Pepperl Fuchs NRN75-FP-A2-P3 Data Sheet

Inductive sensor NRN75-FP-A2-P3

Technical Data

General specifications

Switching element function PNP NO/NC

Model Number

NRN75-FP-A2-P3

Features

• 75 mm non-flush

• Reduction factor = 1

Rated operating distance s Installation non-flush Output polarity DC Assured operating distance sa0 ... 55 mm Reduction factor r Reduction factor rCu 1 Reduction factor r Reduction factor r

Nominal ratings

Operating voltage UB10 ... 30 V DC Switching frequency f 0 ... 50 Hz Hysteresis H typ. 3 % Reverse polarity protection reverse polarity protected Short-circuit protection pulsing Vol tag e d rop U Rated insulation voltage U Operating current I Off-state current I No-load supply current I Time delay before availability t Operating voltage indicator LED, green Switching state indicator LED, yellow

Functional safety related parameters

MTTFd 824 a Mission Time (T Diagnostic Coverage (DC) 0 %

Ambient conditions

Ambient temperature 0 ... 50 °C (32 ... 122 °F) (± 10 % changing operating distance)

Mechanical specifications

Connection type screw terminals Information for connection A maximum of two conductors with the same core cross-section

Core cross-section up to 2.5 mm

Minimum core cross-section

Maximum core cross-section Housing material PBT Sensing face PBT Housing base aluminum painted Degree of protection IP68

Compliance with standards and directives

Stan dard conf ormit y

Sta ndar ds

Approvals and certificates

UL approval cULus Listed, General Purpose CSA approval cCSAus Listed, General Purpose CCC approval CCC approval / marking not required for products rated ≤36 V

304

St37

) 20 a

75 mm

≤ 3 V

50 V

BIS

0 ... 200 mA

0 ... 0.5 mA

≤ 20 mA

≤ 300 ms

-25 ... 70 °C (-13 ... 158 °F) (± 20 % changing operating distance)

may be mounted on one terminal connection! tightening torque 1.2 Nm + 10 %

without wire end ferrule 0.5 mm without wire end ferrule 2.5 mm2 , with connector sleeves 1.5 mm

EN 60947-5-2:2007 IEC 60947-5-2:2007

, with connector sleeves 0.34 mm

Dimensions

M20 x 1.5

LEDs

ø 9.5

ø 5.3

Release date: 2016-09-29 11:31 Date of issue: 2016-10-10 242779_eng.xml

Refer to “General Notes Relating to Pepperl+Fuchs Product Information”.

Inductive sensor NRN75-FP-A2-P3

Electrical Connection

Installation Hint

L+

L-

These sensors are also suitable for mounting on metal. The stated switching distance ia achieved with a metal base plate, min. dimensions 225 mm x 225 mm. When mounted on a non-metallic base plate the switching distance is reduced by approx. 10 %.

225

Release date: 2016-09-29 11:31 Date of issue: 2016-10-10 242779_eng.xml

Refer to “General Notes Relating to Pepperl+Fuchs Product Information”.