Permasteel Pg-50410s0lb-1 Owner's Manual
FOR OUTDOOR USE ONLY
GAS GRILL USER’S MANUAL
MODEL NUMBER: PG-50410S0LB
CUSTOMER SERVICE: (888)-287-0735
DANGER
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, keep away from the
appliance and immediately call your gas
supplier or your fire department.
WARNING
1. Do not store or use gasoline or other
flammable liquids or vapors in the
vicinity of this or any other appliance.
2. An LP cylinder not connected for use
TM
shall not be stored in the vicinity of this
or any other appliance.
LIMITED WARRANTY
Model Number: PG-50410S0LB
PermaSteel Stainless Steel BBQ Grill
We warrant to the original con sum er p urc ha s er (“Purc h as er”) of th e P erm aSt eelStainless Steel
BBQ Grill (“Product”) that each Product shall be free from defects in workmanship and materials
for a period of the years listed below from the date of original purchase. Our obligation under this
warranty shall be limited to repair or replacement of, or adequate compensation for, the Product, at
the option of us, during the warranty period. Our liability shall not extend beyond repair or
replacement, or the cost equivalent thereto.
This warranty excludes normal wear and tear of the Product and its parts or components, and any
damage arising from any of the following: negligent use or misuse of the Product, use contrary to
this User’s Manual, or alteration by any one other than us. The warranty period of the years listed
below shall not be extended or renewed by the repair or replacement of, or compensation for, the
Product.
If your Product is defective or otherwise requires service or parts, please first call PermaSteel
Customer Service toll-free at (888)-287-0735, between 8:00 a.m. and 5:00 p.m., PST. Please tell
us which model you purchased, the date of purchase, and the problem with your Product. We will
use our very best efforts to honor this warranty, and repair, replace or compensate you for your
Product through your original place of purchase. A copy of your original purchase receipt must
accompany your service request.
Component Warranty Period:
Burners: 1 Year
Flame Tamer: 1 Year
Cooking Grids: 1 Year
Valves: 1 Year
Frame, Housing, Cart, Control Panel,
Igniter, and Related Parts: 1 Year
All Stainless Steel Parts: 1 Year
LIMITATION OF REMEDIES AND LIABILITY
We shall not be liable for any incidental or consequential damages for breach of any express or
implied warranty on its Product. Except to the extent prohibited by applicable law, any implied
warranty or merchantability or fitness for a particular purpose on this Product shall be limited to the
duration of the above warranty. Neither us nor anyone else who has been involved in the creation,
production, or delivery of the Product shall be liable for damages of any type, including but not
limited to any lost profits, lost savings, loss of anticipated benefits, or other incidental or
consequential damages which may arise out of the purchase, use, or inability to use the Product,
whether arising out of contract, negligence, strict tort, or under any warranty, or otherwise, even if
you have been advised of the possibility of such damage or any other claim by any other party.
Our liability for any breach of warranty shall be limited to repair or replacement of th e defective part
or parts as described above. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you. The above
warranty gives you specific legal rights, and you may have other rights which vary from state to
state.
TM
TABLE OF CONTENTS
BEFORE YOU BEGIN
MESSAGE TO OUR USERS PAGE 1
SAFETY SYMBOLS PAGE 1
INSTALLATION & SAFETY PRECAUTIONS PAGE 2
ASSEMBLY
PARTS PAGE 3
STEP I PAGE 5
STEP II & STEP III PAGE 6
STEP IV & STEP V PAGE 7
STEP VI & STEP VII PAGE 8
STEP VIII PAGE 9
STEP IX PAGE 10
STEP X PAGE 11
STEP XI & STEP XII PAGE 13
STEP XIII PAGE 14
POST ASSEMBLY
GAS CONNECTION PAGE 15
LEAK TESTING PAGE 18
FINAL INSTALLATION CHECK LIST PAGE 19
GRILL LIGHTING INSTRUCTION PAGE 20
OPERATING INSTRUCTION PAGE 22
CARE & MAINTENANCE PAGE 25
TROUBLE SHOOTING PAGE 26
FOOD SAFETY PAGE 27
TM
GRILL STORAGE PAGE 27
MESSAGE TO OUR USERS
Thank you for your purchase of our Stainless Steel BBQ Gas Grill. We sincerely wish
you will enjoy using our fine products.
Please read this User’s Manual in its entirety before using the grill.
Please contact our customer service at (888)-287-0735 if you have any questions.
Please read this User’s Manual carefully. Failure to follow the provided instruction
can result in serious bodily injury and/or property damage.
Some parts of this grill may have sharp edges. Please wear suitable protective gloves
to do any required assemble.
IMPORTANT: This grill is intended for outdoor use only and is not intended to be
installed in or on recreational vehicles or boats.
NOTE TO INSTALLER: Leave this User’s Manual with the customer after delivery
and/or installation.
NOTE TO CONSUMER: Leave this User’s Manual in a convenient place for future
reference.
SAFETY SYMBOLS
The symbols listed here are being used through out this User’s Manual. Please pay
special attention to them. The meaning of each of the symbols is listed here:
DANGER– this symbol indicates an imminently hazardous situation which
will result in death or serious bodily injury if not properly followed.
WARNING– this symbol indicates a warning of potential serious bodily
injury if the instructions are not strictly followed. Please be sure to read and
follow all of these messages carefully.
CAUTION– this symbol indicates a potentially hazardous situation which
may result in minor or moderate bodily injury if the instructions are not properly
followed.
1
INSTALLATION/SAFETY PRECAUTIONS
WARNING
READ THIS SECTION FIRST BEFORE INSTALLING THE GRILL
This grill is designed to use LP (Liquid Propane) gas only. Please use the grill with
the regulator supplied by PermaSteel.
