Perlick HC24TO Installation Manual
Installation Manual
for Beer Dispensing Equipment
HP15TS/TO
HP24TS/TO
HC24TB/TO
15” SIGNATURE SERIES
24” SIGNATURE SERIES
24” C-SERIES
Form No. Z2349
Rev. 03/05/2014
PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
DANGER
WARNING
DANGER
WARNING
TABLE OF CONTENTS
Dispensing Equipment Installation .....................................3
Connecting the CO2 Cylinder ................................................8
CO2 Leak Test ....................................................................................8
Mounting Hole Template ..........................................................9
CONGRATULATIONS
Congratulations on your purchase of a Perlick high
quality residential Beer Dispenser. Perlick has proudly
manufactured beer dispensing systems for over 50 years
for bars, restaurants, stadiums, arenas and large venues
around the world. That same technology is used in each
and every residential beer dispenser we produce, assuring
you’ll pour fresh, cold beer as the brewery intended it to
be enjoyed.
IMPORTANT!
The installation of the actual beer
dispenser cabinet should happen prior
to installing the dispensing equipment.
Refer to the Installation Manual that
accompanied the Beer Dispenser for step-
by-step installation of the cabinet.
All Perlick products are built with commercial grade
stainless steel, providing you with the beauty and durability
for a lifetime of use. This installation guide will show you
how to properly install the dispensing equipment on your
Perlick Beer Dispenser.
We dedicate considerable time to ensure that our products
provide the highest level of customer satisfaction. If,
however, service is required, call Perlick at 800.558.5592.
For your own protection, never return merchandise for
credit without our approval.
We thank you again for selecting a high quality Perlick Beer
Dispenser. Cheers!
Keep CO2 cylinder away from
heat. Rupture disc vents at 122°F
maximum.
Do not drop or throw regulator or
CO2 cylinder.
Allow only properly trained and
experienced personnel to handle
high pressure gas.
Do not apply oil to the regulator!
C
2
US
perlick.com
PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
INSTALLATION OF DISPENSING EQUIPMENT
Open the tapping kit box and become familiar with
its components. If the dispensing head is going to be
mounted on a counter top directly above the refrigerated
cabinet, have the counter top pre-drilled using the
supplied template on page 9. Make sure that the access
hole in the refrigerated cabinet is in line with the counter
top holes. Remove any obstructions from the access hole
of the refrigerator. Follow instructions on pages 4 through
7 to properly install the tapping equipment on your perlick
unit.
Dispensing Head
Apply silicone to
bottom interior
Faucet Lead
Flange Sleeve
All hose connections
use worm-drive
hose clamps (view
enlarged to verify)
Keg
Keg Coupler
Beer Connection
NOTE: Image does not accurately reect positions of the
dierent elements within the unit. Positions and hose lengths
shown are to clearly illustrate proper connection methods
only.
Air Distributor
Distributor is only on
multiple keg units,
each keg is connected
to a valve on the air
distributor. Single keg
is connected directly to
the regulator.
perlick.com
3
Loading...