Rechargeable
Dual Power Supply System AC/DC
Instructions for use
PERMAFLO TECHNOLOGIES
EPE EXPRESSWAY,
Fan
LONDON, LEKKI, LAGOS, NIGERIA
PERMAFLO
recharge
Standing
CE-12V16B
2 PIONEER STREET, LEKKI-
OSAPA-
LTD
uction manual
designed,
turn off the power and pull the plug when it isn't working
n and extend useful time of the
Please keep away from children. This is an electrical appliance with stored electrical
power even when not plugged into the electrical mains. Ensure only adults operate this
off the power supply
Do
order to avoid getting an electric
objects
into the fan guard when it is
Alth
is a household
please check if the
Do
Please read the instr
Rechargeable Fan is wellappliance. Ensure you
power consumptio
CAUTION
rechargeable fan.
Please cut
before pulling the plug out.
pull the plug with wet hands
shock.
USER INFORMATION
carefully before using this product.
low-voltage, low power, it
appliance.
Before using,
not
in
wire and the plug are damaged.
not fold or pull the wire
ough this
electric
to save
Do not put fingers or sharp
working.
Do not use before assembly.
1
TROUBLESHOOTING
Problem Troubleshooting
Fan not working
Check whether cable is connected or not
Check batteries are discharged. If discharged, connect
the AC adapter to power
Fan blades not
rotating
Check toggle switch is up or down
Check the AC adapter if it is damaged. If damaged,
please replace the AC adapter.
Fan not charging
Check the batteries are properly connected and
contacting
Check if batteries are aging or damaged. If so, please
replace the batteries
CARE AND MAINTENANCE
• When not in use the fan should be stored in a dry location
• Aways unplug the fan before cleaning or disassembling.
• Clean the outside surfaces of the Rechargeable fan with a damp cloth and mild
detergent – do not allow water to enter the unit.
TECHNICAL SPECIFICATION
• Power supply: 220 – 240V ~ 50Hz/60Hz or solar panel power: 35W
• Operating temperature: -5℃ ~ 50℃
• Charging time: 8 ~ 10 hours
• Cordless time after fully charged: 3.5 ± 0.5 hours for HIGH setting, and 5.0 ± 0.5
hours for LOW setting
PRODUCT STANDARDS
• IEC 60335-1:2006
• IEC 60335-2-80：2008
For the four pilot lights on the right side, they are for “Charge, Low, Middle and High”
respectively from left to right.
• The charging pilot light indicates the current status of the battery. If the product is
connected to an AC outlet, the light will twinkle when it’s being charged, while the
light will be green when it’s fully charged.
IMPORTANT: If the product is not used for a long time, battery must be fully
charged before use. Recharge every 3 months to guarantee battery
life.
WARNINGS
• Ensure power rating complies with local power supply.
• Do not break light box. If lamp tube is damaged, it must be replaced by dealers or
professionals.
• Power cord should be regularly examined for signs of damage and the appliance is
not to be used if the cord is damaged.
• If power cord is damaged, it must be replaced by the Permaflo, its approved service
agent in order to avoid danger.
• Do not use non-rechargeable batteries.
• Do not mix new and used batteries & do not mix battery types.
Do not expose batteries to heat as they may explode or leak.
SAFETY
• This product is designed to be used indoors. Rechargeable fan should not be used
in the rain, near fire or other unsuitable environment.
• Always position cable and extension leads so they do not become a trip hazard for
children, pets or the elderly.
BEFORE YOU START
• Unpack the Rechargeable fan ensuring that all the parts are present and that there are
no components left in the box. Also ensure the product is free from all packing material
as this could melt.
• Do not connect the Rechargeable fan to the power supply until it is fully assembled.
• Do not connect the Rechargeable fan to the power supply if any of the components, or
the cable, appear damaged. If in doubt contact the place of purchase.
CHARATERISTICS
• This product can be powered by AC electricity, DC battery or solar panels. Normally, it
is powered by AC electricity.
• Self-protect function to avoid being overcharged or low-battery so that the lifetime of
the battery can be extended efficiently.
• A rechargeable product which is convenient to be used indoor during time of power
failures or outdoor (non adverse weather conditions only).
• Both can be used at the same time or used during charging.
Note: If the unit is used for the first time, it should be charged continuously for at
least 12 hours before the Rechargeable fan is turned on.
ASSEMBLY INSTRUCTION
Tip: For ease of assembly, ask somebody to help by holding the additional units while
you fix them to the fan.
1. Unpack the rechargeable fan components ensuring that all the parts are present
and that there are no components left in the box. Also ensure the product is free from
all packing material as this could melt.
See Fig 1
2. Take the extension tube, take out the big screw (part 12), install the plastic cover
(part 11) on the extension tube. See Fig 2
3. Take the fan body (part 7) out and connect the cable through the extension tube,
take out the nut from poly bag (part 10) and tighten screws to fix the expansion tube
and fan body. See Fig 3
4.Take the base, connect the
recess
(part
) to the
(part
s on the control panel:
between fan body and base.
(from poly bag) to f
(part
2
press down
, and
extension into base
and base.
Fig 2
wire terminal
, tightening 4 screws
Fig 3
Put the
ix the expansion
5. Take the back grill
grill and fan body.
6. Put the blade (part 3
7. Make up the front grill
OPERATION
5) out and tighten the big plastic nut
motor shaft, tightening blade nut (part
1) and back grill together and
4) to fix the back
)
the buttons.
•
For the two button
Lamp
.
the left is for the Fan
the right for the
Warranty Certificate
Product name: _______________ Product model:________________________
Product No: ________________ Purchase Date:_________________________
Customer: ________________ Cerificate No:__________________________
Customer address:__________________________________________________________
________________________________________________________________________
Warranty Notice:
1. Please fill in the above information and retain for warranty to be valid.
2. Please present this Warranty Certificate and purchase receipt before maintenance.
3. Warranty Period: within 1 year after purchase.
4. Warranty restriction: Warranty will be not be valid in the follow cases.
(A) Unapproved maintenance by customer (non-Permaflo technician);
(B) Customer’s unauthorized parts change, misuse or accidental damage;
(C) Usage in an improper environment.
5. Warranty does not cover damage or normal wear and tear.
(This certificate is retained by end user)
Special Statement:
• Permaflo reserves the right to interpret Warranty conditions.
• Warranty conditions can be revised without prior notice to customer.
• Internal picture for reference only.
Loading...