
As shown, put
battery(CR2032) into the
battery battery compartment.
Install introductionOverview How to wear P1 for pet Begin to experience Services and support
Screw the battery cover
with the opener clockwise
to the end.
After battery cover was
complete closed, the LED
indicator in the front will blink
three times. That means P1
start working.
Close the battery cover align
to the anchor shown in below
figure.
Put the one side of P1 into
accessory.
Put the band in one side of
accessory as shown in below
figure.
Pull the band cross over the
pet collar and end at the
other side of accessary.
Push the other side of P1 till
hearing the sound of click.
Scan to download PETKIT from app
store for ios devices and google
player for android devices.
P1 is IP67 dust and water resistant. That means your pet
can wear P1 when swimming or bathing.
P1 has well-tuned power consumption performance. One
cell-battery can last for 4 month in normal usage frequency .
P1’s wireless solution is based on Bluetooth 4.0 low energy
technology.
All the materials used by P1 is recyclable.
Please put the empty battery to battery collection point.
Scan to join PETKIT‘s
after-sales services
(available for “WeChat”
users).
Get more information
from website.

FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Note: Modifications to this product will void the user’s authority to operate this equipment.