Page 1
Revision: June 30, 2016
Page: 1/6
Product identifier
Chemical Name
Mixture
CAS No.
Mixture
Trade Name
Perfect Data Eco II Duster
Product Code
50-501207 to 50-501213
Relevant identified uses of the substance or mixture and uses advised against
Identified Use(s)
Dusting agent
Uses Advised Against
None
Company Identification
Spray Products Corporation
P.O. Box 737
Norristown, PA 19404
Telephone
(610) 277-1010
Fax
(610) 277-4390
E-Mail (competent person)
sds@sprayproducts.com
Emergency telephone number
Emergency Phone No.
Transportation Emergency: CHEMTREC 24 hr. 1-800-4249300 / 1 (703) 527-3887 (Collect calls accepted)
Classification of the substance or mixture
OSHA HCS (29 CFR 1910.1200)
Flam. Aerosol 1; Liquified Gas; Simple Asphyxiant
Label elements
Hazard Symbol
Signal word(s)
DANGER
Hazard Statement(s)
Extremely flammable aerosol.
Contains gas under pressure; may explode if heated.
May displace oxygen and cause rapid suffocation.
SAFETY DATA SHEET
OSHA HCS (29 CFR 1910.1200)
SECTION 1: PRODUCT AND COMPANY IDENTIFICATION
SECTION 2: HAZARDS IDENTIFICATION
Note: This product is a consumer product and is labeled in accordance with the US Consumer Product
Safety Commission regulations which take precedence over OSHA Hazard Communication labeling. The
actual container label will not include the label elements below. The labeling below applies to
industrial/professional products under OSHA Hazard Communication labeling .
Page 2
Revision: June 30, 2016
Page: 2/6
Precautionary Statement(s)
Keep away from heat/sparks/open flames/hot surfaces. – No smoking.
Do not spray on an open flame or other ignition source.
Do not pierce or burn, even after use.
Avoid breathing spray.
Store in a well-ventilated place. Do not use in confined spaces.
Protect from sunlight and do not expose to temperatures exceeding 50
ºC/122 ºF.
Wear eye/face protection.
Wash hands and exposed skin after use.
Keep out of reach of children.
Other hazards
Intentional inhalation of gas from container may be fatal.
SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS
Hazardous Ingredient(s)
% wt. *
CAS No.
Hazard classification
1,1-Difluoroethane
98 - 100
75-37-6
Flam. Gas 1; H220
Liquified Gas; H280
Simple Asphyxiant
Additional Information - None
* The exact percentage withheld as a trade secret in accordance with 29 CFR 1910.1200.
Description of first aid measures
Inhalation
Move person to fresh air. If breathing is labored, administer oxygen. If
symptoms develop, obtain medical attention.
Skin Contact
Wash affected skin with soap and water. If symptoms develop, obtain
medical attention.
Eye Contact
IF IN EYES: Rinse cautiously with water for several minutes. Remove
contact lenses, if present and easy to do. Continue rinsing. If symptoms
occur obtain medical attention.
Ingestion
Unlikely to be required but if necessary treat symptomatically. Do not
give anything by mouth to an unconscious person. Seek medical
treatment.
Most important symptoms and effects, both acute and
delayed
Liquid contact with skin or eyes may cause frostbite.
Indication of any immediate medical attention and
special treatment needed
IF SWALLOWED: Immediately call a POISON CENTER or
doctor/physician.
Extinguishing Media
-Suitable Extinguishing Media
Extinguish with carbon dioxide, dry chemical, foam or water spray.
-Unsuitable Extinguishing Media
Do not use water jet.
SECTION 4: FIRST AID MEASURES
SECTION 5: FIRE-FIGHTING MEASURES
Page 3
Revision: June 30, 2016
Page: 3/6
Special hazards arising from the substance or
mixture
Highly flammable vapor (flash point below 23°C).
Advice for fire-fighters
A self contained breathing apparatus and suitable protective clothing
should be worn in fire conditions. Keep containers cool by spraying
with water if exposed to fire.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and
emergency procedures
Keep away from heat/sparks/open flames/hot surfaces. – No smoking.
Avoid contact with skin and eyes. Avoid breathing vapors.
Environmental precautions
Not normally required.
Methods and material for containment and cleaning up
Gaseous. Not normally required.
Reference to other sections
None
Additional Information
None
Precautions for safe handling
Keep away from heat/sparks/open flames/hot surfaces. – No
smoking. Avoid contact with skin and eyes. Use product in a wellventilated area only. Do not use in confined spaces.
Conditions for safe storage, including any incompatibilities
-Storage temperature
Protect from sunlight. Keep in a cool, well ventilated place. Store at
temperatures not exceeding 50 °C / 122 °F.
-Incompatible materials
This product should be stored away from sources of strong heat or
oxidizing chemicals. Materials to avoid: Alkalai or Alkaline Earth
Metals (Al, Zn).
Specific end use(s)
Dusting agent
Occupational Exposure Limits
SUBSTANCE.
CAS No.
(8hr TWA)
(STEL)
Note:
PEL
(OSHA)
TLV
(ACGIH)
PEL
(OSHA)
TLV
(ACGIH)
None
-----
-----
-----
-----
-----
#
#
Assure minimum oxygen content of work atmosphere.
Recommended monitoring method
None
Exposure controls
Appropriate engineering controls
Ensure adequate ventilation.
