shank (D) (see illustration). Insert the
faucet supply tubes (E) and mounting shank (D)
through the hole in the deck plate (F). Note: The
tabs on the faucet body (B) must be aligned to the
grooves inside the deck plate (F). To ensure this is
the case, rotate the faucet body (B) back and forth.
When the tabs are aligned, the faucet will cease to
10B
10A
10C
10D
10E
nuts. Remove any excess putty from around the
outside edge of the deck plate (B). To continue with
the installation, go to step 2A.
1B INSTALLING SINGLE POST RING
Pass single post ring (A) over copper inlet / outlet
Any questions or concerns on Price
Pster products, contact your local Price
Pster distributor or point of contact.
3
Loading...