The installation of this appliance must conform with local codes or, in the absence
of local codes, with either the National Fuel Gas Code, ANSI Z223. 1, or
CAN/CGA B149.1, Natural Gas Installation Code or CAN/CGA-B149.2, Propane
Installation Code.
The LP-gas supply cylinder is to be constructed and marked in accordance with the
specifications for LP-gas cylinders of the U.S. Department of Transportation
(DOT) or the National Standard of Canada, CAN/CSA-B339, Cylinders,
Spheres and Tubes for the Transportation of Dangerous Goods.
If an external electrical source is utilized, the outdoor cooking gas appliance, when
installed, must be electrically grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical Code, ANSI/NFPA 70-1990,
or the Canadian Electrical Code, CSA C22.1. Keep the power cord of the motor
away from the hot surfaces of the grill while in use. Remove and store the motor in
a dry place when not in use.
This grill is safety certified for use in the United States and Canada only. Never
modify to use in other places. Modification may cause serious bodily injury or
property damage. PermaSteel is not responsible for any modifications, and all
warranties will be void.
PROPANE & GAS WARNING
2
GRILL PARTS DIAGRAM
Notice: This part list is for your reference only, some parts will be different,
please subject to the actual appliance in carton.
3
GRILL PARTS LIST
REF # DESCRIPTION Q'TY REF # DESCRIPTION Q'TY
1 Lid 1 33 Motor 1
2 Temp. Gauge S eat 1 34 Mot or B r ac k et 1
3 Temp. Gauge 1 35 Left Side S helf 1
4 Name Plat e 1 36 Left Side S helf B r ac k et 1
5 Clip Rings 2 37 Towel Rack 1
6 Heat Insulation S eats 2 38 Lid Hinge, S ide B ur ner 1
7 Left Handle Seat 1 39 Side Bur ner Lid 1
8 Right Handle S eat 1 40 Cooking Gr id, S ide B ur ner 1
9 Lid Handle 1 41 Right S ide Shelf 1
10 Fir ebox 1 42 Right Side S helf B r ac k et 1
11 Fir ebox Seat 1 43 Side Bur ner 1
12 Left M ain B ur ner 1 44 Side Bur ner Ignit ion E lec tr ode 1
13 Main Burners 2 45 Side Bur ner Manifold 1
14 Sear ing B ur ner 1 46 Side B ur ner Valve 1
15 Searing B ur ner Ignition 1 47 Knob 1
16 Contr ol P anel 1 48 Left S ide Panel 1
17 Manifold 1 49 Tank B affle 1
18 Main Burner Valv es 3 50 Hose Retaining Ring 1
19 Searing B ur ner Valve 1 51 Back P anel 1
20 Main Burner Knobs 3 52 Right Side P anel 1
21 Searing B ur ner K nob 1 53 Bot tom Panel 1
22 Tank Insulation Panel 1 54 Lower Magnet 1
23 Gr ease Cup Brac k et 1 55 Tank Holder Rubber S tr ap 1
24 Gr ease Cup 1 56 Tank Holder 1
25 Hose Baffle 1 57 Casters without Brake 2
26 Door Br ac k et 1 58 Casters with B rak e 2
27 Upper Magnet 1 59 Right Door 1
28 Rotisserie Kit 1 60 Left Door 1
29 F lame Ta mers 2 61 Ig nition Rod 1
30 Right Flame Tamer 1 62 Door Hinges 2
31 Cooking G r ids 3 63 Door Handles 2
32 War ming Rack 1
4
ASSEMBLY INSTRUCTIONS
Tools Required:
#2 Philips head screwdriver (not provided)
Hexagon/Allen wrench (provided).
The following hardware is provided:
wheItem Description Specification Quantity
1
2
3
4
5
Truss head screw
(With Split lock And Gasket)
Truss head screw
(With Split lock And Gasket)
Truss head screw
(With Split lock And Gasket)
Truss head screw
(With Split lock And Gasket)
Truss head screw
(With Split lock And Gasket)
1/4-20x5/8” 16 pcs
1/4-20x1/2” 32 pcs
5/32-32x1/2” 2 pcs
5/32-32x3/8” 22 pcs
1 pc
STEP I:
Take out bottom panel and four cast ers (two with brakes, two without brakes)
from packing carton.
Use 16 pcs 1/4”-20 x 5/8” screws to attached four casters on the back of
bottom panel. Each caster need 4 screws.
Note: The casters with brake should be mounted on the side closer to tank
hole.
5
ASSEMBLY INSTRUCTIONS
STEP II:
Use 2 pcs of 5/32"-32x1/2” screws to attach the door magnet on the bottom.
Use 2 pcs of 1/4”-20x1/2” screws to attach the back panel on the bottom.
Use 3 pcs of 1/4”-20x1/2” screws to attach the left side panel on the bottom.
Use 3 pcs of 1/4”-20x1/2” screws to attach the right side panel on the bottom.
Use 3 pcs of 1/4”-20x1/2” screws to attach the left side panel to the back panel.
Use 3 pcs of 1/4”-20x1/2” screws to attach the right side panel to the back panel.
STEP III :
Place the door bracket on the location as in below figure, and use 4pcs of 5/32“32x3/8” screws to attach it.
6
ASSEMBLY INSTRUCTIONS
STEP IV :
Use 2 pcs of 5/32"-32x3/8” screws to attach the tank baffle on the left side panel.
Use 2 pcs of 1/4"-20x1/2” screws to attach the 2 small tank holder brackets which
fix tank holder on right side panel. Hook one end of tank strap to tank holder.
STEP V :
Place door hinge rods through door spine holes, align upper side of door hinges
with holes on door bracket, then insert bottom end of door hinges(flared end) into
predrilled holes on bottom panel. Move the hinge rods up and down to adjust them.
7
Loading...