Pepperl+Fuchs IDM161-M-1D-J1-BT-N-N0, IDM261-M-2D-J1-BT-N-N0 User Manual
Manual
IDM161-M-1D-J1-BT-N-N0
IDM261-M-2D-J1-BT-N-N0
Bluetooth handheld scanner for use in explosionhazardous areas Zone 1/21
The latest version of the General Terms of Supply for Products
and Services in the Electronics Industry set out by the German
Electrical and Electronic Manufacturers’ Association (ZVEI) and
the "Extended Reservation of Proprietorship" supplementary
clause apply to this document.
Table of ConTenTs
Table of Contents
1. Important Notes About The Instruction Manual ..................................6
1.1. Safety Information .......................................................................................... 6
1.2. Notes About The Manual ...............................................................................7
1.3. General Warning Messages ........................................................................... 9
2. Technical Data .......................................................................................12
2.1. Explosion Protection .................................................................................... 12
2.2. Technical Data for Bluetooth Scanner ......................................................... 12
2.3. Use .............................................................................................................. 13
3. System Structure ..................................................................................14
3.1. Overview ......................................................................................................14
3.2. System Structure 1 ......................................................................................15
3.3. System Structure 2 ......................................................................................16
3.4. System Structure 3 ......................................................................................17
4. Commissioning .....................................................................................18
4.1. Preparing Bluetooth Handheld Scanners .....................................................18
4.2. Pinout of Power Module with RS232 ........................................................... 22
4.3. Pinout of power module with USB ................................................................ 25
5. Accessories ..........................................................................................28
2018-06
4
ImporTanT noTes abouT The InsTruCTIon manual
1. Important Notes About The Instruction Manual
1.1. Safety Information
This document contains symbols to identify warning messages and information messages.
Warning messages
You always nd warning messages whenever hazards could result from your actions.
It is essential that you observe these warning messages to ensure your personal safety and to prevent property damage.
Warning messages are shown in descending order according to the risk level, as
follows:
DANGER!
This symbol warns you of an immediate and present danger.
If you do not observe this warning message, there is a risk of personal injury and
even death.
WARNING!
This symbol warns you of a potential fault or hazard.
If you do not observe this warning message, there is a risk of personal injury or
severe property damage.
CAUTION!
This symbol warns you of a potential fault.
Failure to observe this warning message may result in the product or any systems
and plants connected to it malfunctioning or suering a complete failure.
2018-06
6
ImporTanT noTes abouT The InsTruCTIon manual
Information messages
Note
This symbol draws your attention to important information.
Example
This symbol indicates an example.
Tip
This symbol indicates a tip is provided.
Action
This symbol highlights an action. You are prompted to perform an action or sequence
of actions.
1.2. Notes About The Manual
Please read the manual carefully before initial commissioning.
The instruction manual contains important information on the function and safety
regulations. If you do not observe this information, the intended use in explosion-hazardous areas cannot be guaranteed.
Observe the information given in this manual during commissioning and use of the
product.
2018-06
There is no responsibility for actuality. Pepperl+Fuchs GmbH reserves the right to
make changes to this document.
Prior to use, make sure that you have the latest version of the user manual. Check the
homepage www.pepperl-fuchs.com or contact your contact person at Pepperl+Fuchs
for clarication.
The gures in this manual are for illustration purposes only, and may dier from the
actual design in its appearance.
7
ImporTanT noTes abouT The InsTruCTIon manual
DANGER!
Do not make any changes to the device that are not intended or been approved by
Pepperl+Fuchs.
Improper handling of the handheld scanner can void the type approval to operate in
explosion-hazardous areas.
Non-compliance excludes warranty claims.
Note
Information regarding programming from the SICK AG manual (www.SICK.com) is
required for the full commissioning of the handheld scanner.
2018-06
8
ImporTanT noTes abouT The InsTruCTIon manual
1.3. General Warning Messages
WARNING!
Only operate the devices when assembled.
Do not clean the device in explosion-hazardous areas. Do not wipe it dry.
Switch o the device immediately if you believe that the device can no longer be
operated safely after damaging eects or abnormalities in general (ingress of
water, uids, exposure to temperatures outside the specied range etc.).
Note general statutory regulations or directives on occupational safety, accident
prevention regulations and environmental protection laws, e.g., Ordinance on
Industrial Safety and Health (BetrSichV).
Do not open the device.
You may not make any changes to the device. You may not exchange or replace
any components. Explosion protection is no longer guaranteed for non-speci-
ed components.
Ensure safe handling during use through adequate stability and freedom of
movement.
Immediately remove the device from the explosion-hazardous area in the event
of damage to the housing.
IEC 60079-19 and IEC 60079-17 stipulate that you as the operator of electrical
plants in explosion-hazardous areas are obligated to appoint an electrician to
check that these plants are in perfect condition.
Do not insert any objects into the housing or other openings of the handheld
scanner. Openings on the device must not be obstructed, blocked, or covered.
Dispose of the device and the associated components correctly, as required by
law, by an approved company.
2018-06
Note
Note the relevant deployment and operational regulations for electrical plants
(e.g., Directive 99/92/EC, Directive 2014/34/EU or the applicable national regulations, IEC 60 079-14, and the series DIN VDE 0100).
As the operator, perform maintenance and repair work for the device properly in
explosion-hazardous areas.
9
Loading...