PerTronix 6696SXC User Manual

y p

Product and Warranty Information

For 2007 Ford Mustang GT500

P/N 6696SXC

(1) X-Pipe with Catalytic Converters

NOTE: Installation of this product requires an adequate workspace, general mechanic’s tools,

general mechanical “know-how” and a reasonable degree of experience. Most auto
enthusiasts with these resources will have little difficulty installing these mid-pipes. However,
you should carefully read these instructions before attempting to install these mid-pipes. If in
doubt, consult a professional mechanic. (Better to do it now than to get stuck halfway through
the installation.) This part is certified for use on Emission Controlled Vehicles.
JBA Performance Exhaust assumes no responsibility for damages resulting from improper
operation, misuse, abuse, or lack of responsible care, or any problems resulting from
incompatibility with other manufacturer's products.

Included with your installation instructions is a copy of the product warranty. Please read it
carefully before you begin any work on your vehicle. Should you have any questions about the
warrant

olicy or installation, please give JBA a call at 619 229-7797.

Rev. 04-07

LIMITED LIFETIME WARRANTY

All products manufactured by JBA are guaranteed to be free from defects in materials and workmanship at

the time of sale. All products are guaranteed to fit the intended application, provided the vehicle has not

suffered structural damage or other modification*. Claims for damage occurring during shipment must be

made to the carrier. JBA, at its option, will repair or replace any product found to be defective in materials or

workmanship.

Failure of any JBA product while on the originally installed vehicle, will entitle the origin al purchaser to repair,

replacement, or pro rata credit according to the following chart:

Up to 2 years from the date of purchase JBA will repair or replace at its option

After 2 years JBA will allow credit of 50% of the current price

Certain uses or occurrences listed below will void this warranty.

PURCHASER ASSUMES RESPONSIBILITY: JBA expressly disclaims, and the purchaser expressly
assumes, responsibility for all labor related costs and any incidental or consequential damages arising from
any JBA product installation or failure. JBA’s liability is limited to the purchase price of the product. JBA, at
its option, may refund the amount of the purchase to end a warranty claim. Labor charges incurred to install
or remove the product are not covered. Damage resulting from incorrect timing, fuel system problems,
clogged catalytic converters or backfire is not covered. Charges for the loss of use of vehicle, car rentals,
and towing are the responsibility of the customer and are not covered. Cost of customer-applied coatin gs is
not covered. As sound preference is subjective, sound is not warranted. Other than the warranty described
herein, JBA products are sold “AS IS”. No warranty terms are implied. The terms of this warranty are
severable. Any provision voided by state or other applicable law shall not act to enlarge other provisions of
this warranty except as expressly required by law. Catalytic converters and other products sold but not
manufactured by JBA are subject to the product manufacturer’s warranty only and are not warranted by
JBA.

THE FOLLOWING WILL VOID THIS WARRANTY: Use of “ heat-wrap” products and/or the use of fuels
other than gasoline will void this warranty. Damage caused by improper installation is not covered under this
warranty. Damage caused by collision, road hazards, or failure of other components is not covered. Any
repair or alteration to a JBA product not performed by JBA or its authorized agents will void this warranty.

NO FREIGHT WARRANTY: JBA does not warrant freight. The purchaser will be responsible for freight to
and from JBA. Contact JBA to make a warranty claim and to receive a return authorization number. Return
the product freight prepaid along with a copy of the original purchase invoice and a written description of
the problem including the return authorization number to the address below. JBA does not accept freight­collect shipments. A product found to be defective or otherwise covered under this warranty will be repaired
or replaced per the above policy and returned freight-collect.

JBA cannot assume responsibility for compliance with local law and regulations regarding smog and noise
standards. Headers described as “smog legal” are warranted to be C.A.R.B. (California Air Resources
Board) exempt or pending exemption approval. This warranty is extended solely to the original purchaser
and for the original vehicle on which the product was installed.

JBA reserves the right to change the design, material, or specifications of any

product without notice.

Automotive Engineered Products, Inc.

dba JBA Headers and Performance Exhaust

7149 Mission Gorge Road, Suite D

San Diego, California 92120

Copyright 2005 by Automotive Engineered Products, Inc. All rights reserved.

* Note that certain custom headers may require different engine mounts or brackets for proper fit.

[phone]