Perfect Aire PMP50 User Manual
(50 PINT)
DEHUMIDIFIER
With Ejector Pump
USER MANUAL
Your Source for Home Comfort
FOR MODEL:
PMP50
Before using your dehumidifier,
please read this manual carefully
and keep it for future reference,
along with your receipt.
CONTENTS
SAFETY PRECAUTIONS ..................................................................................... 2
IDENTIFICATION OF PARTS............................................................................... 3
DEHUMIDIFIER FEATURES ................................................................................ 4
OPERATING INSTRUCTIONS ............................................................................. 6
CARE AND MAINTENANCE .............................................................................. 10
TROUBLESHOOTING TIPS ............................................................................... 11
This manual provides the information needed for proper use and maintenance of this air conditioner. Basic
preventative care can help extend the life of this unit. The “Troubleshooting Tips” section in this manual contains a
chart with solutions to the most common problems. Referring to this section may save time and prevent the need
for a service call in the event of a problem.
!
CAUTION
● Contact an authorized service technician for repair or maintenance of this unit.
● Contact an installer for installation of this unit if necessary.
● The dehumidifier is not intended for use by young children without supervision. Young children should
be supervised to ensure that they do not play with the air conditioner.
● Disabled persons may require assistance with set up and usage.
● If the power cord is to be replaced, replacement work should be performed by authorized personnel only.
● Installation and repair work must be performed in accordance with the national wiring standards by authorized
personnel only.
NOTE: All the illustrations in this manual are for explanation purposes only.
Unit purchased may be slightly different.
The design and specifications are subject to change without prior notice for product improvement. Contact
customer service for details.
ELECTRICAL INFORMATION
● The manufacturers nameplate is located on the rear panel of the unit and contains electrical and other technical
data specific to this unit.
● Be sure the unit is properly grounded. To minimize shock and fire hazards, proper grounding is important. The
power cord is equipped with a three-prong grounding plug for protection against shock hazards.
● Your unit must be used in a properly grounded wall receptacle. If the wall receptacle you intend to use is not
adequately grounded or protected by a time delay fuse or circuit breaker, have a qualified electrician install the
proper receptacle.
● Ensure the receptacle is accessible after the unit installation.
● Do not use extension cords or an adaptor plugs with this unit. However, if it is necessary to use an extension
cord, use an approved dehumidifier extension cord only (available at most local hardware stores).
● To avoid the possibility of personal injury, always disconnect the power supply to the unit before installing
and/or servicing.
1
SAFETY PRECAUTIONS
To prevent injury to the user or other people and property damage, the following instructions must be followed.
Incorrect operation due to ignoring of instructions may cause harm or damage. The seriousness is classified by
the following indications:
! !
WARNING
CAUTION
!
This symbol indicates the possibility of death or serious injury.
This symbol indicates the possibility of injury or damage to property.
Meanings of symbols used in this manual are:
Do not exceed the rating
of the power outlet or
connection device.
Otherwise, it may cause
electric shock or fire due to
excess heat generation.
Do not modify power cord
length or share the outlet
with other appliances
It may cause electric shock or
fire due to heat generation.
!
Disconnect the power if
strange sounds, smell, or
smoke comes from it.
It may cause fire and electric
shock.
Do not operate or stop the
unit by inserting or pulling
plug directly from the wall.
It may cause electric shock or
fire due to heat generation.
Do not insert or pull out
plug with wet hands.
It may cause electric shock.
You should never try to
take apart or repair the
unit by yourself.
It may cause failure of
machine or electric shock.
WARNING
Do not damage or use an
unspecified power cord.
It may cause electric shock
or fire.
Do not place the unit near
a heat source.
Plastic parts may melt and
cause a fire.
!
Before cleaning, turn off
the power and unplug the
unit.
It may cause electrical shock
or injury.
Always do this.Never do this.
!
Do not use the machine near
flammable gas or combustibles, such
as gasoline, benzene, thinner, etc.
It may cause an explosion
or fire.
Do not drink or use the
water drained from the unit.
It contains contaminants and
could make you sick.
Do not take the water
bucket out during
operation.
It will cause bucket full code
to appear and can possibly
cause electric shock.
CAUTION
Do not cover the intake or
exhaust openings with
cloths or towels.
A lack of air flow can lead to
overheating and fire.
Never insert your finger or
other foreign objects into grilles or openings. Take
special care to warn
children of these dangers.
It may cause electric shock or
failure of appliance.
!
Always insert the filters
securely. Clean filter
once every two weeks.
Operation without filters
may cause failure.
!
Care should be taken when
using the unit in a room
with the following persons:
Infants, children, elderly
people, and people not
sensitive to humidity.
Do not place heavy objects
on the power cord; make
sure that the cord is not
compressed.
There is danger of fire or
electric shock.
!
If water enters the unit, turn
the unit off and disconnect
the power; contact a
qualified service technician.
