Pepperl+Fuchs ODT-MAH120-HD Quick Start Manual
QUICK START GUIDE
ODT-HH-MAH120-HD
Handheld - High Density
FACTORY AUTOMATION
ODT-HH-MAH120-HD
With regard to the supply of products, the current issue of the following document is applicable: The General Terms of Delivery for Products and Services of the Electrical Industry,
published by the Central Association of the Electrical Industry (Zentralverband Elektrotechnik und Elektroindustrie (ZVEI) e.V.) in its most recent version as well as the supplementary
clause: "Expanded reservation of proprietorship"
ODT-HH-MAH120-HD
1 Introduction ................................................................................... 4
1.1 Purpose of this Quick Start Guide .......................................................... 4
1.2 Intended use.............................................................................................. 4
2 Installation and Commissioning.................................................. 5
2.1 Connection ................................................................................................ 5
2.1.1 Connection via USB.................................................................................... 6
2.1.2 Connection via RS 232 ............................................................................... 7
2.1.3 Connection via PS/2 ................................................................................... 9
2.2 Operating modes .....................................................................................10
2.2.1 USB operating modes................................................................................10
2.2.2 RS232 operating modes ........................................................................... 12
2.3 Positioning and reading techniques..................................................... 14
2.4 Optimizing reading performance........................................................... 15
2.5 Reading high-density data matrix codes .............................................. 16
2.6 Factory defaults ...................................................................................... 18
3
ODT-HH-MAH120-HD
Introduction
1 Introduction
1.1 Purpose of this Quick Start Guide
This Quick Start Guide is designed to help you learn the basic functions for operating the device. The guide
also contains brief instructions for using the device again at a later stage. However, this Quick Start Guide
does not replace the manual on the CD supplied.
The Quick Start Guide does not explain complex scenarios or offer detailed information. If you wish to use
the full range of device functions, refer to the manual. We also recommend reading the manual if you are
unsure about handling the device or experience device malfunctions.
1.2 Intended use
Operating the Handheld in a way different from that described in these instructions may have a negative
effect on the reliability and function of the device and connected systems. Protection of operating personnel
and the overall system is no longer guaranteed if the device is not used as specified.
The handheld was designed for identifying 1D and 2D codes and should be used for this purpose only. The
handheld is flexible and can therefore be used to decode codes in many branches of industry, such as the
logistics sector.
4
ODT-HH-MAH120-HD
Installation and Commissioning
2 Installation and Commissioning
2.1 Connection
You have the opportunity to connect the handheld to the following PC interfaces:
•USB
•RS232
•PS/2
The handheld is ready for immediate use once you have connected it to the computer.
Attaching the connecting cable to the handheld
1. Slide the protective cap over the 8-pin DIN plug.
2. Align the 8-pin plug so that it fits into the socket on the handheld.
5
ODT-HH-MAH120-HD
Installation and Commissioning
3. Press the 8-pin DIN plug and protective cap onto the socket.
4. Use a srewdriver and the screws provided to fasten the protective cap onto the bottom of the handle.
2.1.1 Connection via USB
Connecting USB connecting cable to computer
1. Insert the USB plug of the connecting cable in a free USB port on your computer. This can be done during
operation.
The handheld turns itself on automatically once you have connected it to the computer.
6
Loading...