PerTronix D926 User Manual

Corporate Office: PerTronix Inc. 440 E. Arrow Highway, San Dimas, California 91773 * Phone [phone] * FAX [phone] * www.dougsheaders.com

Y PIPE INSTALLATION INSTRUCTIONS

PART NUMBER: D926

99-05 Chevrolet/GMC 2 WD Pickup 4.6-6.0L

For use with D3354 Headers

PerTronix©

to realize the full potential of our good fit, please read and understand these instructions completely prior to starting work.
Check to make sure you received the proper parts for your application. The header number will be stamped on the engine

flange. If you are unsure you have received the proper parts call before you start work.
Be sure to work safe! Whenever you work under the vehicle be sure that it is located on level, solid ground and is supported

by adequate safety stands! Remember: Hot asphalt will not support most jack stands!
Many factors affect the installation of headers, some of which are broken or aftermarket motor mounts, accidents that impact the

configuration of the frame, and/or the installation of different engines or aftermarket cylinder heads.
Attention Customers breaking in new engines: Due to the extreme heat generated during the break-in process, the

appearance of the ceramic coating may be altered in certain areas. The protection characteristics and thermal barrier properties
of the coating is never compromised. It is recommended that a cast iron manifold or old set of headers be used for this process.

Notice: The coating of these headers can be marred or scratched during installation. If the header needs to be returned and is
damaged, you will be charged for recoat.

thanks you for choosing

DOUG’S HEADERS

, the best fitting, highest quality header on the market. In order

DISASSEMBLY

1. Disconnect the negative battery cable from the battery.

2. If a car lift is not available, raise the vehicle 2 feet or higher and support with adequate
safety stands. Make sure the vehicle is on a flat solid surface and is stable.

3. Remove the factory Y Pipe from the truck.

INSTALLATION

1. Bolt the Doug’s Y Pipe to the Doug’s headers using the gaskets and hardware supplied
with the headers.

2. Bolt the factory intermediate pipe to the Doug’s Y Pipe using the original hardware.

3. Connect the negative battery cable.

Part No. 0110-003089 Page 1 of 2 rev. 1 11-19-13 DSL

IMPORTANT CHECK LIST

Be sure that all brake lines and fuel lines are clear of headers and/or connector pipes.
All spark plug wires, battery cables, or other electrical components should be clear of

headers and/or connector pipes.

If dipstick tube was removed, make sure it is installed properly and that the dipstick has

been replaced.

Double-check the tightness of all bolts including brackets and accessories.

STARTING THE ENGINE

Start the engine and allow it to warm up to operating temperature. Check for any unusual
noises or exhaust leaks. If every thing is OK, stop the engine and tighten all bolts while
the engine is still warm.
NOTE: Check the bolts periodically to make sure they have not loosened. Re-tighten
after the first 500 miles and then again at 1000 miles.

PARTS LIST

Qty Description

1 Y Pipe
2 Doug’s Stickers

Part No. 0110-003089 Page 2 of 2 rev. 1 11-19-13 DSL