It may cause failure of
appliance or accident.
Do not use in areas
where chemicals
are handled.
This will cause deterioration
of the unit due to the dissolving
of chemicals and solvents in
the air.
Do not climb up on or
sit on the unit.
You may be injured if you fall
or if the unit falls over.
Do not place flower
vases or other water
containers on top of
the unit.
Water may spill inside the
unit, causing insulation failure
and electrical shock or fire.
Do not use the unit in
small spaces.
Lack of ventilation can
cause overheating and fire.
Do not put in places where
water may splash onto
the unit.
Water may enter the unit and
degrade the insulation. It may
cause an electric shock or fire.
!
Place the unit on a
level, sturdy section of
the floor.
If the unit falls over, it may
cause water to spill and
damage belongings, or cause
electrical shock or fire.
2
IDENTIFICATION OF PARTS
Front
Control panel
Air intake grille
Air outlet grille
Air filter (behind the grille)
Water bucket
Handle (both sides)
1
2
4
5
6
3
Fig. 1a -
Front
Rear
Continuous drain hose outlet
Caster
Power cord and plug
Band (used only when storing the unit)
Pump drain hose outlet
4
1
2
3
Fig. 1b -
Rear
5
NOTE:
Inside the bucket, on the left side, is an “arm”
mechanism that wobbles. This piece is called the
“float.” DO NOT remove the foam piece that is
found in the cube-like part of the float. See Fig. 2.
If the piece is removed, the bucket will overflow.
Accessories:
Drain Hose Adaptor A
with Short Hose (1 pc ea)
for continous drainage operation
Located inside the bucket. Packaged on the side of the unit. Located in the upper corner of the
NOTE: For continuous drainage operation, a hose no longer than 6 ft is recommended.
See page 12 for setup instructions and hose specifications if selecting continuous drainage option.
16 ft long Drain Hose (1 pc)
for pump drainage operation
Screw (2 pcs, 4x5/8”)
for drain hose adaptor,
continuous drainage operation
packaging of this user manual.
Fig. 2 - Foam piece
inside float mechanism.
DO NOT REMOVE
the foam.
NOTE: All the illustrations in this manual are for explanation purposes only.
Unit purchased may be slightly different, but the operations and functions are the same.
3
DEHUMIDIFIER FEATURES
NOTE: The control panel of the unit you purchased may be slightly different based on the model.
Filter
Bucket full
indicator light
Pump
Fig.3
Pump operation
on indicator light
CONTROL PADS
When you push the button to change operation
modes, the unit will make a beep sound to indicate
that it is changing modes.
PUMP Pad
Press to activate the pump operation.
NOTE: Make sure the pump drain hose is
installed into the unit and the continuous drain
hose is removed from the unit before the pump
operation is activated. When the bucket is full,
the pump starts to work. Refer to the next pages
for removing the collected water. Do not use this
operation when the outdoor temperature is equal
to or less than 32°F (0°C).
FILTER Pad
The check filter feature is a reminder to clean the
air filter for more efficient operation. The Filter
light (Clean Filter light) will illuminate after 250
hours of operation. To reset after cleaning the
filter, press the Filter pad and the light will go off.
FAN Pad
Controls the fan speed. Press to select either
Turbo (High) or Normal fan speed. Set the fan
control to Turbo for maximum moisture removal.
When the humidity has been reduced and quiet
operation is preferred, take the fan off of Turbo so
the unit runs on Normal.
POWER Pad
Press to turn the dehumidifier on and off.
Filter
Full
Pump
Timer on/off
indicator light
Clean filter
indicator light
On Off
Timer
High fan
indicator light
Turbo
Cont.
Fan
Continuous
operation on
indicator light
Auto defrost
Auto defrost operation on
indicator light
DOWN – & UP + Pads
Humidity Set Control Pads
The humidity level can be set within a range of
35% RH (Relative Humidity) to 85% RH in 5%
increments. For drier air, press the – pad and set
to a lower percent value (%). For damper air, press
the + pad and set to a higher percent value (%).
Timer Set Control Pads
Use the Up/Down pads to set the Auto start and
Auto stop time from 0.0 to 24 hours.
Continuous Operation
To run the unit in continuous mode, press the –
pad until the display reads 35% RH. Then press
the – pad again until the display reads “CO” for
continuous operation. To stop continuous
operation, press the + and set the desired % RH
set point level to resume normal operation.
NOTE: You cannot set a desired humidity while
in continuous mode. Continuous mode means
the dehumidifier will run all the time and does not
need a humidity setting.
TIMER Pad
Press to initiate the auto start and auto stop
feature in conjunction with the + and – pads.
Display
Shows the set % humidity level from 35% to 85%
or auto start/stop time (0−24) while setting, then
shows the actual (5% accuracy) room % humidity
level in a range of 30% RH to 90% RH.
4
Loading...