Pepperl Fuchs NBB8-18GM60-B3B-V1 Data Sheet

Inductive sensor NBB8-18GM60-B3B-V1

Dimensions

M18x1

Model Number

NBB8-18GM60-B3B-V1

AS-Interface

Features

• 8 mm embeddable

• Cylindrical

• A/B slave with extended addressing possibility for up to 62 slaves

• NO/NC selectable

• On/Off delay (disconnectable)

Connection

(+)

(-)

Pinout

Accessories

BF 18

Mounting flange, 18 mm

EXG-18

Quick mounting bracket with dead stop

V1-G-BK0,3M-PUR-U-V1-G

Connection cable, M12 to M12, PUR cable, 4-pin

V1-G-BK1M-PUR-U-V1-G

Connection cable, M12 to M12, PUR cable, 4-pin

M12x1

Technical Data

General specifications

Switching element function NO/NC programmable Rated operating distance s Installation embeddable Output polarity AS-Interface Assured operating distance sa0 ... 6.48 mm Reduction factor r Reduction factor rCu 0.4 Reduction factor r Reduction factor r Slave type A/B slave AS-Interface specification V3.0 Required master specification ≥ V2.1

Nominal ratings

Operating voltage UB26.5 ... 31.9 V via AS-i bus system Switching frequency f 0 ... 200 Hz Hysteresis H 1 ... 15 typ. 5 % Reverse polarity protected reverse polarity protected No-load supply current I Indication of the switching state dual-LED, yellow Fault indication dual-LED, red

Functional safety related parameters

MTTFd 926 a Mission Time (TM) 20 a Diagnostic Coverage (DC) 0 %

Ambient conditions

Ambient temperature -25 ... 70 °C (-13 ... 158 °F) Storage temperature -40 ... 85 °C (-40 ... 185 °F)

Mechanical specifications

Connection type Device connector M12 x 1 , 4-pin Housing material brass, nickel-plated Sensing face PBT Protection degree IP67

Compliance with standards and directives

Standard conformity

Standards

Approvals and certificates

UL approval cULus Listed, General Purpose CSA approval cCSAus Listed, General Purpose CCC approval Products with a maximum operating voltage of ≤36 V do not bear a

0.4

0.7

303

0.5

Brass

8 mm

≤ 25 mA

EN 60947-5-2:2007 IEC 60947-5-2:2007 EN 50295:1999

CCC marking because they do not require approval.

Release date: 2011-07-21 08:34 Date of issue: 2011-07-21 226334_eng.xml

Subject to modifications without notice

Inductive sensor NBB8-18GM60-B3B-V1

Programming Instructions

Adress 00 preset, alterable via Busmaster or programming units IO-Code 0 ID-Code A ID1-Code 7 ID2-Code E

Data bit Bit Function

D0 Switching state D1 D2 D3 -

Parameter bit Bit Function

P0 ON / Off delay activated* / deactivated P1 Switching element function NO* / NC P2 not used P3 not used

Standard setting