Pepperl Fuchs NBN30-FPS-A2 Data Sheet
Inductive sensor NBN30-FPS-A2
Dimensions
LED
24.545.2
77
ø9.6
ø 5.3
Model Number
NBN30-FPS-A2
Features
• 30 mm non-flush
•4-wire DC
Connection
1
4
2
3
45
60
7
15.3
41
Technical Data
General specifications
Switching element function PNP NO/NC
Rated operating distance s
Installation non-flush
Output polarity DC
Assured operating distance sa0 ... 24.3 mm
Actuating element mild steel, e. g. 1.0037, SR235JR (formerly St37-2)
Reduction factor rAl 0.2
Reduction factor r
L+
L-
Reduction factor r
Reduction factor r
Nominal ratings
Operating voltage UB10 ... 30 V DC
Switching frequency f 0 ... 50 Hz
Hysteresis H 0.05 ... 7.26 mm
Reverse polarity protection yes
Short-circuit protection yes
Overload resistance yes
Wire breakage protection yes
Inductive overvoltage protection yes
Surge suppression yes
Ripple 10 %
Voltage drop U
Repeat accuracy 0.75 mm
Operating current I
Off-state current I
No-load supply current I
Time delay before availability t
Operating voltage display LED, green
Indication of the switching state LED, yellow
Functional safety related parameters
MTTFd 1430 a
Mission Time (T
Diagnostic Coverage (DC) 0 %
Ambient conditions
Ambient temperature -25 ... 85 °C (-13 ... 185 °F)
Storage temperature -40 ... 85 °C (-40 ... 185 °F)
Mechanical specifications
Connection type screw terminals
Core cross-section up to 2.5 mm
Housing material PBT
Sensing face PBT
Housing base PBT
Protection degree IP65
Mass 270 g
Compliance with standards and directives
Standard conformity
Standards
Approvals and certificates
CCC approval Products with a maximum operating voltage of ≤36 V do not bear a
0.1
Cu
0.5
304
0.2
Brass
) 20 a
M
30 mm
n
90 mm x 90 mm x 1 mm
≤ 2.5 V
d
0 ... 200 mA
L
≤ 0.01 mA
r
≤ 20 mA
0
≤ 100 ms
v
2
EN 60947-5-2:2007
IEC 60947-5-2:2007
CCC marking because they do not require approval.
Release date: 2012-09-25 10:04 Date of issue: 2012-09-25 236513_eng.xml
Subject to modifications without notice
Copyright Pepperl+Fuchs
1
Inductive sensor NBN30-FPS-A2
Installation hint
These sensors are especially
designed for embeddable mounting in
conveyor floors. Due to its precise
location in metal base plates the
sensor is afforded a high degree of
mechanical protection. No clearance
is required between the sensor and
the base plate, avoiding the need for
protective guarding to prevent
possible foot injury.
The large sensing range ensures
positive detection, and thus provides
consistent control and monitoring of
the conveyor.
Release date: 2012-09-25 10:04 Date of issue: 2012-09-25 236513_eng.xml
Subject to modifications without notice
Copyright Pepperl+Fuchs
2
Loading...