Performance Designed PL6432, PL6432A User Manual

Thank you for purchasing wireless controller for the PLAYSTATION 3 video game
system.

Contents:

1 Wireless Controller for PS3
1 USB Dongle (found attached to the controller)
1 USB Cable
1 Manual

Set up:

1) Remove the USB receiver that is attached to the bottom of the controller and plug it

into one of the free ports of your PLAYSTATION 3

2) USB receiver LED will flash rapidly while looking for positive connection with the

controller. USB receiver light will light up solid when the connection is established

3) Place the power switch is in “ON” position

4) Press the “HOME” button, the controller will be automatically assigned a player

number. (you can change the controller player number by pressing and holding the
HOME button and then changing the player number from the PS3 menu – refer to
your console manual for more information

5) The battery of the controller is low when its LED start flashing.

Power Save Mode:

Controller will go into Power Save Mode after 3 (three) minutes of inactivity. You need
to press the START button to turn it back to the ACTIVE mode

Important Notice

1. Recommended user age range 14+.

2. Adult supervision is necessary when controller is used by child

CAUTION:

Changes or modifications to this equipment not expressly approved by the manufacturer
could void the users authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.

Controller FCC ID: X5B-PL6423 IC: 8814A-PL6423
Dongle FCC ID: X5B-PL6423A IC: 8814A-PL6423A

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.

INDUSTRY CANADA CONFORMITY
This device has been tested and found to comply with the limits specified in RSS-210.

Operation is subject to the following two conditions: (1) This device may not cause
interference, and (2) This device must accept any interference, including interference that
may cause undesired operation of the device.

This Class [B] digital apparatus complies with Canadian ICES-003.

DECLARATION DE CONFORMITE D’INDUSTRIE CANADA
Ce périphérique a été testé et reconnu conforme aux limites spécifiées dans RSS-210.

Son utilisation est soumise aux deux conditions suivantes : (1) il ne doit pas provoquer
d’interférences gênantes et (2) il doit tolérer les interférences reçues, notamment celles
susceptibles d’en perturber le fonctionnement.

Cet appareil numérique de classe [B] est conforme à la norme canadienne ICES-003.

© 2010 Performance Designed Products LLC. All rights reserved. PDP and
AFTERGLOW™ are trademarks of Performance Designed Products LLC. PlayStation
3® is a registered trademark of Sony Computer Entertainment, Inc. This product is not
designed, manufactured, sponsored or endorsed by Sony Computer Entertainment.

Please keep this information for future reference.