Pepperl Fuchs NBN30-FPS-UU Data Sheet

Inductive sensor NBN30-FPS-UU

Dimensions

LED

24.545.2

77

ø9.6

ø 5.3

Model Number

NBN30-FPS-UU

Features

• 30 mm not embeddable

• NO/NC selectable

Connection

3

1

4

2

AC/D C

45

60

7

15.3

41

Technical Data

General specifications

Switching element function AC/DC NO/NC
Rated operating distance s
Installation not embeddable
Output polarity AC/DC
Assured operating distance sa0 ... 24.3 mm
Actuating element structural steel, e. g. 1.0037, SR235JR (formerly St37-2)

Reduction factor rAl 0.2
Reduction factor r
Reduction factor r
Reduction factor r

Nominal ratings

Installation conditions

B
C

F
Operating voltage U
Switching frequency f 0 ... 25 Hz
Hysteresis H 0.05 ... 7.26 mm
Reverse polarity protected yes
Short-circuit protection no
Overload resistance no
Wire breakage protection yes
Inductive overvoltage protection yes
Surge suppression yes
Voltage drop Ud≤ 8 V
Repeat accuracy 0.75 mm
Operating current I
No-load supply current I
Indication of the switching state LED, yellow

Functional safety related parameters

Mission Time (TM) 20 a
Diagnostic Coverage (DC) 0 %

Ambient conditions

Ambient temperature -25 ... 85 °C (-13 ... 185 °F)
Storage temperature -40 ... 85 °C (-40 ... 185 °F)

Mechanical specifications

Connection type screw terminals
Core cross-section up to 2.5 mm
Housing material PBT
Sensing face PBT
Housing base PBT
Protection degree IP65
Mass 445 g

Compliance with standards and directives

Standard conformity

Standards

0.1

Cu

0.5

304

0.2

Brass

30 mm

n

90 mm x 90 mm x 1 mm

70 mm
40 mm
100 mm
20 ... 265 V AC/DC

B

0 ... 300 mA

L

≤ 2 mA

0

EN 60947-5-2:2007
IEC 60947-5-2:2007

2

Release date: 2012-03-22 08:48 Date of issue: 2012-03-22 236514_eng.xml

Subject to modifications without notice

Copyright Pepperl+Fuchs

1

Inductive sensor NBN30-FPS-UU

Installation hint

These sensors are especially
designed for embeddable mounting in
conveyor floors. Due to its precise
location in metal base plates the
sensor is afforded a high degree of
mechanical protection. No clearance
is required between the sensor and
the base plate, avoiding the need for
protective guarding to prevent
possible foot injury.

The large sensing range ensures
positive detection, and thus provides
consistent control and monitoring of
the conveyor.

Release date: 2012-03-22 08:48 Date of issue: 2012-03-22 236514_eng.xml

Subject to modifications without notice

Copyright Pepperl+Fuchs

2