✓ Keeps beer loss to a minimum
✓ Speeds service on keg changeovers
✓ Minimizes overfoaming
The patented Perlick Smart Coupler* combines an integral
Empty Keg Sensor with a quality keg coupler to eliminate
the need for wall-mounted FOB devices. It senses when a
keg is empty and shuts off the beer flow , yet leaves the line
fully charged with beer. This prevents gas from entering an
empty line causing excessive foaming when tapping a
fresh keg. Packed 25 per case. Weight: 1 lb. 8 oz. each
Existing Perlick single valve keg couplers can be retrofitted
to function as Smart Couplers. Simply replace the probe
with Perlick’s No. 40125 empty keg sensor. Bulk-packed.
Weight: 8 oz. each
Single and dual cleaning
adapters are uniquely
designed to operate
No. 43657No. 43681No. 43659
SingleDualSeries
AdapterAdapterAdapter
allowing the system to be cleaned from the faucet through
the keg coupler. Prevents solution from entering the CO
line, eliminating beer contamination when retaping. Brass
nickel plated (Bulk Packed)
*Note: These adapters are designed to be used with all Perlick single
valve couplers and most competitor’s couplers. Must be used with Smart
Couplers when cleaning lines from the faucet through the Smart Coupler.
when Perlick’s keg coupler is in the untapped
(handle up) position,
2
Universal Empty Keg Sensor
Controls the amount of beer loss by closing off the beer
flow when a keg empties. Mounts directly to the keg
coupler for dual probe or imported kegs.
Uniquely constructed to tap a keg
in limited space. Just push down
and twist to tap.
Part No.Description
40030 ............................Lo-Bo
KEG COUPLERS
G-Series Keg Couplers for Single Valve
Domestic and Imported Kegs
Provided with non-rotating probe in stainless steel or
nickel-plated brass. Enlarged bore and wider tip opening
produces less turbulence and restriction which allows for
reduced line pressure and CO2 breakout. Nickel-plated,
forged brass body with three internally mounted
seals.Floating ball check valve equalizes line pressure.
Relief valve vents over-pressurized keg. For bent probe
design, attach #2036SS elbow to external thread on keg
couplers. Optional Locking Shield prevents accidental
untapping. Individually packed, 25 per case. Weight 24 oz.
each.
For Domestic Kegs
Part No.Descriptionr
26000G............................Probe, brass, less lock
26000GS.........................Probe, S. St., less lock
26000G1..........................Probe, brass, with lock
26000GS1.......................Probe, S. St., with lock
For Imported Kegs
Part No.Description
27500G............................Probe, brass, less lock
27500GS.........................Probe, S. St., less lock
27500G1..........................Probe, brass, with lock
27500GS1.......................Probe, S. St., with lock
No. 26000G
No. 26000G1
No. 32695
No. 2036SS
Elbow for Bent Probe
Couplers
Part No.Description
2036SS.......................................S. St. elbow coupler