Personal protection equipment
Eye/face protection
Wear protective eyewear (goggles, face shield, or safety glasses).
SECTION 7: HANDLING AND STORAGE
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
Page 4
Revision: June 30, 2016
Page: 4/6
Skin protection (Hand protection/ Other)
Wear suitable gloves if prolonged skin contact is likely (Nitrile rubber)
Respiratory protection
Normally no personal respiratory protection is necessary. In case of
insufficient ventilation, wear suitable respiratory equipment. A dust
mask is not acceptable.
Thermal hazards
Not normally required. Use gloves with insulation for thermal
protection, when needed.
Environmental Exposure Controls
None known
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
Appearance
Liquified Gas
Color.
Colorless
Odor
Slight ethereal odor
Odor Threshold (ppm)
Not available
pH (Value)
Not available
Melting Point (°C) / Freezing Point (°C)
Not available
Boiling point/boiling range (°C):
-25 (1,1-Difluoroethane)
Flash Point (°C)
-50, est. (1,1-Difluoroethane)
Evaporation Rate
>1 (Ethyl ether =1) (1,1-Difluoroethane)
Flammability (solid, gas)
Extremely flammable
Explosive Limit Ranges
3.9% - 16.9% v/v (1,1-Difluoroethane)
Vapor pressure (Pascal)
5.3 x 105 @ 21°C (1,1-Difluoroethane)
Vapor Density (Air=1)
2.4 (1,1-Difluoroethane)
Density (g/ml)
Not available
Solubility (Water)
0.28% @ 21°C (1,1-Difluoroethane)
Solubility (Other)
Not available
Partition Coefficient (n-Octanol/water)
Not available
Auto Ignition Point (°C)
440 (1,1-Difluoroethane)
Decomposition Temperature (°C)
Not available
Kinematic Viscosity
Not available
Explosive properties
Not explosive.
Oxidizing properties
Not oxidizing.
Other information
Not available
Reactivity
Stable under normal conditions.
Chemical stability
Stable.
Possibility of hazardous reactions
None anticipated.
Conditions to avoid
Avoid contact with heat and ignition sources.
Incompatible materials
Strong oxidizing agents. Materials to avoid: Alkalai or Alkaline Earth
Metals (Al, Zn).
Hazardous decomposition product(s)```
Hydrofluoric Acid and Carbonyl Halides.
Acute toxicity (Inhalation)
ALC (approximate lethal concentration) = 383000 ppm
4 hr exposure
SECTION 10: STABILITY AND REACTIVITY
SECTION 11: TOXICOLOGICAL INFORMATION
Exposure routes: Inhalation, Skin Contact, Eye Contact
Page 5
Revision: June 30, 2016
Page: 5/6
SECTION 12: ECOLOGICAL INFORMATION
Aquatic toxicity:
Short term
Not available
Long Term
Not available
Waste treatment methods
Disposal should be in accordance with local, state or national
legislation. Consult an accredited waste disposal contractor or the
local authority for advice.
U.S. DOT
Sea transport
(IMDG)
Air transport
(ICAO/IATA)
UN number
1030
1030
1030
Proper Shipping Name
1,1-Difluoroethane
1,1-Difluoroethane
1,1-Difluoroethane
Transport hazard class(es)
2.1
2.1
2.1
Packing group
Not applicable
Not applicable
Not applicable
Environmental hazards
None assigned
None assigned
None assigned
Special precautions for user
None assigned
None assigned
None assigned
Transport in bulk according to Annex II of MARPOL73/78 and the IBC Code: Not applicable
Safety, health and environmental regulations/legislation specific for the substance or mixture:
TSCA (Toxic Substance Control Act) - Inventory Status: All components listed or polymer exempt.
Designated Hazardous Substances and Reportable Quantities (40 CFR 302.4):
Chemical Name
CAS No.
Typical %wt.
RQ (Pounds)
None
----
----
----
SARA 311/312 - Hazard Categories:
Fire Sudden Release Reactivity Immediate (acute) Chronic (delayed)
SARA 313 - Toxic Chemicals (40 CFR 372):
Chemical Name
CAS No.
Typical %wt.
Isopropanol
67-63-0
0.0087
SARA 302 - Extremely Hazardous Substances(40 CFR 355):
Chemical Name
CAS No.
Typical %wt.
TPQ (pounds)
None
----
----
----
California Proposition 65 List:
Chemical Name
CAS No.
Type of Toxicity
None
----
----
The following sections contain revisions or new statements: 1-16.
Date of preparation: June 8, 2016
SECTION 13: DISPOSAL CONSIDERATIONS
SECTION 14: TRANSPORT INFORMATION
SECTION 15: REGULATORY INFORMATION
SECTION 16: OTHER INFORMATION
Page 6
Revision: June 30, 2016
Page: 6/6
Hazard Statement(s) and Risk Phrases Listed in: SECTION 2:/ SECTION 3:
Hazard Statement(s)
- H220: Extremely flammable gas.
- H280: Contains gas under pressure; may explode if heated.
Training advice: None.
Disclaimer: We believe the statements, technical information and recommendations contained herein are reliable, but they are
given without warranty or guarantee of any kind. The information contained in this document applies to this specific material as
supplied. It may not be valid for this material if it is used in combination with any other materials. It is the user’s responsibility to
satisfy oneself as to the suitability and completeness of this information for the user’s own particular use.
Loading...