Pepperl Fuchs NJ2-C-E02-1.025-V1 Data Sheet

Inductive sensor NJ2-C-E02-1.025-V1

Dimensions

LEDs

Ø38.1

Ø25

M12 x 1

Model Number

NJ2-C-E02-1.025-V1

Cylinder Position Switch

Features

•4-wire DC

• Weld Immune

• Sensing range 2 mm

• 250 psi rating

Connection

L+

L-

Pinout

Wire colors in accordance with EN 60947-5-2

1 BN 2 WH 3 BU 4 BK

Accessories

V1-G-2M-PVC

Cable connector

V1-W-2M-PVC

Cable connector

35.2

14.3

3/8-18 NPT

Ø11.5

27.2

"X"

Technical Data

General specifications

Switching element function NPN & PNP, NO Rated operating distance s Installation embeddable Output polarity DC Assured operating distance sa0 ... 1.62 mm Reduction factor r Reduction factor r

Nominal ratings

Operating voltage UB10 ... 30 V DC Switching frequency f 0 ... 30 Hz Hysteresis H 10 ... 20 % 15 typ. Reverse polarity protected yes Short-circuit protection yes Voltage drop U

Operating current I Off-state current I

No-load supply current I Mag. Field strength, AC fields 250 mT Mag. Field strength, DC fields 100 mT

Limit data

Operating pressure dynamically 250 psi

Indicators/operating means

LED green Power on LED yellow Output status

Standard conformity

Standards EN 60947-5-2

Ambient conditions

Ambient temperature -25 ... 70 °C (-13 ... 158 °F)

Mechanical specifications

Connection type V1 connector (M12 x 1), 4-pin Protection degree IP67 Material Housing: zinc

Note X = 1.025 in (26 mm)

Approvals and certificates

UL approval cULus Listed, General Purpose CSA approval cCSAus Listed, General Purpose

0.4

0.85

V2A

2 mm

≤ 2 V DC ≤ 200 mA

L r

≤ 100 µA ≤ 35 mA

Probe: aluminum

Release date: 2010-05-14 20:01 Date of issue: 2010-05-14 904458_ENG.xml

Subject to modifications without notice

Inductive sensor NJ2-C-E02-1.025-V1

Probe Through-Hole:

Standard probe hole ports are tapped with size 3/8" NPT threading for C series. The minimum probe through-hole diameter is 0.560" (14.22 mm).

Important: When using spacers, make certain to maintain the 0.250" (6.35 mm) minimum mounting screw thread engagement.

Probe Through-Hole: Standard probe hole ports are tapped with size 3/8" NPT threading for C series. The minimum probe through-hole diameter is 0.560" (14.22 mm).

Important: When using spacers, make certain to maintain the 0.250" (6.35 mm) minimum mounting screw thread engagement.

3/8" NPT threaded port (NPT Series)

Probe through-hole

3/8" NPT threaded port (NPT Series)

Probe through-hole

Release date: 2010-05-14 20:01 Date of issue: 2010-05-14 904458_ENG.xml

Subject to modifications without notice